summaryrefslogtreecommitdiff
path: root/drivers/hwspinlock/Makefile
AgeCommit message (Collapse)Author
2021-05-27hwspinlock: add sun6i hardware spinlock supportWilken Gottwalt
Adds the sun6i_hwspinlock driver for the hardware spinlock unit found in most of the sun6i compatible SoCs. This unit provides at least 32 spinlocks in hardware. The implementation supports 32, 64, 128 or 256 32bit registers. A lock can be taken by reading a register and released by writing a 0 to it. This driver supports all 4 spinlock setups, but for now only the first setup (32 locks) seem to exist in available devices. This spinlock unit is shared between all ARM cores and the embedded companion core. All of them can take/release a lock with a single cycle operation. It can be used to sync access to devices shared by the ARM cores and the companion core. There are two ways to check if a lock is taken. The first way is to read a lock. If a 0 is returned, the lock was free and is taken now. If an 1 is returned, the caller has to try again. Which means the lock is taken. The second way is to read a 32bit wide status register where every bit represents one of the 32 first locks. According to the datasheets this status register supports only the 32 first locks. This is the reason the first way (lock read/write) approach is used to be able to cover all 256 locks in future devices. The driver also reports the amount of supported locks via debugfs. Reviewed-by: Samuel Holland <samuel@sholland.org> Acked-by: Maxime Ripard <maxime@cerno.tech> Signed-off-by: Wilken Gottwalt <wilken.gottwalt@posteo.net> Link: https://lore.kernel.org/r/bfd2b97307c2321b15c09683f4bd5e1fcc792f13.1615713499.git.wilken.gottwalt@posteo.net Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
2021-03-17hwspinlock: remove sirf driverArnd Bergmann
The CSR SiRF prima2/atlas platforms are getting removed, so this driver is no longer needed. Cc: Barry Song <baohua@kernel.org> Link: https://lore.kernel.org/linux-arm-kernel/20210120124812.2800027-1-arnd@kernel.org/T/ Signed-off-by: Arnd Bergmann <arnd@arndb.de> Link: https://lore.kernel.org/r/20210120132537.2285157-1-arnd@kernel.org Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
2018-12-05hwspinlock: add STM32 hwspinlock deviceBenjamin Gaignard
This patch adds support of hardware semaphores for stm32mp1 SoC. The hardware block provides 32 semaphores. Signed-off-by: Benjamin Gaignard <benjamin.gaignard@st.com> Signed-off-by: Benjamin Gaignard <benjamin.gaignard@linaro.org> Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
2017-11-02License cleanup: add SPDX GPL-2.0 license identifier to files with no licenseGreg Kroah-Hartman
Many source files in the tree are missing licensing information, which makes it harder for compliance tools to determine the correct license. By default all files without license information are under the default license of the kernel, which is GPL version 2. Update the files which contain no license information with the 'GPL-2.0' SPDX license identifier. The SPDX identifier is a legally binding shorthand, which can be used instead of the full boiler plate text. This patch is based on work done by Thomas Gleixner and Kate Stewart and Philippe Ombredanne. How this work was done: Patches were generated and checked against linux-4.14-rc6 for a subset of the use cases: - file had no licensing information it it. - file was a */uapi/* one with no licensing information in it, - file was a */uapi/* one with existing licensing information, Further patches will be generated in subsequent months to fix up cases where non-standard license headers were used, and references to license had to be inferred by heuristics based on keywords. The analysis to determine which SPDX License Identifier to be applied to a file was done in a spreadsheet of side by side results from of the output of two independent scanners (ScanCode & Windriver) producing SPDX tag:value files created by Philippe Ombredanne. Philippe prepared the base worksheet, and did an initial spot review of a few 1000 files. The 4.13 kernel was the starting point of the analysis with 60,537 files assessed. Kate Stewart did a file by file comparison of the scanner results in the spreadsheet to determine which SPDX license identifier(s) to be applied to the