From c80b5e4a2e787bb7b2dfff85fc2b192fd630663b Mon Sep 17 00:00:00 2001 From: Russell King Date: Sat, 30 Nov 2019 14:52:08 +0000 Subject: net: phy: marvell10g: place in powersave mode at probe Place the 88x3310 into powersaving mode when probing, which saves 600mW per PHY. For both PHYs on the Macchiatobin double-shot, this saves about 10% of the board idle power. Reviewed-by: Andrew Lunn Signed-off-by: Russell King --- drivers/net/phy/marvell10g.c | 30 ++++++++++++++++++++++++++---- 1 file changed, 26 insertions(+), 4 deletions(-) diff --git a/drivers/net/phy/marvell10g.c b/drivers/net/phy/marvell10g.c index 7092feb9e6b5..7e05b92504f0 100644 --- a/drivers/net/phy/marvell10g.c +++ b/drivers/net/phy/marvell10g.c @@ -227,6 +227,18 @@ static int mv3310_hwmon_probe(struct phy_device *phydev) } #endif +static int mv3310_power_down(struct phy_device *phydev) +{ + return phy_set_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL, + MV_V2_PORT_CTRL_PWRDOWN); +} + +static int mv3310_power_up(struct phy_device *phydev) +{ + return phy_clear_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL, + MV_V2_PORT_CTRL_PWRDOWN); +} + static int mv3310_reset(struct phy_device *phydev, u32 unit) { int retries, val, err; @@ -348,6 +360,11 @@ static int mv3310_probe(struct phy_device *phydev) dev_set_drvdata(&phydev->mdio.dev, priv); + /* Powering down the port when not in use saves about 600mW */ + ret = mv3310_power_down(phydev); + if (ret) + return ret; + ret = mv3310_hwmon_probe(phydev); if (ret) return ret; @@ -357,16 +374,14 @@ static int mv3310_probe(struct phy_device *phydev) static int mv3310_suspend(struct phy_device *phydev) { - return phy_set_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL, - MV_V2_PORT_CTRL_PWRDOWN); + return mv3310_power_down(phydev); } static int mv3310_resume(struct phy_device *phydev) { int ret; - ret = phy_clear_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL, - MV_V2_PORT_CTRL_PWRDOWN); + ret = mv3310_power_up(phydev); if (ret) return ret; @@ -392,6 +407,8 @@ static bool mv3310_has_pma_ngbaset_quirk(struct phy_device *phydev) static int mv3310_config_init(struct phy_device *phydev) { + int err; + /* Check that the PHY interface type is compatible */ if (phydev->interface != PHY_INTERFACE_MODE_SGMII && phydev->interface != PHY_INTERFACE_MODE_2500BASEX && @@ -402,6 +419,11 @@ static int mv3310_config_init(struct phy_device *phydev) phydev->mdix_ctrl = ETH_TP_MDI_AUTO; + /* Power up so reset works */ + err = mv3310_power_up(phydev); + if (err) + return err; + /* Enable EDPD mode - saving 600mW */ return mv3310_set_edpd(phydev, ETHTOOL_PHY_EDPD_DFLT_TX_MSECS); } -- cgit