dma-mapping: treat dev->bus_dma_mask as a DMA limit

Using a mask to represent bus DMA constraints has a set of limitations.
The biggest one being it can only hold a power of two (minus one). The
DMA mapping code is already aware of this and treats dev->bus_dma_mask
as a limit. This quirk is already used by some architectures although
still rare.

With the introduction of the Raspberry Pi 4 we've found a new contender
for the use of bus DMA limits, as its PCIe bus can only address the
lower 3GB of memory (of a total of 4GB). This is impossible to represent
with a mask. To make things worse the device-tree code rounds non power
of two bus DMA limits to the next power of two, which is unacceptable in
this case.

In the light of this, rename dev->bus_dma_mask to dev->bus_dma_limit all
over the tree and treat it as such. Note that dev->bus_dma_limit should
contain the higher accessible DMA address.

Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de>
Reviewed-by: Robin Murphy <robin.murphy@arm.com>
Signed-off-by: Christoph Hellwig <hch@lst.de>

1 files changed, 1 insertions, 1 deletions

diff --git a/arch/x86/pci/sta2x11-fixup.c b/arch/x86/pci/sta2x11-fixup.c
index 4a631264b809..c313d784efab 100644
--- a/arch/x86/pci/sta2x11-fixup.c
+++ b/arch/x86/pci/sta2x11-fixup.c
@@ -143,7 +143,7 @@ static void sta2x11_map_ep(struct pci_dev *pdev)
 
 	dev->dma_pfn_offset = PFN_DOWN(-amba_base);
 
-	dev->bus_dma_mask = max_amba_addr;
+	dev->bus_dma_limit = max_amba_addr;
 	pci_set_consistent_dma_mask(pdev, max_amba_addr);
 	pci_set_dma_mask(pdev, max_amba_addr);