# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
%YAML 1.2
---
$id: http://devicetree.org/schemas/usb/genesys,gl850g.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: Genesys Logic USB hub controller

maintainers:
  - Icenowy Zheng <uwu@icenowy.me>

properties:
  compatible:
    enum:
      - usb5e3,608
      - usb5e3,610
      - usb5e3,620
      - usb5e3,626

  reg: true

  reset-gpios:
    description: GPIO controlling the RESET# pin.

  vdd-supply:
    description:
      The regulator that provides 3.3V or 5.0V core power to the hub.

  peer-hub: true

  ports:
    $ref: /schemas/graph.yaml#/properties/ports

    patternProperties:
      '^port@':
        $ref: /schemas/graph.yaml#/properties/port

        properties:
          reg:
            minimum: 1
            maximum: 4

required:
  - compatible
  - reg

allOf:
  - $ref: usb-hub.yaml#
  - if:
      properties:
        compatible:
          contains:
            enum:
              - usb5e3,608
    then:
      properties:
        peer-hub: false
        vdd-supply: false

  - if:
      properties:
        compatible:
          contains:
            enum:
              - usb5e3,610
              - usb5e3,620
    then:
      properties:
        peer-hub: true
        vdd-supply: true

unevaluatedProperties: false

examples:
  - |
    #include <dt-bindings/gpio/gpio.h>
    usb {
        dr_mode = "host";
        #address-cells = <1>;
        #size-cells = <0>;

        hub: hub@1 {
            compatible = "usb5e3,608";
            reg = <1>;
            reset-gpios = <&pio 7 2 GPIO_ACTIVE_LOW>;
        };
    };

  - |
    #include <dt-bindings/gpio/gpio.h>
    usb {
        dr_mode = "host";
        #address-cells = <1>;
        #size-cells = <0>;

        /* 2.0 hub on port 1 */
        hub_2_0: hub@1 {
            compatible = "usb5e3,610";
            reg = <1>;
            peer-hub = <&hub_3_0>;
            reset-gpios = <&gpio 20 GPIO_ACTIVE_LOW>;
            vdd-supply = <&vcc_5v>;
        };

        /* 3.1 hub on port 4 */
        hub_3_0: hub@2 {
            compatible = "usb5e3,620";
            reg = <2>;
            peer-hub = <&hub_2_0>;
            reset-gpios = <&gpio 20 GPIO_ACTIVE_LOW>;
            vdd-supply = <&vcc_5v>;
        };
    };