summaryrefslogtreecommitdiff
path: root/drivers/net
diff options
context:
space:
mode:
authorVladimir Oltean <vladimir.oltean@nxp.com>2021-02-08 19:36:27 +0200
committerDavid S. Miller <davem@davemloft.net>2021-02-09 11:41:11 -0800
commiteb4733d7cffc547e08fe5a216e4f03663bb71108 (patch)
tree38bb8742810e1f9e6fb9da320e559a8b393a6e45 /drivers/net
parent6bbc088d6ebfd5a4284641dbe8413ebab0dfeb8c (diff)
net: dsa: felix: implement port flushing on .phylink_mac_link_down
There are several issues which may be seen when the link goes down while forwarding traffic, all of which can be attributed to the fact that the port flushing procedure from the reference manual was not closely followed. With flow control enabled on both the ingress port and the egress port, it may happen when a link goes down that Ethernet packets are in flight. In flow control mode, frames are held back and not dropped. When there is enough traffic in flight (example: iperf3 TCP), then the ingress port might enter congestion and never exit that state. This is a problem, because it is the egress port's link that went down, and that has caused the inability of the ingress port to send packets to any other port. This is solved by flushing the egress port's queues when it goes down. There is also a problem when performing stream splitting for IEEE 802.1CB traffic (not yet upstream, but a sort of multicast, basically). There, if one port from the destination ports mask goes down, splitting the stream towards the other destinations will no longer be performed. This can be traced down to this line: ocelot_port_writel(ocelot_port, 0, DEV_MAC_ENA_CFG); which should have been instead, as per the reference manual: ocelot_port_rmwl(ocelot_port, 0, DEV_MAC_ENA_CFG_RX_ENA, DEV_MAC_ENA_CFG); Basically only DEV_MAC_ENA_CFG_RX_ENA should be disabled, but not DEV_MAC_ENA_CFG_TX_ENA - I don't have further insight into why that is the case, but apparently multicasting to several ports will cause issues if at least one of them doesn't have DEV_MAC_ENA_CFG_TX_ENA set. I am not sure what the state of the Ocelot VSC7514 driver is, but probably not as bad as Felix/Seville, since VSC7514 uses phylib and has the following in ocelot_adjust_link: if (!phydev->link) return; therefore the port is not really put down when the link is lost, unlike the DSA drivers which use .phylink_mac_link_down for that. Nonetheless, I put ocelot_port_flush() in the common ocelot.c because it needs to access some registers from drivers/net/ethernet/mscc/ocelot_rew.h which are not exported in include/soc/mscc/ and a bugfix patch should probably not move headers around. Fixes: bdeced75b13f ("net: dsa: felix: Add PCS operations for PHYLINK") Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com> Signed-off-by: David S. Miller <davem@davemloft.net>
Diffstat (limited to 'drivers/net')
-rw-r--r--drivers/net/dsa/ocelot/felix.c17
-rw-r--r--drivers/net/ethernet/mscc/ocelot.c54
-rw-r--r--drivers/net/ethernet/mscc/ocelot_io.c8
3 files changed, 78 insertions, 1 deletions
diff --git a/drivers/net/dsa/ocelot/felix.c b/drivers/net/dsa/ocelot/felix.c
index 7dc230677b78..45fdb1256dbf 100644
--- a/drivers/net/dsa/ocelot/felix.c
+++ b/drivers/net/dsa/ocelot/felix.c
@@ -233,9 +233,24 @@ static void felix_phylink_mac_link_down(struct dsa_switch *ds, int port,
