1 files changed, 0 insertions, 38 deletions
diff --git a/Documentation/devicetree/bindings/gpio/ni,169445-nand-gpio.txt b/Documentation/devicetree/bindings/gpio/ni,169445-nand-gpio.txt
deleted file mode 100644
index ca2f8c745a27..000000000000
--- a/Documentation/devicetree/bindings/gpio/ni,169445-nand-gpio.txt
+++ /dev/null
@@ -1,38 +0,0 @@
-Bindings for the National Instruments 169445 GPIO NAND controller
-
-The 169445 GPIO NAND controller has two memory mapped GPIO registers, one
-for input (the ready signal) and one for output (control signals).  It is
-intended to be used with the GPIO NAND driver.
-
-Required properties:
-	- compatible: should be "ni,169445-nand-gpio"
-	- reg-names: must contain
-		"dat" - data register
-	- reg: address + size pairs describing the GPIO register sets;
-		order must correspond with the order of entries in reg-names
-	- #gpio-cells: must be set to 2. The first cell is the pin number and
-			the second cell is used to specify the gpio polarity:
-			0 = active high
-			1 = active low
-	- gpio-controller: Marks the device node as a gpio controller.
-
-Optional properties:
-	- no-output: disables driving output on the pins
-
-Examples:
-	gpio1: nand-gpio-out@1f300010 {
-		compatible = "ni,169445-nand-gpio";
-		reg = <0x1f300010 0x4>;
-		reg-names = "dat";
-		gpio-controller;
-		#gpio-cells = <2>;
-	};
-
-	gpio2: nand-gpio-in@1f300014 {
-		compatible = "ni,169445-nand-gpio";
-		reg = <0x1f300014 0x4>;
-		reg-names = "dat";
-		gpio-controller;
-		#gpio-cells = <2>;
-		no-output;
-	};