file. She confirmed any determination that was not immediately clear with lawyers working with the Linux Foundation. Criteria used to select files for SPDX license identifier tagging was: - Files considered eligible had to be source code files. - Make and config files were included as candidates if they contained >5 lines of source - File already had some variant of a license header in it (even if <5 lines). All documentation files were explicitly excluded. The following heuristics were used to determine which SPDX license identifiers to apply. - when both scanners couldn't find any license traces, file was considered to have no license information in it, and the top level COPYING file license applied. For non */uapi/* files that summary was: SPDX license identifier # files ---------------------------------------------------|------- GPL-2.0 11139 and resulted in the first patch in this series. If that file was a */uapi/* path one, it was "GPL-2.0 WITH Linux-syscall-note" otherwise it was "GPL-2.0". Results of that was: SPDX license identifier # files ---------------------------------------------------|------- GPL-2.0 WITH Linux-syscall-note 930 and resulted in the second patch in this series. - if a file had some form of licensing information in it, and was one of the */uapi/* ones, it was denoted with the Linux-syscall-note if any GPL family license was found in the file or had no licensing in it (per prior point). Results summary: SPDX license identifier # files ---------------------------------------------------|------ GPL-2.0 WITH Linux-syscall-note 270 GPL-2.0+ WITH Linux-syscall-note 169 ((GPL-2.0 WITH Linux-syscall-note) OR BSD-2-Clause) 21 ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause) 17 LGPL-2.1+ WITH Linux-syscall-note 15 GPL-1.0+ WITH Linux-syscall-note 14 ((GPL-2.0+ WITH Linux-syscall-note) OR BSD-3-Clause) 5 LGPL-2.0+ WITH Linux-syscall-note 4 LGPL-2.1 WITH Linux-syscall-note 3 ((GPL-2.0 WITH Linux-syscall-note) OR MIT) 3 ((GPL-2.0 WITH Linux-syscall-note) AND MIT) 1 and that resulted in the third patch in this series. - when the two scanners agreed on the detected license(s), that became the concluded license(s). - when there was disagreement between the two scanners (one detected a license but the other didn't, or they both detected different licenses) a manual inspection of the file occurred. - In most cases a manual inspection of the information in the file resulted in a clear resolution of the license that should apply (and which scanner probably needed to revisit its heuristics). - When it was not immediately clear, the license identifier was confirmed with lawyers working with the Linux Foundation. - If there was any question as to the appropriate license identifier, the file was flagged for further research and to be revisited later in time. In total, over 70 hours of logged manual review was done on the spreadsheet to determine the SPDX license identifiers to apply to the source files by Kate, Philippe, Thomas and, in some cases, confirmation by lawyers working with the Linux Foundation. Kate also obtained a third independent scan of the 4.13 code base from FOSSology, and compared selected files where the other two scanners disagreed against that SPDX file, to see if there was new insights. The Windriver scanner is based on an older version of FOSSology in part, so they are related. Thomas did random spot checks in about 500 files from the spreadsheets for the uapi headers and agreed with SPDX license identifier in the files he inspected. For the non-uapi files Thomas did random spot checks in about 15000 files. In initial set of patches against 4.14-rc6, 3 files were found to have copy/paste license identifier errors, and have been fixed to reflect the correct identifier. Additionally Philippe spent 10 hours this week doing a detailed manual inspection and review of the 12,461 patched files from the initial patch version early this week with: - a full scancode scan run, collecting the matched texts, detected license ids and scores - reviewing anything where there was a license detected (about 500+ files) to ensure that the applied SPDX license was correct - reviewing anything where there was no detection but the patch license was not GPL-2.0 WITH Linux-syscall-note to ensure