1 files changed, 0 insertions, 48 deletions
diff --git a/Documentation/devicetree/bindings/net/can/tcan4x5x.txt b/Documentation/devicetree/bindings/net/can/tcan4x5x.txt
deleted file mode 100644
index 20c0572c9853..000000000000
--- a/Documentation/devicetree/bindings/net/can/tcan4x5x.txt
+++ /dev/null
@@ -1,48 +0,0 @@
-Texas Instruments TCAN4x5x CAN Controller
-================================================
-
-This file provides device node information for the TCAN4x5x interface contains.
-
-Required properties:
-	- compatible:
-		"ti,tcan4552", "ti,tcan4x5x"
-		"ti,tcan4553", "ti,tcan4x5x" or
-		"ti,tcan4x5x"
-	- reg: 0
-	- #address-cells: 1
-	- #size-cells: 0
-	- spi-max-frequency: Maximum frequency of the SPI bus the chip can
-			     operate at should be less than or equal to 18 MHz.
-	- interrupt-parent: the phandle to the interrupt controller which provides
-                    the interrupt.
-	- interrupts: interrupt specification for data-ready.
-
-See Documentation/devicetree/bindings/net/can/bosch,m_can.yaml for additional
-required property details.
-
-Optional properties:
-	- reset-gpios: Hardwired output GPIO. If not defined then software
-		       reset.
-	- device-state-gpios: Input GPIO that indicates if the device is in
-			      a sleep state or if the device is active. Not
-			      available with tcan4552/4553.
-	- device-wake-gpios: Wake up GPIO to wake up the TCAN device. Not
-			     available with tcan4552/4553.
-	- wakeup-source: Leave the chip running when suspended, and configure
-			 the RX interrupt to wake up the device.
-
-Example:
-tcan4x5x: tcan4x5x@0 {
-		compatible = "ti,tcan4x5x";
-		reg = <0>;
-		#address-cells = <1>;
-		#size-cells = <1>;
-		spi-max-frequency = <10000000>;
-		bosch,mram-cfg = <0x0 0 0 16 0 0 1 1>;
-		interrupt-parent = <&gpio1>;
-		interrupts = <14 IRQ_TYPE_LEVEL_LOW>;
-		device-state-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
-		device-wake-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>;
-		reset-gpios = <&gpio1 27 GPIO_ACTIVE_HIGH>;
-		wakeup-source;
-};