summaryrefslogtreecommitdiff
path: root/drivers/net/wireless/realtek/rtw89/efuse.c
AgeCommit message (Collapse)Author
2024-11-06wifi: rtw89: efuse: read firmware secure info v0 from efuse for WiFi 6 chipsPing-Ke Shih
WiFi 6 chips could program secure information in v0 or v1 format. Use existing v1 parser or newly added v0 parser to recognize firmware key that is going to be used. Signed-off-by: Ping-Ke Shih <pkshih@realtek.com> Link: https://patch.msgid.link/20241030022135.11688-4-pkshih@realtek.com
2024-11-06wifi: rtw89: efuse: move recognize firmware MSS info v1 to commonPing-Ke Shih
The WiFi 6 chip use the same firmware MSS information v1 read from efuse, so move this logic to common. No change logic at all. Signed-off-by: Ping-Ke Shih <pkshih@realtek.com> Link: https://patch.msgid.link/20241030022135.11688-3-pkshih@realtek.com
2024-11-06wifi: rtw89: efuse: move reading efuse of fw secure info to commonPing-Ke Shih
The secure key used by certain hardware module is programmed in efuse, so driver should read the information from efuse before downloading firmware. Originally only RTL8922AE can support firmware secure boot, and read efuse during chip power on. To extend to support all chips, move the caller to common power on flow and add separate functions to read efuse for WiFi 6 chips. No logic change at all. Signed-off-by: Ping-Ke Shih <pkshih@realtek.com> Link: https://patch.msgid.link/20241030022135.11688-2-pkshih@realtek.com
2023-11-22wifi: rtw89: mac: add to access efuse for WiFi 7 chipsPing-Ke Shih
MAC address, hardware type, calibration values and etc are stored in efuse, so we read them at probe stage and use them as capabilities to register hardware. There are two physical efuse -- one is the main efuse for digital hardware part, and the other is for analog part. Because they are very similar, we only describe the main efuse below. The main efuse is split into two regions -- one is for logic map, and the other is for physical map. For both regions, we use the same method to read data, but need additional parser to get logic map. To allow reading operation, we need to convert power state to active, and turn to idle state after reading. For WiFi 7 chips, we introduce efuse blocks to define feature group easier, and these blocks are discontinue. For example, RF block is from 0x1_0000 ~ 0x1_0240, and the next block PCIE_SDIO is starting from 0x2_0000. Comparing to old one used by WiFi 6 chips, there is only single one logic map, it would be a little hard to add an new field to a group if we don't reserve a room in advance. The relationship between efuse, region and block is shown as below: (logical map) +------------+ +---------------+ +-----------------+ | main efuse | | region 1 | | block 0x1_0000~ | | (digital) | |(to logcal map)| +-----------------+ | | | | => +-----------------+ | | => | | | block 0x2_0000~ | | | | | +-----------------+ | | |---------------| : | | | region 2 | +------------+ +---------------+ +------------+ +-----------------+ | 2nd efuse | ======================> | block 0x7_0000~ | | (analog) | +-----------------+ +------------+ The parser converting from raw data to logic map is to decode block page, block page offset, and word_en bits. Each word_en bit indicates two following bytes as data of logic map, so total four word_en bits can represent eight bytes. Thus, block page offset is 8-byte alignment. The layout of a tuple is shown as below +--------+--------+--------+--------+--------+--------+ | fixed 3 byte header | | | | | | | | | | [19:17] block_page | | | ... | | [16:4] block_page_offset| | | | | [3:0] word_en | ^ | ^ | | +----|---+--------+--------+---|----+----|---+--------+ | | | +-------------------------+---------+ a word_en bit indicates two bytes as data For example, block_page = 0x3 block_page_offset = 0x80 (must 8-byte alignment) word_en = 0x6 (b'0110; 0 means data is presented) following 4 bytes = 34 56 78 90 Then, 0x3_0080 = 34 56 0x3_0086 = 78 90 A special block page is RTW89_EFUSE_BLOCK_ADIE (7) that uses different but similar format, because its real efuse size is smaller than main efuse. Signed-off-by: Ping-Ke Shih <pkshih@realtek.com> Signed-off-by: Kalle Valo <kvalo@kernel.org> Link: https://lore.kernel.org/r/20231117024029.113845-4-pkshih@realtek.com
2023-11-22wifi: rtw89: mac: use mac_gen pointer to access about efusePing-Ke Shih
Use function pointers to abstract efuse access, and introduce an new function to convert efuse power state that is needed by WiFi 7 chips. Signed-off-by: Ping-Ke Shih <pkshih@realtek.com> Signed-off-by: Kalle Valo <kvalo@kernel.org> Link: https://lore.kernel.org/r/20231117024029.113845-3-pkshih@realtek.com
2023-05-17wifi: rtw89: 8851b: add to read efuse version to recognize hardware version BPing-Ke Shih
8851B hardware version A and B use different firmware, but register version code of these two are the same, so add this helper to read efuse version to determine which version is installed. Signed-off-by: Ping-Ke Shih <pkshih@realtek.com> Signed-off-by: Kalle Valo <kvalo@kernel.org> Link: https://lore.kernel.org/r/20230512061220.16544-2-pkshih@realtek.com
2022-03-10rtw89: support DAV efuse reading operationPing-Ke Shih
DAV is an another efuse region that new chip, like 8852C, has this region. Extend the code to read it, and convert the physical map to logical map followed by original logical map. Signed-off-by: Ping-Ke Shih <pkshih@realtek.com> Signed-off-by: Kalle Valo <kvalo@kernel.org> Link: https://lore.kernel.org/r/20220307060457.56789-12-pkshih@realtek.com
2021-10-13rtw89: add Realtek 802.11ax driverPing-Ke Shih
This driver named rtw89, which is the next generation of rtw88, supports Realtek 8852AE 802.11ax 2x2 chip whose new features are OFDMA, DBCC, Spatial reuse, TWT and BSS coloring; now some of them aren't implemented though. The chip architecture is entirely different from the chips supported by rtw88 like RTL8822CE 802.11ac chip. First of all, register address ranges are totally redefined, so it's impossible to reuse register definition. To communicate with firmware, new H2C/C2H format is proposed. In order to have better utilization, TX DMA flow is changed to two stages DMA. To provide rich RX status information, additional RX PPDU packets are added. Since there are so many differences mentioned above, we decide to propose a new driver. It has many authors, they are listed in alphabetic order: Chin-Yen Lee <timlee@realtek.com> Ping-Ke Shih <pkshih@realtek.com> Po Hao Huang <phhuang@realtek.com> Tzu-En Huang <tehuang@realtek.com> Vincent Fann <vincent_fann@realtek.com> Yan-Hsuan Chuang <tony0620emma@gmail.com> Zong-Zhe Yang <kevin_yang@realtek.com> Tested-by: Aaron Ma <aaron.ma@canonical.com> Tested-by: Brian Norris <briannorris@chromium.org> Signed-off-by: Ping-Ke Shih <pkshih@realtek.com> Signed-off-by: Kalle Valo <kvalo@codeaurora.org> Link: https://lore.kernel.org/r/20211008035627.19463-1-pkshih@realtek.com