that the applied SPDX license was correct This produced a worksheet with 20 files needing minor correction. This worksheet was then exported into 3 different .csv files for the different types of files to be modified. These .csv files were then reviewed by Greg. Thomas wrote a script to parse the csv files and add the proper SPDX tag to the file, in the format that the file expected. This script was further refined by Greg based on the output to detect more types of files automatically and to distinguish between header and source .c files (which need different comment types.) Finally Greg ran the script using the .csv files to generate the patches. Reviewed-by: Kate Stewart <kstewart@linuxfoundation.org> Reviewed-by: Philippe Ombredanne <pombredanne@nexb.com> Reviewed-by: Thomas Gleixner <tglx@linutronix.de> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2017-05-17hwspinlock: sprd: Add hardware spinlock driverBaolin Wang
The Spreadtrum hardware spinlock device can provide hardware assistance for synchronization between the multiple subsystems. Signed-off-by: Baolin Wang <baolin.wang@spreadtrum.com> Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
2015-06-12hwspinlock: add a CSR atlas7 driverWei Chen
Add hwspinlock support for the CSR atlas7 SoC. The Hardware Spinlock device on atlas7 provides hardware assistance for synchronization between the multiple processors in the system (dual Cortex-A7, CAN bus Cortex-M3 and audio DSP). Reviewed-by: Suman Anna <s-anna@ti.com> Reviewed-by: Bjorn Andersson <bjorn.andersson@sonymobile.com> Signed-off-by: Wei Chen <wei.chen@csr.com> Signed-off-by: Barry Song <Baohua.Song@csr.com> Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
2015-05-02hwspinlock: qcom: Add support for Qualcomm HW Mutex blockBjorn Andersson
Add driver for Qualcomm Hardware Mutex block found in many Qualcomm SoCs. Based on initial effort by Kumar Gala <galak@codeaurora.org> Signed-off-by: Bjorn Andersson <bjorn.andersson@sonymobile.com> Reviewed-by: Andy Gross <agross@codeaurora.org> Reviewed-by: Jeffrey Hugo <jhugo@codeaurora.org> Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
2011-09-21hwspinlock/u8500: add hwspinlock driverMathieu J. Poirier
Add hwspinlock driver for U8500's Hsem hardware. At this point only HSem's protocol 1 is used (i.e. no interrupts). Signed-off-by: Mathieu Poirier <mathieu.poirier@linaro.org> Acked-by: Linus Walleij <linus.walleij@linaro.org> [ohad@wizery.com: adopt recent hwspin_lock_{un}register API changes] [ohad@wizery.com: set the owner member of the driver] [ohad@wizery.com: mark ->remove() function as __devexit] [ohad@wizery.com: write commit log] [ohad@wizery.com: small cleanups] Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
2011-02-17drivers: hwspinlock: add OMAP implementationSimon Que
Add hwspinlock support for the OMAP4 Hardware Spinlock device. The Hardware Spinlock device on OMAP4 provides hardware assistance for synchronization between the multiple processors in the system (dual Cortex-A9, dual Cortex-M3 and a C64x+ DSP). [ohad@wizery.com: adapt to hwspinlock framework, tidy up] Signed-off-by: Simon Que <sque@ti.com> Signed-off-by: Hari Kanigeri <h-kanigeri2@ti.com> Signed-off-by: Krishnamoorthy, Balaji T <balajitk@ti.com> Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com> Cc: Benoit Cousson <b-cousson@ti.com> Cc: Kevin Hilman <khilman@ti.com> Cc: Grant Likely <grant.likely@secretlab.ca> Cc: Arnd Bergmann <arnd@arndb.de> Cc: Paul Walmsley <paul@pwsan.com> Cc: Russell King <linux@arm.linux.org.uk> Signed-off-by: Tony Lindgren <tony@atomide.com>
2011-02-17drivers: hwspinlock: add frameworkOhad Ben-Cohen
Add a platform-independent hwspinlock framework. Hardware spinlock devices are needed, e.g., in order to access data that is shared between remote processors, that otherwise have no alternative mechanism to accomplish synchronization and mutual exclusion operations. Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com> Cc: Hari Kanigeri <h-kanigeri2@ti.com> Cc: Benoit Cousson <b-cousson@ti.com> Cc: Kevin Hilman <khilman@ti.com> Cc: Grant Likely <grant.likely@secretlab.ca> Cc: Paul Walmsley <paul@pwsan.com> Cc: Russell King <linux@arm.linux.org.uk> Acked-by: Arnd Bergmann <arnd@arndb.de> Signed-off-by: Tony Lindgren <tony@atomide.com>