| Age | Commit message (Collapse) | Author |
|---|
|
On these boards, vdd_bat is 16bit, not 24bit. Reading them as 24bit
values yield garbage values because of the additional byte, which is a
configurable fan trippoint[1].
So set their mode to mode_voltage_16bit = 3 instead of
mode_voltage_24bit = 1.
[1]: http://trac.gateworks.com/wiki/gsc#SystemTemperatureandVoltageMonitor
Only tested on GW7100.
Signed-off-by: Nicolas Cavallari <nicolas.cavallari@green-communications.fr>
Acked-by: Tim Harvey <tharvey@gateworks.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
|
Remove the invalid #address-cells and #size-cells nodes from
the fan-controller.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
|
Fix the following dtbs_check warning on all of i.MX8M variants:
"
opp-table: Unevaluated properties are not allowed ('opp-25M', 'opp-100M', 'opp-750M' were unexpected)
"
Using the following command:
"
$ sed -i '/opp-[0-9]\+M/ s@M {@000000 {@' arch/arm64/boot/dts/freescale/imx8m*
"
The Documentation/devicetree/bindings/opp/opp-v2-base.yaml expects the OPP
subnode names to be full frequency listings in Hz without unit suffixes.
Only the i.MX8M DTs are affected per "git grep 'opp-[0-9]\+M'", so fix them.
Signed-off-by: Marek Vasut <marex@denx.de>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
|
Add I2C GPIO bus recovery support by adding scl-gpios and sda-gpios for the
various I2C busses on Gateworks Venice boards.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
|
The node names should be generic and DT schema expects certain pattern
(e.g. with key/button/switch).
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
|
Fix whitespace coding style: use single space instead of tabs or
multiple spaces around '=' sign in property assignment. No functional
changes (same DTB).
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
|
The GW700x PMIC does not have an interrupt. Remove the invalid pin
config.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
|
Fix various MP5416 PMIC configurations:
- Update regulator names per dt-bindings
- ensure values fit among valid register values
- add required regulator-max-microamp property
- add regulator-always-on prop
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
|
The Gateworks Venice GW71xx-0x/GW72xx-0x/GW73xx-0x are development
kits consisting of a GW700x SoM and a Baseboard. Future SoM's such
as the GW701x will create additional combinations.
The GW700x SoM contains:
- i.MX 8M Mini SoC
- LPDDR4 DRAM
- eMMC FLASH
- Gateworks System Controller (eeprom/pushbutton/reset/voltage-monitor)
- GbE PHY connected to the i.MX 8M Mini FEC
- Power Management IC
The GW71xx Baseboard contains:
- 1x MiniPCIe Socket with USB2.0, PCIe, and SIM
- 1x RJ45 GbE (i.MX 8M Mini FEC)
- I/O connector with 1x-SPI/1x-I2C/1x-UART/4x-GPIO signals
- PCIe Clock generator
- GPS and accelerometer
- 1x USB 2.0 Front Panel connector
- wide range power supply
The GW72xx Baseboard contains:
- 2x MiniPCIe Socket with USB2.0, PCIe, and SIM
- 2x RJ45 GbE (i.MX 8M Mini FEC and LAN743x)
- 1x MicroSD connector
- 1x USB 2.0 Front Panel connector
- 1x SPI connector
- 1x Serial connector supporting 2x-UART or 1x-UART configured as 1 of:
RS232 w/ flow-control, RS485, RS422
- PCIe Clock generator
- GPS and accelerometer
- Media Expansion connector (MIPI-CSI/MIPI-DSI/GPIO/I2S)
- I/O connector with 2x-ADC,2x-GPIO,1x-UART,1x-I2C
- wide range power supply
The GW73xx Baseboard contains:
- 3x MiniPCIe Socket with USB2.0, PCIe, and SIM
- 2x RJ45 GbE (i.MX 8M Mini FEC and LAN743x)
- 1x MicroSD connector
- 1x USB 2.0 Front Panel connector
- 1x SPI connector
- 1x Serial connector supporting 2x-UART or 1x-UART configured as 1 of:
RS232 w/ flow-control, RS485, RS422
- WiFi/BT
- PCIe Clock generator
- GPS and accelerometer
- Media Expansion connector (MIPI-CSI/MIPI-DSI/GPIO/I2S)
- I/O connector with 2x-ADC,2x-GPIO,1x-UART,1x-I2C
- wide range power supply
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Reviewed-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
|
