From da7ac948fa93730421d9eb3b47253d8c40afceda Mon Sep 17 00:00:00 2001 From: Chen-Yu Tsai Date: Fri, 6 Oct 2017 14:42:32 +0800 Subject: ARM: dts: sun8i: Add board dts file for Banana Pi M2 Ultra The Banana Pi M2 Ultra is an SBC based on the Allwinner R40 SoC. The form factor and position of various connectors, leds and buttons is similar to the Banana Pi M1+, Banana Pi M3, and is exactly the same as the latest Banana Pi M64. It features: - X-Powers AXP221s PMIC connected to i2c0 - 2 GB DDR3 DRAM - 8 GB eMMC - micro SD card slot - DC power jack - HDMI output - MIPI DSI connector - 2x USB 2.0 hosts - 1x USB 2.0 OTG - gigabit ethernet with Realtek RTL8211E transceiver - WiFi/Bluetooth with AP6212 chip, with external antenna connector - SATA and power connectors for native SATA support - camera sensor connector - consumer IR receiver - audio out headphone jack - onboard microphone - red, green, and blue LEDs - debug UART pins - Li-Po battery connector - Raspberry Pi B+ compatible GPIO header - power, reset, and boot control buttons This patch adds a dts file that enables UART, MMC and PMIC support. Signed-off-by: Chen-Yu Tsai Signed-off-by: Icenowy Zheng Signed-off-by: Maxime Ripard --- arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts | 178 ++++++++++++++++++++++ 1 file changed, 178 insertions(+) create mode 100644 arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts (limited to 'arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts') diff --git a/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts b/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts new file mode 100644 index 000000000000..7b52608cebe6 --- /dev/null +++ b/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts @@ -0,0 +1,178 @@ +/* + * Copyright (C) 2017 Chen-Yu Tsai + * Copyright (C) 2017 Icenowy Zheng + * + * This file is dual-licensed: you can use it either under the terms + * of the GPL or the X11 license, at your option. Note that this dual + * licensing only applies to this file, and not this project as a + * whole. + * + * a) This file is free software; you can redistribute it and/or + * modify it under the terms of the GNU General Public License as + * published by the Free Software Foundation; either version 2 of the + * License, or (at your option) any later version. + * + * This file is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the + * GNU General Public License for more details. + * + * Or, alternatively, + * + * b) Permission is hereby granted, free of charge, to any person + * obtaining a copy of this software and associated documentation + * files (the "Software"), to deal in the Software without + * restriction, including without limitation the rights to use, + * copy, modify, merge, publish, distribute, sublicense, and/or + * sell copies of the Software, and to permit persons to whom the + * Software is furnished to do so, subject to the following + * conditions: + * + * The above copyright notice and this permission notice shall be + * included in all copies or substantial portions of the Software. + * + * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, + * EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES + * OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND + * NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT + * HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, + * WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING + * FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR + * OTHER DEALINGS IN THE SOFTWARE. + */ + +/dts-v1/; +#include "sun8i-r40.dtsi" + +#include + +/ { + model = "Banana Pi BPI-M2-Ultra"; + compatible = "sinovoip,bpi-m2-ultra", "allwinner,sun8i-r40"; + + aliases { + serial0 = &uart0; + }; + + chosen { + stdout-path = "serial0:115200n8"; + }; + + leds { + compatible = "gpio-leds"; + + pwr-led { + label = "bananapi:red:pwr"; + gpios = <&pio 7 20 GPIO_ACTIVE_HIGH>; + default-state = "on"; + }; + + user-led-green { + label = "bananapi:green:user"; + gpios = <&pio 7 21 GPIO_ACTIVE_HIGH>; + }; + + user-led-blue { + label = "bananapi:blue:user"; + gpios = <&pio 7 22 GPIO_ACTIVE_HIGH>; + }; + }; + + wifi_pwrseq: wifi_pwrseq { + compatible = "mmc-pwrseq-simple"; + reset-gpios = <&pio 6 10 GPIO_ACTIVE_LOW>; /* PG10 WIFI_EN */ + }; +}; + +&i2c0 { + status = "okay"; + + axp22x: pmic@34 { + compatible = "x-powers,axp221"; + reg = <0x34>; + interrupt-parent = <&nmi_intc>; + interrupts = <0 IRQ_TYPE_LEVEL_LOW>; + }; +}; + +#include "axp22x.dtsi" + +®_aldo3 { + regulator-always-on; + regulator-min-microvolt = <2700000>; + regulator-max-microvolt = <3300000>; + regulator-name = "avcc"; +}; + +®_dcdc1 { + regulator-always-on; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3000000>; + regulator-name = "vcc-3v0"; +}; + +®_dcdc2 { + regulator-always-on; + regulator-min-microvolt = <1000000>; + regulator-max-microvolt = <1300000>; + regulator-name = "vdd-cpu"; +}; + +®_dcdc3 { + regulator-always-on; + regulator-min-microvolt = <1000000>; + regulator-max-microvolt = <1300000>; + regulator-name = "vdd-sys"; +}; + +®_dcdc5 { + regulator-always-on; + regulator-min-microvolt = <1500000>; + regulator-max-microvolt = <1500000>; + regulator-name = "vcc-dram"; +}; + +®_dldo1 { + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <3300000>; + regulator-name = "vcc-wifi-io"; +}; + +®_dldo2 { + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + regulator-name = "vcc-wifi"; +}; + +&mmc0 { + vmmc-supply = <®_dcdc1>; + bus-width = <4>; + cd-gpios = <&pio 7 13 GPIO_ACTIVE_HIGH>; /* PH13 */ + cd-inverted; + status = "okay"; +}; + +&mmc1 { + pinctrl-names = "default"; + pinctrl-0 = <&mmc1_pg_pins>; + vmmc-supply = <®_dldo2>; + vqmmc-supply = <®_dldo1>; + mmc-pwrseq = <&wifi_pwrseq>; + bus-width = <4>; + non-removable; + status = "okay"; +}; + +&mmc2 { + vmmc-supply = <®_dcdc1>; + vqmmc-supply = <®_dcdc1>; + bus-width = <8>; + non-removable; + status = "okay"; +}; + +&uart0 { + pinctrl-names = "default"; + pinctrl-0 = <&uart0_pb_pins>; + status = "okay"; +}; -- cgit From 0ca12c1ee43ca2decd438e0c0d0550c84fa122c5 Mon Sep 17 00:00:00 2001 From: Icenowy Zheng Date: Wed, 18 Oct 2017 21:06:25 +0800 Subject: ARM: sun8i: r40: add 5V regulator for Banana Pi M2 Ultra On newer revisions of the Banana Pi M2 Ultra boards, the 5V power output (used by HDMI, SATA and USB) is controller via a GPIO. Add the regulator node for it. Older revisions just have the 5V power output always on, and the GPIO is reserved on these boards. So it won't affect the older revisions. Signed-off-by: Icenowy Zheng Signed-off-by: Maxime Ripard Acked-by: Chen-Yu Tsai --- arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts | 9 +++++++++ 1 file changed, 9 insertions(+) (limited to 'arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts') diff --git a/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts b/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts index 7b52608cebe6..035599d870b9 100644 --- a/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts +++ b/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts @@ -78,6 +78,15 @@ }; }; + reg_vcc5v0: vcc5v0 { + compatible = "regulator-fixed"; + regulator-name = "vcc5v0"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + gpio = <&pio 7 23 GPIO_ACTIVE_HIGH>; /* PH23 */ + enable-active-high; + }; + wifi_pwrseq: wifi_pwrseq { compatible = "mmc-pwrseq-simple"; reset-gpios = <&pio 6 10 GPIO_ACTIVE_LOW>; /* PG10 WIFI_EN */ -- cgit From 1357bdb21f2af1e62b8858488a7bccd0fea63e69 Mon Sep 17 00:00:00 2001 From: Icenowy Zheng Date: Wed, 18 Oct 2017 21:06:27 +0800 Subject: ARM: sun8i: r40: enable USB host for Banana Pi M2 Ultra Banana Pi M2 Ultra board features two USB host ports, connected to the two USB host ports on the SoC. Add support for them. Signed-off-by: Icenowy Zheng Signed-off-by: Maxime Ripard Acked-by: Chen-Yu Tsai --- arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+) (limited to 'arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts') diff --git a/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts b/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts index 035599d870b9..8c5efe2a9881 100644 --- a/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts +++ b/arch/arm/boot/dts/sun8i-r40-bananapi-m2-ultra.dts @@ -93,6 +93,14 @@ }; }; +&ehci1 { + status = "okay"; +}; + +&ehci2 { + status = "okay"; +}; + &i2c0 { status = "okay"; @@ -180,8 +188,22 @@ status = "okay"; }; +&ohci1 { + status = "okay"; +}; + +&ohci2 { + status = "okay"; +}; + &uart0 { pinctrl-names = "default"; pinctrl-0 = <&uart0_pb_pins>; status = "okay"; }; + +&usbphy { + usb1_vbus-supply = <®_vcc5v0>; + usb2_vbus-supply = <®_vcc5v0>; + status = "okay"; +}; -- cgit