From b1231b2f7305ade10694a59ffbcfa92357b49a0a Mon Sep 17 00:00:00 2001 From: Jerome Brunet Date: Mon, 28 Aug 2017 16:29:13 +0200 Subject: mmc: meson-gx: implement voltage switch callback Implement voltage switch callback (shamelessly copied from sunxi mmc driver). This allow, with the appropriate tuning function, to use SD ultra high speed modes. Reviewed-by: Kevin Hilman Signed-off-by: Jerome Brunet Signed-off-by: Ulf Hansson --- drivers/mmc/host/meson-gx-mmc.c | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+) diff --git a/drivers/mmc/host/meson-gx-mmc.c b/drivers/mmc/host/meson-gx-mmc.c index 2fa18faa7f0f..0cffc705bfe3 100644 --- a/drivers/mmc/host/meson-gx-mmc.c +++ b/drivers/mmc/host/meson-gx-mmc.c @@ -1049,6 +1049,27 @@ static int meson_mmc_card_busy(struct mmc_host *mmc) return !(FIELD_GET(STATUS_DATI, regval) & 0xf); } +static int meson_mmc_voltage_switch(struct mmc_host *mmc, struct mmc_ios *ios) +{ + /* vqmmc regulator is available */ + if (!IS_ERR(mmc->supply.vqmmc)) { + /* + * The usual amlogic setup uses a GPIO to switch from one + * regulator to the other. While the voltage ramp up is + * pretty fast, care must be taken when switching from 3.3v + * to 1.8v. Please make sure the regulator framework is aware + * of your own regulator constraints + */ + return mmc_regulator_set_vqmmc(mmc, ios); + } + + /* no vqmmc regulator, assume fixed regulator at 3/3.3V */ + if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_330) + return 0; + + return -EINVAL; +} + static const struct mmc_host_ops meson_mmc_ops = { .request = meson_mmc_request, .set_ios = meson_mmc_set_ios, @@ -1057,6 +1078,7 @@ static const struct mmc_host_ops meson_mmc_ops = { .post_req = meson_mmc_post_req, .execute_tuning = meson_mmc_execute_tuning, .card_busy = meson_mmc_card_busy, + .start_signal_voltage_switch = meson_mmc_voltage_switch, }; static int meson_mmc_probe(struct platform_device *pdev) -- cgit