diff options
Diffstat (limited to 'Documentation/hwmon')
-rw-r--r-- | Documentation/hwmon/sht3x.rst | 14 |
1 files changed, 6 insertions, 8 deletions
diff --git a/Documentation/hwmon/sht3x.rst b/Documentation/hwmon/sht3x.rst index 31fd36b144a6..be70e2543f17 100644 --- a/Documentation/hwmon/sht3x.rst +++ b/Documentation/hwmon/sht3x.rst @@ -28,16 +28,14 @@ The device communicates with the I2C protocol. Sensors can have the I2C addresses 0x44 or 0x45, depending on the wiring. See Documentation/i2c/instantiating-devices.rst for methods to instantiate the device. -There are two options configurable by means of sht3x_data: - -1. blocking (pull the I2C clock line down while performing the measurement) or - non-blocking mode. Blocking mode will guarantee the fastest result but - the I2C bus will be busy during that time. By default, non-blocking mode - is used. Make sure clock-stretching works properly on your device if you - want to use blocking mode. -2. high or low accuracy. High accuracy is used by default and using it is +There is only one option configurable by means of sht3x_data: + + high or low accuracy. High accuracy is used by default and using it is strongly recommended. +Even if sht3x sensor supports clock-strech(blocking mode) and non-strench +(non-blocking mode) in single-shot mode, this driver only supports the latter. + The sht3x sensor supports a single shot mode as well as 5 periodic measure modes, which can be controlled with the update_interval sysfs interface. The allowed update_interval in milliseconds are as follows: |