Merge tag 'mtd/for-4.18' of git://git.infradead.org/linux-mtd

Pull MTD updates from Boris Brezillon:
 "Core changes:
   - Add a sysfs attribute to expose available OOB size

  Driver changes:
   - Remove HAS_DMA dependency on various drivers
   - Use dev_get_drvdata() instead of platform_get_drvdata() in docg3
   - Replace msleep by usleep_range() in the dataflash driver
   - Avoid VLA usage in nftl layers
   - Remove useless .owner assignment in pismo
   - Fix various issues in the CFI driver
   - Improve TRX partition handling expose a DT compat for this part
     parser
   - Clarify OFFSET_CONTINUOUS meaning

  NAND core changes:
   - Add Miquel as a NAND maintainer
   - Add access mode to the nand_page_io_req struct
   - Fix kernel-doc in rawnand.h
   - Support bit-wise majority to recover from corrupted ONFI parameter
     pages
   - Stop checking FAIL bit after a SET_FEATURES, as documented in the
     ONFI spec

  Raw NAND Driver changes:
   - Fix and cleanup the error path of many NAND controller drivers
   - GPMI:
      + Cleanup/simplification of a few aspects in the driver
      + Take ECC setup specified in the DT into account
   - sunxi: remove support for GPIO-based R/B polling
   - MTK:
      + Use of_device_get_match_data() instead of of_match_device()
      + Add an entry in MAINTAINERS for this driver
      + Fix nand-ecc-step-size and nand-ecc-strength description in the
        DT bindings doc
   - fsl_ifc: fix ->cmdfunc() to read more than one ONFI parameter page

  OneNAND driver changes:
   - samsung: use dev_get_drvdata() instead of platform_get_drvdata()

  SPI NOR core changes:
   - Add support for a bunch of SPI NOR chips
   - Clear EAR reg when switching to 3-byte addressing mode on Winbond
     chips

  SPI NOR controller driver changes:
   - cadence: Add DMA support for direct mode reads
   - hisi: Prefix a few functions with hisi_
   - intel:
      + Mark the driver as "dangerous" in Kconfig
      + Fix atomic sequence handling
      + Pass a 40us delay (instead of 0us) to readl_poll_timeout()
   - fsl:
      + fix a typo in a function name
      + add support for IP variants embedded in the ls2080a and ls1080a
        SoCs
   - stm32: request exclusive control of the reset line"

* tag 'mtd/for-4.18' of git://git.infradead.org/linux-mtd: (66 commits)
  mtd: nand: Pass mode information to nand_page_io_req
  mtd: cfi_cmdset_0002: Change erase one block to enable XIP once
  mtd: cfi_cmdset_0002: Change erase functions to check chip good only
  mtd: cfi_cmdset_0002: Change erase functions to retry for error
  mtd: cfi_cmdset_0002: Change definition naming to retry write operation
  mtd: cfi_cmdset_0002: Change write buffer to check correct value
  mtd: cmdlinepart: Update comment for introduction of OFFSET_CONTINUOUS
  mtd: bcm47xxpart: add of_match_table with a new DT binding
  dt-bindings: mtd: document Broadcom's BCM47xx partitions
  mtd: spi-nor: Add support for EN25QH32
  mtd: spi-nor: Add support for is25wp series chips
  mtd: spi-nor: Add Winbond w25q32jv support
  mtd: spi-nor: fsl-quadspi: add support for ls2080a/ls1080a
  mtd: spi-nor: stm32-quadspi: explicitly request exclusive reset control
  mtd: spi-nor: intel: provide a range for poll_timout
  mtd: spi-nor: fsl-quadspi: fix api naming typo _init_ahb_read
  mtd: spi-nor: intel-spi: Explicitly mark the driver as dangerous in Kconfig
  mtd: spi-nor: intel-spi: Fix atomic sequence handling
  mtd: rawnand: Do not check FAIL bit when executing a SET_FEATURES op
  mtd: rawnand: use bit-wise majority to recover the ONFI param page
  ...

1 files changed, 1 insertions, 24 deletions

diff --git a/drivers/mtd/nand/raw/davinci_nand.c b/drivers/mtd/nand/raw/davinci_nand.c
index 0f09518d980f..7255a0d94374 100644
--- a/drivers/mtd/nand/raw/davinci_nand.c
+++ b/drivers/mtd/nand/raw/davinci_nand.c
@@ -27,7 +27,6 @@
 #include <linux/module.h>
 #include <linux/platform_device.h>
 #include <linux/err.h>
-#include <linux/clk.h>
 #include <linux/io.h>
 #include <linux/mtd/rawnand.h>
 #include <linux/mtd/partitions.h>
@@ -55,7 +54,6 @@ struct davinci_nand_info {
 	struct nand_chip	chip;
 
 	struct device		*dev;
-	struct clk		*clk;
 
 	bool			is_readmode;
 
@@ -703,22 +701,6 @@ static int nand_davinci_probe(struct platform_device *pdev)
 	/* Use board-specific ECC config */
 	info->chip.ecc.mode	= pdata->ecc_mode;
 
-	ret = -EINVAL;
-
-	info->clk = devm_clk_get(&pdev->dev, "aemif");
-	if (IS_ERR(info->clk)) {
-		ret = PTR_ERR(info->clk);
-		dev_dbg(&pdev->dev, "unable to get AEMIF clock, err %d\n", ret);
-		return ret;
-	}
-
-	ret = clk_prepare_enable(info->clk);
-	if (ret < 0) {
-		dev_dbg(&pdev->dev, "unable to enable AEMIF clock, err %d\n",
-			ret);
-		goto err_clk_enable;
-	}
-
 	spin_lock_irq(&davinci_nand_lock);
 
 	/* put CSxNAND into NAND mode */
@@ -732,7 +714,7 @@ static int nand_davinci_probe(struct platform_device *pdev)
 	ret = nand_scan_ident(mtd, pdata->mask_chipsel ? 2 : 1, NULL);
 	if (ret < 0) {
 		dev_dbg(&pdev->dev, "no NAND chip(s) found\n");
-		goto err;
+		return ret;
 	}
 
 	switch (info->chip.ecc.mode) {
@@ -838,9 +820,6 @@ err_cleanup_nand:
 	nand_cleanup(&info->chip);
 
 err:
-	clk_disable_unprepare(info->clk);
-
-err_clk_enable:
 	spin_lock_irq(&davinci_nand_lock);
 	if (info->chip.ecc.mode == NAND_ECC_HW_SYNDROME)
 		ecc4_busy = false;
@@ -859,8 +838,6 @@ static int nand_davinci_remove(struct platform_device *pdev)
 
 	nand_release(nand_to_mtd(&info->chip));
 
-	clk_disable_unprepare(info->clk);
-
 	return 0;
 }