KVM: VMX: enable IPI virtualization

With IPI virtualization enabled, the processor emulates writes to
APIC registers that would send IPIs. The processor sets the bit
corresponding to the vector in target vCPU's PIR and may send a
notification (IPI) specified by NDST and NV fields in target vCPU's
Posted-Interrupt Descriptor (PID). It is similar to what IOMMU
engine does when dealing with posted interrupt from devices.

A PID-pointer table is used by the processor to locate the PID of a
vCPU with the vCPU's APIC ID. The table size depends on maximum APIC
ID assigned for current VM session from userspace. Allocating memory
for PID-pointer table is deferred to vCPU creation, because irqchip
mode and VM-scope maximum APIC ID is settled at that point. KVM can
skip PID-pointer table allocation if !irqchip_in_kernel().

Like VT-d PI, if a vCPU goes to blocked state, VMM needs to switch its
notification vector to wakeup vector. This can ensure that when an IPI
for blocked vCPUs arrives, VMM can get control and wake up blocked
vCPUs. And if a VCPU is preempted, its posted interrupt notification
is suppressed.

Note that IPI virtualization can only virualize physical-addressing,
flat mode, unicast IPIs. Sending other IPIs would still cause a
trap-like APIC-write VM-exit and need to be handled by VMM.

Signed-off-by: Chao Gao <chao.gao@intel.com>
Signed-off-by: Zeng Guang <guang.zeng@intel.com>
Message-Id: <20220419154510.11938-1-guang.zeng@intel.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

1 files changed, 1 insertions, 0 deletions

diff --git a/arch/x86/include/asm/kvm-x86-ops.h b/arch/x86/include/asm/kvm-x86-ops.h
index da47f60a4650..6f2f1affbb78 100644
--- a/arch/x86/include/asm/kvm-x86-ops.h
+++ b/arch/x86/include/asm/kvm-x86-ops.h
@@ -21,6 +21,7 @@ KVM_X86_OP(has_emulated_msr)
 KVM_X86_OP(vcpu_after_set_cpuid)
 KVM_X86_OP(vm_init)
 KVM_X86_OP_OPTIONAL(vm_destroy)
+KVM_X86_OP_OPTIONAL_RET0(vcpu_precreate)
 KVM_X86_OP(vcpu_create)
 KVM_X86_OP(vcpu_free)
 KVM_X86_OP(vcpu_reset)