EDAC/i10nm: Retrieve and print retry_rd_err_log registers

Retrieve and print retry_rd_err_log registers like the earlier change:
commit e80634a75aba ("EDAC, skx: Retrieve and print retry_rd_err_log registers")

This is a little trickier than on Skylake because of potential
interference with BIOS use of the same registers. The default
behavior is to ignore these registers.

A module parameter retry_rd_err_log(default=0) controls the mode of operation:
- 0=off  : Default.
- 1=bios : Linux doesn't reset any control bits, but just reports values.
           This is "no harm" mode, but it may miss reporting some data.
- 2=linux: Linux tries to take control and resets mode bits,
           clears valid/UC bits after reading. This should be
           more reliable (especially if BIOS interference is reduced
           by disabling eMCA reporting mode in BIOS setup).

Co-developed-by: Qiuxu Zhuo <qiuxu.zhuo@intel.com>
Signed-off-by: Qiuxu Zhuo <qiuxu.zhuo@intel.com>
Signed-off-by: Youquan Song <youquan.song@intel.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Link: https://lore.kernel.org/r/20210818175701.1611513-3-tony.luck@intel.com

1 files changed, 6 insertions, 1 deletions

diff --git a/drivers/edac/skx_common.h b/drivers/edac/skx_common.h
index 01f67e731766..03ac067a80b9 100644
--- a/drivers/edac/skx_common.h
+++ b/drivers/edac/skx_common.h
@@ -80,6 +80,8 @@ struct skx_dev {
 		struct skx_channel {
 			struct pci_dev	*cdev;
 			struct pci_dev	*edev;
+			u32 retry_rd_err_log_s;
+			u32 retry_rd_err_log_d;
 			struct skx_dimm {
 				u8 close_pg;
 				u8 bank_xor_enable;
@@ -150,12 +152,15 @@ struct res_config {
 	/* SAD device number and function number */
 	unsigned int sad_all_devfn;
 	int sad_all_offset;
+	/* Offsets of retry_rd_err_log registers */
+	u32 *offsets_scrub;
+	u32 *offsets_demand;
 };
 
 typedef int (*get_dimm_config_f)(struct mem_ctl_info *mci,
 				 struct res_config *cfg);
 typedef bool (*skx_decode_f)(struct decoded_addr *res);
-typedef void (*skx_show_retry_log_f)(struct decoded_addr *res, char *msg, int len);
+typedef void (*skx_show_retry_log_f)(struct decoded_addr *res, char *msg, int len, bool scrub_err);
 
 int __init skx_adxl_get(void);
 void __exit skx_adxl_put(void);