diff options
Diffstat (limited to 'Documentation/devicetree/bindings/iio/imu')
3 files changed, 6 insertions, 2 deletions
diff --git a/Documentation/devicetree/bindings/iio/imu/bmi160.txt b/Documentation/devicetree/bindings/iio/imu/bmi160.txt index 0c1c105fb503..900c169de00f 100644 --- a/Documentation/devicetree/bindings/iio/imu/bmi160.txt +++ b/Documentation/devicetree/bindings/iio/imu/bmi160.txt @@ -9,9 +9,11 @@ Required properties: - spi-max-frequency : set maximum clock frequency (only for SPI) Optional properties: - - interrupts : interrupt mapping for IRQ, must be IRQ_TYPE_LEVEL_LOW + - interrupts : interrupt mapping for IRQ - interrupt-names : set to "INT1" if INT1 pin should be used as interrupt input, set to "INT2" if INT2 pin should be used instead + - drive-open-drain : set if the specified interrupt pin should be configured as + open drain. If not set, defaults to push-pull. Examples: @@ -20,7 +22,7 @@ bmi160@68 { reg = <0x68>; interrupt-parent = <&gpio4>; - interrupts = <12 IRQ_TYPE_LEVEL_LOW>; + interrupts = <12 IRQ_TYPE_EDGE_RISING>; interrupt-names = "INT1"; }; diff --git a/Documentation/devicetree/bindings/iio/imu/inv_mpu6050.txt b/Documentation/devicetree/bindings/iio/imu/inv_mpu6050.txt index 6ab9a9d196b0..268bf7568e19 100644 --- a/Documentation/devicetree/bindings/iio/imu/inv_mpu6050.txt +++ b/Documentation/devicetree/bindings/iio/imu/inv_mpu6050.txt @@ -11,6 +11,7 @@ Required properties: "invensense,mpu9250" "invensense,mpu9255" "invensense,icm20608" + "invensense,icm20602" - reg : the I2C address of the sensor - interrupts: interrupt mapping for IRQ. It should be configured with flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or diff --git a/Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt b/Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt index 879322ad50fd..69d53d98d0f0 100644 --- a/Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt +++ b/Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt @@ -13,6 +13,7 @@ Required properties: Optional properties: - st,drdy-int-pin: the pin on the package that will be used to signal "data ready" (valid values: 1 or 2). +- st,pullups : enable/disable internal i2c controller pullup resistors. - drive-open-drain: the interrupt/data ready line will be configured as open drain, which is useful if several sensors share the same interrupt line. This is a boolean property. |