From e732f6d26eeab94a4988a556951bbc015b0c3d16 Mon Sep 17 00:00:00 2001 From: Alexander Kurz Date: Tue, 29 May 2018 06:20:20 +0000 Subject: ARM: dts: imx6qdl-wandboard: enable USB OTG Enable USB OTG (dual-role) on the Wandboard. Note, that the USB_OTG_VBUS current is quite limited due to a 22R resistor in the power line. Hence, the overcurrent signal of 1A will never be triggered on this board. Signed-off-by: Alexander Kurz Reviewed-by: Fabio Estevam Signed-off-by: Shawn Guo --- arch/arm/boot/dts/imx6qdl-wandboard.dtsi | 19 ++++++++++++++++++- 1 file changed, 18 insertions(+), 1 deletion(-) (limited to 'arch/arm/boot/dts/imx6qdl-wandboard.dtsi') diff --git a/arch/arm/boot/dts/imx6qdl-wandboard.dtsi b/arch/arm/boot/dts/imx6qdl-wandboard.dtsi index 52baf6d1a956..381bf61fcd28 100644 --- a/arch/arm/boot/dts/imx6qdl-wandboard.dtsi +++ b/arch/arm/boot/dts/imx6qdl-wandboard.dtsi @@ -44,6 +44,16 @@ regulator-max-microvolt = <3300000>; regulator-always-on; }; + + reg_usb_otg_vbus: regulator-usbotgvbus { + compatible = "regulator-fixed"; + regulator-name = "usb_otg_vbus"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_usbotgvbus>; + gpio = <&gpio3 22 GPIO_ACTIVE_LOW>; + }; }; &audmux { @@ -166,6 +176,12 @@ >; }; + pinctrl_usbotgvbus: usbotgvbusgrp { + fsl,pins = < + MX6QDL_PAD_EIM_D22__GPIO3_IO22 0x130b0 + >; + }; + pinctrl_usdhc1: usdhc1grp { fsl,pins = < MX6QDL_PAD_SD1_CMD__SD1_CMD 0x17059 @@ -240,10 +256,11 @@ }; &usbotg { + vbus-supply = <®_usb_otg_vbus>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_usbotg>; disable-over-current; - dr_mode = "peripheral"; + dr_mode = "otg"; status = "okay"; }; -- cgit