diff options
Diffstat (limited to 'Documentation/devicetree/bindings/watchdog/atmel-wdt.txt')
-rw-r--r-- | Documentation/devicetree/bindings/watchdog/atmel-wdt.txt | 51 |
1 files changed, 0 insertions, 51 deletions
diff --git a/Documentation/devicetree/bindings/watchdog/atmel-wdt.txt b/Documentation/devicetree/bindings/watchdog/atmel-wdt.txt deleted file mode 100644 index 711a880b3d3b..000000000000 --- a/Documentation/devicetree/bindings/watchdog/atmel-wdt.txt +++ /dev/null @@ -1,51 +0,0 @@ -* Atmel Watchdog Timers - -** at91sam9-wdt - -Required properties: -- compatible: must be "atmel,at91sam9260-wdt". -- reg: physical base address of the controller and length of memory mapped - region. -- clocks: phandle to input clock. - -Optional properties: -- timeout-sec: contains the watchdog timeout in seconds. -- interrupts : Should contain WDT interrupt. -- atmel,max-heartbeat-sec : Should contain the maximum heartbeat value in - seconds. This value should be less or equal to 16. It is used to - compute the WDV field. -- atmel,min-heartbeat-sec : Should contain the minimum heartbeat value in - seconds. This value must be smaller than the max-heartbeat-sec value. - It is used to compute the WDD field. -- atmel,watchdog-type : Should be "hardware" or "software". Hardware watchdog - use the at91 watchdog reset. Software watchdog use the watchdog - interrupt to trigger a software reset. -- atmel,reset-type : Should be "proc" or "all". - "all" : assert peripherals and processor reset signals - "proc" : assert the processor reset signal - This is valid only when using "hardware" watchdog. -- atmel,disable : Should be present if you want to disable the watchdog. -- atmel,idle-halt : Should be present if you want to stop the watchdog when - entering idle state. - CAUTION: This property should be used with care, it actually makes the - watchdog not counting when the CPU is in idle state, therefore the - watchdog reset time depends on mean CPU usage and will not reset at all - if the CPU stop working while it is in idle state, which is probably - not what you want. -- atmel,dbg-halt : Should be present if you want to stop the watchdog when - entering debug state. - -Example: - watchdog@fffffd40 { - compatible = "atmel,at91sam9260-wdt"; - reg = <0xfffffd40 0x10>; - interrupts = <1 IRQ_TYPE_LEVEL_HIGH 7>; - clocks = <&clk32k>; - timeout-sec = <15>; - atmel,watchdog-type = "hardware"; - atmel,reset-type = "all"; - atmel,dbg-halt; - atmel,idle-halt; - atmel,max-heartbeat-sec = <16>; - atmel,min-heartbeat-sec = <0>; - }; |