{
struct ocelot *ocelot = ds->priv;
struct ocelot_port *ocelot_port = ocelot->ports[port];
+ int err;
+
+ ocelot_port_rmwl(ocelot_port, 0, DEV_MAC_ENA_CFG_RX_ENA,
+ DEV_MAC_ENA_CFG);
- ocelot_port_writel(ocelot_port, 0, DEV_MAC_ENA_CFG);
ocelot_fields_write(ocelot, port, QSYS_SWITCH_PORT_MODE_PORT_ENA, 0);
+
+ err = ocelot_port_flush(ocelot, port);
+ if (err)
+ dev_err(ocelot->dev, "failed to flush port %d: %d\n",
+ port, err);
+
+ /* Put the port in reset. */
+ ocelot_port_writel(ocelot_port,
+ DEV_CLOCK_CFG_MAC_TX_RST |
+ DEV_CLOCK_CFG_MAC_RX_RST |
+ DEV_CLOCK_CFG_LINK_SPEED(OCELOT_SPEED_1000),
+ DEV_CLOCK_CFG);
}
static void felix_phylink_mac_link_up(struct dsa_switch *ds, int port,
diff --git a/drivers/net/ethernet/mscc/ocelot.c b/drivers/net/ethernet/mscc/ocelot.c
index ff87a0bc089c..c072eb5c0764 100644
--- a/drivers/net/ethernet/mscc/ocelot.c
+++ b/drivers/net/ethernet/mscc/ocelot.c
@@ -375,6 +375,60 @@ static void ocelot_vlan_init(struct ocelot *ocelot)
}
}
+static u32 ocelot_read_eq_avail(struct ocelot *ocelot, int port)
+{
+ return ocelot_read_rix(ocelot, QSYS_SW_STATUS, port);
+}
+
+int ocelot_port_flush(struct ocelot *ocelot, int port)
+{
+ int err, val;
+
+ /* Disable dequeuing from the egress queues */
+ ocelot_rmw_rix(ocelot, QSYS_PORT_MODE_DEQUEUE_DIS,
+ QSYS_PORT_MODE_DEQUEUE_DIS,
+ QSYS_PORT_MODE, port);
+
+ /* Disable flow control */
+ ocelot_fields_write(ocelot, port, SYS_PAUSE_CFG_PAUSE_ENA, 0);
+
+ /* Disable priority flow control */
+ ocelot_fields_write(ocelot, port,
+ QSYS_SWITCH_PORT_MODE_TX_PFC_ENA, 0);
+
+ /* Wait at least the time it takes to receive a frame of maximum length
+ * at the port.
+ * Worst-case delays for 10 kilobyte jumbo frames are:
+ * 8 ms on a 10M port
+ * 800 μs on a 100M port
+ * 80 μs on a 1G port
+ * 32 μs on a 2.5G port
+ */
+ usleep_range(8000, 10000);
+
+ /* Disable half duplex backpressure. */
+ ocelot_rmw_rix(ocelot, 0, SYS_FRONT_PORT_MODE_HDX_MODE,
+ SYS_FRONT_PORT_MODE, port);
+
+ /* Flush the queues associated with the port. */
+ ocelot_rmw_gix(ocelot, REW_PORT_CFG_FLUSH_ENA, REW_PORT_CFG_FLUSH_ENA,
+ REW_PORT_CFG, port);
+
+ /* Enable dequeuing from the egress queues. */
+ ocelot_rmw_rix(ocelot, 0, QSYS_PORT_MODE_DEQUEUE_DIS, QSYS_PORT_MODE,
+ port);
+
+ /* Wait until flushing is complete. */
+ err = read_poll_timeout(ocelot_read_eq_avail, val, !val,
+ 100, 2000000, false, ocelot, port);
+
+ /* Clear flushing again. */
+ ocelot_rmw_gix(ocelot, 0, REW_PORT_CFG_FLUSH_ENA, REW_PORT_CFG, port);
+
+ return err;
+}
+EXPORT_SYMBOL(ocelot_port_flush);
+
void ocelot_adjust_link(struct ocelot *ocelot, int port,
struct phy_device *phydev)
{
diff --git a/drivers/net/ethernet/mscc/ocelot_io.c b/drivers/net/ethernet/mscc/ocelot_io.c
index 0acb45948418..ea4e83410fe4 100644
--- a/drivers/net/ethernet/mscc/ocelot_io.c
+++ b/drivers/net/ethernet/mscc/ocelot_io.c
@@ -71,6 +71,14 @@ void ocelot_port_writel(struct ocelot_port *port, u32 val, u32 reg)
}
EXPORT_SYMBOL(ocelot_port_writel);
+void ocelot_port_rmwl(struct ocelot_port *port, u32 val, u32 mask, u32 reg)
+{
+ u32 cur = ocelot_port_readl(port, reg);
+
+ ocelot_port_writel(port, (cur & (~mask)) | val, reg);
+}
+EXPORT_SYMBOL(ocelot_port_rmwl);
+
u32 __ocelot_target_read_ix(struct ocelot *ocelot, enum ocelot_target target,
u32 reg, u32 offset)
{