From 28a134f5a0553110c623c31ceb653a21fbe92be7 Mon Sep 17 00:00:00 2001 From: Vladimir Oltean Date: Mon, 24 Feb 2020 14:15:33 +0200 Subject: net: dsa: felix: Use PHY_INTERFACE_MODE_INTERNAL instead of GMII phy-mode = "gmii" is confusing because it may mean that the port supports the 8-bit-wide parallel data interface pinout, which it doesn't. It may also be confusing because one of the "gmii" internal ports is actually overclocked to run at 2.5Gbps (even though, yes, as far as the switch MAC is concerned, it still thinks it's gigabit). So use the phy-mode = "internal" property to describe the internal ports inside the NXP LS1028A chip (the ones facing the ENETC). The change should be fine, because the device tree bindings document is yet to be introduced, and there are no stable DT blobs in use. Signed-off-by: Vladimir Oltean Reviewed-by: Andrew Lunn Tested-by: Michael Walle Signed-off-by: David S. Miller --- drivers/net/dsa/ocelot/felix.c | 3 +-- drivers/net/dsa/ocelot/felix_vsc9959.c | 3 +-- 2 files changed, 2 insertions(+), 4 deletions(-) diff --git a/drivers/net/dsa/ocelot/felix.c b/drivers/net/dsa/ocelot/felix.c index 3257962..35124ef 100644 --- a/drivers/net/dsa/ocelot/felix.c +++ b/drivers/net/dsa/ocelot/felix.c @@ -176,8 +176,7 @@ static void felix_phylink_validate(struct dsa_switch *ds, int port, phylink_set(mask, 100baseT_Full); phylink_set(mask, 1000baseT_Full); - /* The internal ports that run at 2.5G are overclocked GMII */ - if (state->interface == PHY_INTERFACE_MODE_GMII || + if (state->interface == PHY_INTERFACE_MODE_INTERNAL || state->interface == PHY_INTERFACE_MODE_2500BASEX || state->interface == PHY_INTERFACE_MODE_USXGMII) { phylink_set(mask, 2500baseT_Full); diff --git a/drivers/net/dsa/ocelot/felix_vsc9959.c b/drivers/net/dsa/ocelot/felix_vsc9959.c index 2c812b4..93800e8 100644 --- a/drivers/net/dsa/ocelot/felix_vsc9959.c +++ b/drivers/net/dsa/ocelot/felix_vsc9959.c @@ -955,8 +955,7 @@ static int vsc9959_prevalidate_phy_mode(struct ocelot *ocelot, int port, phy_interface_t phy_mode) { switch (phy_mode) { - case PHY_INTERFACE_MODE_GMII: - /* Only supported on internal to-CPU ports */ + case PHY_INTERFACE_MODE_INTERNAL: if (port != 4 && port != 5) return -ENOTSUPP; return 0; -- cgit