summaryrefslogtreecommitdiff
path: root/drivers/net/wireless/iwlwifi/iwl-nvm-parse.c
AgeCommit message (Collapse)Author
2014-03-09iwlwifi: nvm: fix VHT capability antenna-dependent fieldsJohannes Berg
As the antenna dependent fields depend on the firmware file and not the NVM, use those fields in the VHT capability creation. Additionally, fix the STBC and antenna pattern consistency fields. Signed-off-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2014-02-24Merge branch 'for-john' of ↵John W. Linville
git://git.kernel.org/pub/scm/linux/kernel/git/iwlwifi/iwlwifi-next
2014-02-23iwlwifi: nvm: remove reading valid antennas from NVMJohannes Berg
These values aren't used as the firmware values should be used, so reading them is pointless and hides potential errors when somebody uses these values. Leave them zero to make it clearer that they can't be used. We can't remove the struct members as the DVM driver does read the values from EEPROM/OTP and the structure is shared between drivers. Signed-off-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2014-02-20iwlwifi: mvm: fix possible memory leakEytan Lifshitz
iwl_parse_nvm_data() doesn't free allocated memory if it is fed with invalid parameter. Fix this. Signed-off-by: Eytan Lifshitz <eytan.lifshitz@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2014-02-13Merge branch 'master' of ↵John W. Linville
git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless
2014-02-13iwlwifi: mvm: new NVM format in family 8000Eran Harary
Support the changes below: - Fields and sections structure were changed. - the NVM file built from DWord instead of Words. - sections header format was changed. Signed-off-by: Eran Harary <eran.harary@intel.com> Reviewed-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2014-02-03iwlwifi: remove obsolete TODOEmmanuel Grumbach
The calib_version is 255 and this is perfectly fine - no need to leave a TODO there. Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2014-02-02iwlwifi: mvm: don't allow A band if SKU forbids itEmmanuel Grumbach
The driver wasn't reading the NVM properly. While this didn't lead to any issue until now, it seems that there is an old version of the NVM in the wild. In this version, the A band channels appear to be valid but the SKU capabilities (another field of the NVM) says that A band isn't supported at all. With this specific version of the NVM, the driver would think that A band is supported while the HW / firmware don't. This leads to asserts. Cc: <stable@vger.kernel.org> [3.10+] Reviewed-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2014-01-13iwlwifi: mvm: don't use highest rate in VHT MCS SetEyal Shapira
Keeping this as 0 is ok according to spec section 9.7.11 as this means the limits are according to the Tx/Rx supported MCS x NSS bitmap. Initially we've set these as there were concerns of interop issues but these turned out to be false. Signed-off-by: Eyal Shapira <eyalx.shapira@intel.com> Reviewed-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2014-01-13iwlwifi: change beamformee STS capEyal Shapira
All beamformee supporting chips have the ability to support VHT NDP in up to 4 STSs. So change the published beamformee STS cap accordingly to 3 as it should be Nsts-1. Signed-off-by: Eyal Shapira <eyalx.shapira@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2013-12-31iwlwifi: Update Copyright to 2014Emmanuel Grumbach
Happy new year! Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2013-12-17iwlwifi: mvm: set highest rate in VHT MCS SetEyal Shapira
Set the Tx/Rx highest long GI rates in the VHT Supported MCS Set field according to the chip capabilties. Signed-off-by: Eyal Shapira <eyal@wizery.com> Reviewed-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2013-12-17iwlwifi: publish Tx STBC support in VHTEyal Shapira
If the device is MIMO and VHT capable it supports Tx STBC. Unlike HT, any chip that supports VHT also support STBC so no need for a config parameter. Using num_of_ants multiple times warranted caching it. Signed-off-by: Eyal Shapira <eyal@wizery.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2013-12-17iwlwifi: set VHT beamformee STS cap correctlyEyal Shapira
