| Age | Commit message (Collapse) | Author |
|---|
|
Needed for new Intel board file changes.
|
|
of_gpio.h is deprecated and subject to remove. The drivers in question
don't use it, simply remove the unused header.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Link: https://patch.msgid.link/20241031103302.2450830-1-andriy.shevchenko@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
On a system with wcd937x, rxmacro and Qualcomm audio DSP, which is pretty
common set of devices on Qualcomm platforms, and due to the order of how
DAPM widgets are powered on (they are sorted), there is a small time window
when wcd937x chip is online and expects the flow of incoming data but
rxmacro is not yet online. When wcd937x is programmed to receive data
via AUX port then its AUX PDM watchdog is enabled in
wcd937x_codec_enable_aux_pa(). If due to some reasons the rxmacro and
soundwire machinery are delayed to start streaming data, then there is
a chance for this AUX PDM watchdog to reset the wcd937x codec. Such event
is not logged as a message and only wcd937x IRQ counter is increased
however there could be a lot of other reasons for that IRQ.
There is a similar opportunity for such delay during DAPM widgets power
down sequence.
If wcd937x codec reset happens on the start of the playback, then there
will be no sound and if such reset happens at the end of a playback then
it may generate additional clicks and pops noises.
On qrb4210 RB2 board without any debugging bits the wcd937x resets are
sometimes observed at the end of a playback though not always.
With some debugging messages or with some tracing enabled the AUX PDM
watchdog resets the wcd937x codec at the start of a playback and there
is no sound output at all.
In this patch:
- TIMEOUT_SEL bit in PDM_WD_CTL2 register is set to increase the watchdog
reset delay to 100ms which eliminates the AUX PDM watchdog IRQs on
qrb4210 RB2 board completely and decreases the number of unwanted clicks
noises;
- HOLD_OFF bit postpones triggering such watchdog IRQ till wcd937x codec
reset which usually happens at the end of a playback. This allows to
actually output some sound in case of debugging.
Cc: Adam Skladowski <a39.skl@gmail.com>
Cc: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Cc: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Alexey Klimov <alexey.klimov@linaro.org>
Link: https://patch.msgid.link/20241022033132.787416-3-alexey.klimov@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The wcd937x supports also AUX input but the control that sets correct
soundwire port for this is missing. This control is required for audio
playback, for instance, on qrb4210 RB2 board as well as on other
SoCs.
Reported-by: Adam Skladowski <a39.skl@gmail.com>
Reported-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Suggested-by: Adam Skladowski <a39.skl@gmail.com>
Suggested-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Cc: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Alexey Klimov <alexey.klimov@linaro.org>
Link: https://patch.msgid.link/20241022033132.787416-2-alexey.klimov@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
After commit 0edb555a65d1 ("platform: Make platform_driver::remove()
return void") .remove() is (again) the right callback to implement for
platform drivers.
Convert all drivers below sound/soc to use .remove(), with the eventual
goal to drop struct platform_driver::remove_new(). As .remove() and
.remove_new() have the same prototypes, conversion is done by just
changing the structure member name in the driver initializer.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@baylibre.com>
Link: https://patch.msgid.link/20240909151230.909818-2-u.kleine-koenig@baylibre.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The device never comes online from a reset/shutdown state, because the
driver de-asserts reset GPIO when requesting it but then, at the end of
probe() through wcd937x_reset(), leaves it asserted.
Cc: stable@vger.kernel.org
Fixes: 9be3ec196da4 ("ASoC: codecs: wcd937x: add wcd937x codec driver")
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://patch.msgid.link/20240806114913.40022-1-krzysztof.kozlowski@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
Remove separate handling for vdd-buck regulator supply which is not
required. The vdd-buck regulator supply enabled using bulk enable.
Add the error handling in wcd937x_probe() and disable the regulators in
error case.
Reported-by: Christophe JAILLET <christophe.jaillet@wanadoo.fr>
Closes: https://lore.kernel.org/linux-sound/834d31cc-f4bc-4db7-a25b-f9869e550eb6@wanadoo.fr/
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://patch.msgid.link/20240704081723.3394153-4-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
Remove the string compare with widget name in MIC BIAS settings, instead
of string compare use the MIC BIAS id's.
Reported-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Closes: https://lore.kernel.org/linux-sound/ba911ebd-aef5-46af-ace1-84d13bee6876@linaro.org/
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://patch.msgid.link/20240704081723.3394153-3-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The driver stores the read chipid in 'struct wcd937x_priv' but never
needs it after.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://msgid.link/r/20240612-asoc-wcd9xxx-wide-cleanups-v1-15-0d15885b2a06@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The driver does not use few 'struct wcd937x_priv' and 'struct
wcd937x_sdw_priv' members, so just drop them for smaller code.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://msgid.link/r/20240612-asoc-wcd9xxx-wide-cleanups-v1-14-0d15885b2a06@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
Driver does not modify static wcd937x_sdw_ch_info array, so it can be
made const for code safety.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://msgid.link/r/20240612-asoc-wcd9xxx-wide-cleanups-v1-12-0d15885b2a06@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
Driver does not modify few static data (MBHC reg fields, IRQ chip), so
make them const for code safety.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://msgid.link/r/20240612-asoc-wcd9xxx-wide-cleanups-v1-11-0d15885b2a06@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
This patch adds audio routing for both playback and capture and
Makefile and Kconfigs changes for wcd937x.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-8-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
This patch adds required dapm widgets for capture path.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-7-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
This patch adds required dapm widgets for playback.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-6-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
This patch adds basic controls found in WCD9370/WCD9375 codec.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-5-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
This patch adds basic SoundWire codec driver to support for
WCD9370/WCD9375 TX and RX devices.
The WCD9370/WCD9375 has Multi Button Headset Control hardware to
support Headset insertion, type detection, 8 headset buttons detection,
Over Current detection and Impedence measurements.
This patch adds support for this using wcd-mbhc apis.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-4-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
