gpiolib: provide provision to register pin ranges

pinctrl subsystem needs gpio chip base to prepare set of gpio
pin ranges, which a given pinctrl driver can handle. This is
important to handle pinctrl gpio request calls in order to
program a given pin properly for gpio operation.

As gpio base is allocated dynamically during gpiochip
registration, presently there exists no clean way to pass this
information to the pinctrl subsystem.

After few discussions from [1], it was concluded that may be
gpio controller reporting the pin range it supports, is a
better way than pinctrl subsystem directly registering it.

[1] http://comments.gmane.org/gmane.linux.ports.arm.kernel/184816

Cc: Grant Likely <grant.likely@secretlab.ca>
Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
Signed-off-by: Shiraz Hashim <shiraz.hashim@st.com>
[Edited documentation a bit]
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

1 files changed, 36 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/gpio/gpio.txt b/Documentation/devicetree/bindings/gpio/gpio.txt
index 4e16ba4feab0..a33628759d36 100644
--- a/Documentation/devicetree/bindings/gpio/gpio.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio.txt
@@ -75,4 +75,40 @@ Example of two SOC GPIO banks defined as gpio-controller nodes:
 		gpio-controller;
 	};
 
+2.1) gpio-controller and pinctrl subsystem
+------------------------------------------
 
+gpio-controller on a SOC might be tightly coupled with the pinctrl
+subsystem, in the sense that the pins can be used by other functions
+together with optional gpio feature.
+
+While the pin allocation is totally managed by the pin ctrl subsystem,
+gpio (under gpiolib) is still maintained by gpio drivers. It may happen
+that different pin ranges in a SoC is managed by different gpio drivers.
+
+This makes it logical to let gpio drivers announce their pin ranges to
+the pin ctrl subsystem and call 'pinctrl_request_gpio' in order to
+request the corresponding pin before any gpio usage.
+
+For this, the gpio controller can use a pinctrl phandle and pins to
+announce the pinrange to the pin ctrl subsystem. For example,
+
+	qe_pio_e: gpio-controller@1460 {
+		#gpio-cells = <2>;
+		compatible = "fsl,qe-pario-bank-e", "fsl,qe-pario-bank";
+		reg = <0x1460 0x18>;
+		gpio-controller;
+		gpio-ranges = <&pinctrl1 20 10>, <&pinctrl2 50 20>;
+
+    }
+
+where,
+   &pinctrl1 and &pinctrl2 is the phandle to the pinctrl DT node.
+
+   Next values specify the base pin and number of pins for the range
+   handled by 'qe_pio_e' gpio. In the given example from base pin 20 to
+   pin 29 under pinctrl1 and pin 50 to pin 69 under pinctrl2 is handled
+   by this gpio controller.
+
+The pinctrl node must have "#gpio-range-cells" property to show number of
+arguments to pass with phandle from gpio controllers node.