It was set to zero which reflects support of a single STS. Set according to the number of Rx antennas which correctly reflects the number of STSs the STA can receive in a VHT NDP. This improves beamforming and has been tested to improve Rx throughput. Signed-off-by: Eyal Shapira <eyal@wizery.com> Reviewed-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2013-12-09iwlwifi: fix check for a single rx antennaEyal Shapira
valid_rx_ant is a bitmask of available antennas and not the number of Rx antennas. Use num_of_ant and remove duplicate definitions in both dvm and mvm. Signed-off-by: Eyal Shapira <eyal@wizery.com> Reviewed-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
2013-11-25cfg80211: consolidate passive-scan and no-ibss flagsLuis R. Rodriguez
These two flags are used for the same purpose, just combine them into a no-ir flag to annotate no initiating radiation is allowed. Old userspace sending either flag will have it treated as the no-ir flag. To be considerate to older userspace we also send both the no-ir flag and the old no-ibss flags. Newer userspace will have to be aware of older kernels. Update all places in the tree using these flags with the following semantic patch: @@ @@ -NL80211_RRF_PASSIVE_SCAN +NL80211_RRF_NO_IR @@ @@ -NL80211_RRF_NO_IBSS +NL80211_RRF_NO_IR @@ @@ -IEEE80211_CHAN_PASSIVE_SCAN +IEEE80211_CHAN_NO_IR @@ @@ -IEEE80211_CHAN_NO_IBSS +IEEE80211_CHAN_NO_IR @@ @@ -NL80211_RRF_NO_IR | NL80211_RRF_NO_IR +NL80211_RRF_NO_IR @@ @@ -IEEE80211_CHAN_NO_IR | IEEE80211_CHAN_NO_IR +IEEE80211_CHAN_NO_IR @@ @@ -(NL80211_RRF_NO_IR) +NL80211_RRF_NO_IR @@ @@ -(IEEE80211_CHAN_NO_IR) +IEEE80211_CHAN_NO_IR Along with some hand-optimisations in documentation, to remove duplicates and to fix some indentation. Signed-off-by: Luis R. Rodriguez <mcgrof@do-not-panic.com> [do all the driver updates in one go] Signed-off-by: Johannes Berg <johannes.berg@intel.com>
2013-07-31iwlwifi: mvm: Enable user set TX powerMatti Gottlieb
Support Tx power limitations. These limitations can come from mac80211 for various reasons. Signed-off-by: Matti Gottlieb <matti.gottlieb@intel.com> Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com> Signed-off-by: Johannes Berg <johannes.berg@intel.com>
2013-05-29iwlwifi: take valid ant for HT caps from TLVEmmanuel Grumbach
I forgot to take them from TLV and took them from the NVM instead. Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com> Reviewed-by: Ilan Peer <ilan.peer@intel.com> Signed-off-by: Johannes Berg <johannes.berg@intel.com>
2013-05-13iwlwifi: nvm: honour VHT enable flagJohannes Berg
Some devices don't support VHT (802.11ac) and this is encoded in the data stored in the NVM. Read the flag and use it to set up the VHT capabilities accordingly. Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com> Signed-off-by: Johannes Berg <johannes.berg@intel.com>
2013-03-06iwlwifi: export symbols only conditionallyJohannes Berg
If all the pieces of iwlwifi are built into the kernel then there's no need for it to export its symbols to other modules, so prevent that. Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com> Signed-off-by: Johannes Berg <johannes.berg@intel.com>
2013-03-06iwlwifi: mvm: advertise VHT capabilitiesEytan Lifshitz
Update the NVM parsing functions to add VHT capabilities; they are only added for 5 GHz, of course. This assumes that all devices with NVM reading (rather than EEPROM) that support 5 GHz have VHT, which is true right now. Signed-off-by: Eytan Lifshitz <eytan.lifshitz@intel.com> Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com> Signed-off-by: Johannes Berg <johannes.berg@intel.com>
2013-03-06iwlwifi: a few fixes in licenseEmmanuel Grumbach
7000.c was released as GPL only by mistake: it should be dual licensed - GPL / BSD. The file that contains the license in the kernel is COPYING and not LICENSE.GPL. Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com> Signed-off-by: Johannes Berg <johannes.berg@intel.com>
2013-01-30iwlwifi: add NVM and PHY DB code for new MVM driverJohannes Berg
The new MVM (multi-virtual MAC) firmware driver requires NVM (non-volatile memory) parsing code and some PHY information database code. Add this separately. Signed-off-by: Johannes Berg <johannes.berg@intel.com>
generated by cgit (git 2.34.1) at 2025-06-05 02:42:42 +0000