// SPDX-License-Identifier: (GPL-2.0+ OR MIT) /* * Copyright (c) 2020 Rockchip Electronics Co., Ltd. * Copyright (c) 2022 Edgeble AI Technologies Pvt. Ltd. */ / { aliases { ethernet0 = &gmac; mmc0 = &emmc; }; chosen { stdout-path = "serial2:1500000n8"; }; vcc5v0_sys: regulator-vcc5v0-sys { compatible = "regulator-fixed"; regulator-name = "vcc5v0_sys"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; }; sdio_pwrseq: pwrseq-sdio { compatible = "mmc-pwrseq-simple"; clocks = <&rk809 1>; clock-names = "ext_clock"; pinctrl-names = "default"; pinctrl-0 = <&wifi_enable_h>; reset-gpios = <&gpio1 RK_PD0 GPIO_ACTIVE_LOW>; }; }; &emmc { bus-width = <8>; cap-mmc-highspeed; mmc-hs200-1_8v; non-removable; pinctrl-names = "default"; pinctrl-0 = <&emmc_bus8 &emmc_cmd &emmc_clk &emmc_rstnout>; rockchip,default-sample-phase = <90>; vmmc-supply = <&vcc_3v3>; vqmmc-supply = <&vcc_1v8>; status = "okay"; }; &i2c0 { clock-frequency = <400000>; status = "okay"; rk809: pmic@20 { compatible = "rockchip,rk809"; reg = <0x20>; interrupt-parent = <&gpio0>; interrupts = ; #clock-cells = <1>; clock-output-names = "rk808-clkout1", "rk808-clkout2"; pinctrl-names = "default"; pinctrl-0 = <&pmic_int_l>; rockchip,system-power-controller; wakeup-source; vcc1-supply = <&vcc5v0_sys>; vcc2-supply = <&vcc5v0_sys>; vcc3-supply = <&vcc5v0_sys>; vcc4-supply = <&vcc5v0_sys>; vcc5-supply = <&vcc_buck5>; vcc6-supply = <&vcc_buck5>; vcc7-supply = <&vcc5v0_sys>; vcc8-supply = <&vcc3v3_sys>; vcc9-supply = <&vcc5v0_sys>; regulators { vdd_npu_vepu: DCDC_REG1 { regulator-name = "vdd_npu_vepu"; regulator-always-on; regulator-boot-on; regulator-initial-mode = <0x2>; regulator-min-microvolt = <650000>; regulator-max-microvolt = <950000>; regulator-ramp-delay = <6001>; regulator-state-mem { regulator-off-in-suspend; }; }; vdd_arm: DCDC_REG2 { regulator-name = "vdd_arm"; regulator-always-on; regulator-boot-on; regulator-initial-mode = <0x2>; regulator-min-microvolt = <725000>; regulator-max-microvolt = <1350000>; regulator-ramp-delay = <6001>; regulator-state-mem { regulator-off-in-suspend; }; }; vcc_ddr: DCDC_REG3 { regulator-name = "vcc_ddr"; regulator-always-on; regulator-boot-on; regulator-initial-mode = <0x2>; regulator-state-mem { regulator-on-in-suspend; }; }; vcc3v3_sys: DCDC_REG4 { regulator-name = "vcc3v3_sys"; regulator-always-on; regulator-boot-on; regulator-initial-mode = <0x2>; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <3300000>; }; }; vcc_buck5: DCDC_REG5 { regulator-name = "vcc_buck5"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <2200000>; regulator-max-microvolt = <2200000>; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <2200000>; }; }; vcc_0v8: LDO_REG1 { regulator-name = "vcc_0v8"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <800000>; regulator-max-microvolt = <800000>; regulator-state-mem { regulator-off-in-suspend; }; }; vcc1v8_pmu: LDO_REG2 { regulator-name = "vcc1v8_pmu"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <1800000>; }; }; vdd0v8_pmu: LDO_REG3 { regulator-name = "vcc0v8_pmu"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <800000>; regulator-max-microvolt = <800000>; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <800000>; }; }; vcc_1v8: LDO_REG4 { regulator-name = "vcc_1v8"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <1800000>; }; }; vcc_dovdd: LDO_REG5 { regulator-name = "vcc_dovdd"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; regulator-state-mem { regulator-off-in-suspend; }; }; vcc_dvdd: LDO_REG6 { regulator-name = "vcc_dvdd"; regulator-min-microvolt = <1200000>; regulator-max-microvolt = <1200000>; regulator-state-mem { regulator-off-in-suspend; }; }; vcc_avdd: LDO_REG7 { regulator-name = "vcc_avdd"; regulator-min-microvolt = <2800000>; regulator-max-microvolt = <2800000>; regulator-state-mem { regulator-off-in-suspend; }; }; vccio_sd: LDO_REG8 { regulator-name = "vccio_sd"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <3300000>; regulator-state-mem { regulator-off-in-suspend; }; }; vcc3v3_sd: LDO_REG9 { regulator-name = "vcc3v3_sd"; regulator-always-on; regulator-boot-on; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; regulator-state-mem { regulator-off-in-suspend; }; }; vcc_5v0: SWITCH_REG1 { regulator-name = "vcc_5v0"; }; vcc_3v3: SWITCH_REG2 { regulator-name = "vcc_3v3"; regulator-always-on; regulator-boot-on; }; }; }; }; &i2c2 { status = "okay"; clock-frequency = <400000>; pcf8563: rtc@51 { compatible = "nxp,pcf8563"; reg = <0x51>; #clock-cells = <0>; interrupt-parent = <&gpio0>; interrupts = ; clock-output-names = "xin32k"; }; }; &gmac { assigned-clocks = <&cru CLK_GMAC_SRC_M1>, <&cru CLK_GMAC_SRC>, <&cru CLK_GMAC_TX_RX>; assigned-clock-parents = <&cru CLK_GMAC_RGMII_M1>, <&cru CLK_GMAC_SRC_M1>, <&cru RMII_MODE_CLK>; assigned-clock-rates = <0>, <50000000>; clock_in_out = "output"; phy-handle = <&phy>; phy-mode = "rmii"; phy-supply = <&vcc_3v3>; pinctrl-names = "default"; pinctrl-0 = <&rgmiim1_miim &rgmiim1_rxer &rgmiim1_bus2 &rgmiim1_mclkinout>; status = "okay"; }; &mdio { phy: ethernet-phy@0 { compatible = "ethernet-phy-ieee802.3-c22"; reg = <0x0>; pinctrl-names = "default"; pinctrl-0 = <ð_phy_rst>; reset-active-low; reset-assert-us = <50000>; reset-deassert-us = <10000>; reset-gpios = <&gpio2 RK_PA6 GPIO_ACTIVE_LOW>; }; }; &pinctrl { ethernet { eth_phy_rst: eth-phy-rst { rockchip,pins = <2 RK_PA6 RK_FUNC_GPIO &pcfg_pull_down>; }; }; bt { bt_enable: bt-enable { rockchip,pins = <1 RK_PC6 RK_FUNC_GPIO &pcfg_pull_none>; }; bt_wake_dev: bt-wake-dev { rockchip,pins = <1 RK_PC7 RK_FUNC_GPIO &pcfg_pull_none>; }; bt_wake_host: bt-wake-host { rockchip,pins = <1 RK_PC5 RK_FUNC_GPIO &pcfg_pull_none>; }; }; pmic { pmic_int_l: pmic-int-l { rockchip,pins = <0 RK_PB1 RK_FUNC_GPIO &pcfg_pull_up>; }; }; wifi { wifi_enable_h: wifi-enable-h { rockchip,pins = <1 RK_PD0 RK_FUNC_GPIO &pcfg_pull_none>; }; }; }; &pmu_io_domains { pmuio0-supply = <&vcc1v8_pmu>; pmuio1-supply = <&vcc3v3_sys>; vccio1-supply = <&vcc_1v8>; vccio2-supply = <&vccio_sd>; vccio3-supply = <&vcc_1v8>; vccio4-supply = <&vcc_dovdd>; vccio5-supply = <&vcc_1v8>; vccio6-supply = <&vcc_1v8>; vccio7-supply = <&vcc_dovdd>; status = "okay"; }; &saradc { vref-supply = <&vcc_1v8>; status = "okay"; }; &sdio { bus-width = <4>; cap-sd-highspeed; cap-sdio-irq; keep-power-in-suspend; max-frequency = <100000000>; mmc-pwrseq = <&sdio_pwrseq>; non-removable; pinctrl-names = "default"; pinctrl-0 = <&sdmmc1_clk &sdmmc1_cmd &sdmmc1_bus4>; rockchip,default-sample-phase = <90>; sd-uhs-sdr104; vmmc-supply = <&vcc3v3_sys>; vqmmc-supply = <&vcc_1v8>; status = "okay"; }; &sdmmc { bus-width = <4>; cap-mmc-highspeed; cap-sd-highspeed; card-detect-delay = <200>; pinctrl-names = "default"; pinctrl-0 = <&sdmmc0_clk &sdmmc0_cmd &sdmmc0_bus4 &sdmmc0_det>; rockchip,default-sample-phase = <90>; sd-uhs-sdr12; sd-uhs-sdr25; sd-uhs-sdr104; vqmmc-supply = <&vccio_sd>; status = "okay"; }; &uart0 { pinctrl-names = "default"; pinctrl-0 = <&uart0_xfer &uart0_ctsn &uart0_rtsn>; uart-has-rtscts; status = "okay"; bluetooth { compatible = "realtek,rtl8723ds-bt"; device-wake-gpios = <&gpio1 RK_PC7 GPIO_ACTIVE_HIGH>; /* BT_WAKE */ enable-gpios = <&gpio1 RK_PC6 GPIO_ACTIVE_HIGH>; /* BT_RST */ host-wake-gpios = <&gpio1 RK_PC5 GPIO_ACTIVE_HIGH>; /* BT_WAKE_HOST */ max-speed = <2000000>; pinctrl-names = "default"; pinctrl-0 = <&bt_enable>, <&bt_wake_dev>, <&bt_wake_host>; }; }; &uart2 { status = "okay"; }; &uart3 { pinctrl-names = "default"; pinctrl-0 = <&uart3m2_xfer>; status = "okay"; }; &uart4 { pinctrl-names = "default"; pinctrl-0 = <&uart4m2_xfer>; status = "okay"; };