EDAC/i10nm: Retrieve and print retry_rd_err_log registers

Retrieve and print retry_rd_err_log registers like the earlier change:
commit e80634a75aba ("EDAC, skx: Retrieve and print retry_rd_err_log registers")

This is a little trickier than on Skylake because of potential
interference with BIOS use of the same registers. The default
behavior is to ignore these registers.

A module parameter retry_rd_err_log(default=0) controls the mode of operation:
- 0=off  : Default.
- 1=bios : Linux doesn't reset any control bits, but just reports values.
           This is "no harm" mode, but it may miss reporting some data.
- 2=linux: Linux tries to take control and resets mode bits,
           clears valid/UC bits after reading. This should be
           more reliable (especially if BIOS interference is reduced
           by disabling eMCA reporting mode in BIOS setup).

Co-developed-by: Qiuxu Zhuo <qiuxu.zhuo@intel.com>
Signed-off-by: Qiuxu Zhuo <qiuxu.zhuo@intel.com>
Signed-off-by: Youquan Song <youquan.song@intel.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Link: https://lore.kernel.org/r/20210818175701.1611513-3-tony.luck@intel.com

1 files changed, 2 insertions, 1 deletions

diff --git a/drivers/edac/skx_base.c b/drivers/edac/skx_base.c
index 4dbd46575bfb..1abc020d49ab 100644
--- a/drivers/edac/skx_base.c
+++ b/drivers/edac/skx_base.c
@@ -230,7 +230,8 @@ static int skx_get_dimm_config(struct mem_ctl_info *mci, struct res_config *cfg)
 #define SKX_ILV_TARGET(tgt)	((tgt) & 7)
 
 static void skx_show_retry_rd_err_log(struct decoded_addr *res,
-				      char *msg, int len)
+				      char *msg, int len,
+				      bool scrub_err)
 {
 	u32 log0, log1, log2, log3, log4;
 	u32 corr0, corr1, corr2, corr3;