From 510f02febb10259919a41926ab6bf9ec5c72ee48 Mon Sep 17 00:00:00 2001 From: Oleksij Rempel Date: Thu, 19 Oct 2023 13:14:59 +0200 Subject: net: phy: micrel: Fix forced link mode for KSZ886X switches Address a link speed detection issue in KSZ886X PHY driver when in forced link mode. Previously, link partners like "ASIX AX88772B" with KSZ8873 could fall back to 10Mbit instead of configured 100Mbit. The issue arises as KSZ886X PHY continues sending Fast Link Pulses (FLPs) even with autonegotiation off, misleading link partners in autoneg mode, leading to incorrect link speed detection. Now, when autonegotiation is disabled, the driver sets the link state forcefully using KSZ886X_CTRL_FORCE_LINK bit. This action, beyond just disabling autonegotiation, makes the PHY state more reliably detected by link partners using parallel detection, thus fixing the link speed misconfiguration. With autonegotiation enabled, link state is not forced, allowing proper autonegotiation process participation. Signed-off-by: Oleksij Rempel Reviewed-by: Vladimir Oltean Reviewed-by: Divya Koppera Signed-off-by: David S. Miller --- drivers/net/phy/micrel.c | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+) (limited to 'drivers/net/phy/micrel.c') diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c index 927d3d54658e..08e3915001c3 100644 --- a/drivers/net/phy/micrel.c +++ b/drivers/net/phy/micrel.c @@ -1733,6 +1733,28 @@ static int ksz886x_config_aneg(struct phy_device *phydev) if (ret) return ret; + if (phydev->autoneg != AUTONEG_ENABLE) { + /* When autonegotation is disabled, we need to manually force + * the link state. If we don't do this, the PHY will keep + * sending Fast Link Pulses (FLPs) which are part of the + * autonegotiation process. This is not desired when + * autonegotiation is off. + */ + ret = phy_set_bits(phydev, MII_KSZPHY_CTRL, + KSZ886X_CTRL_FORCE_LINK); + if (ret) + return ret; + } else { + /* If we had previously forced the link state, we need to + * clear KSZ886X_CTRL_FORCE_LINK bit now. Otherwise, the PHY + * will not perform autonegotiation. + */ + ret = phy_clear_bits(phydev, MII_KSZPHY_CTRL, + KSZ886X_CTRL_FORCE_LINK); + if (ret) + return ret; + } + /* The MDI-X configuration is automatically changed by the PHY after * switching from autoneg off to on. So, take MDI-X configuration under * own control and set it after autoneg configuration was done. -- cgit