1 files changed, 0 insertions, 44 deletions
diff --git a/Documentation/devicetree/bindings/gpio/gpio-altera.txt b/Documentation/devicetree/bindings/gpio/gpio-altera.txt
deleted file mode 100644
index 2a80e272cd66..000000000000
--- a/Documentation/devicetree/bindings/gpio/gpio-altera.txt
+++ /dev/null
@@ -1,44 +0,0 @@
-Altera GPIO controller bindings
-
-Required properties:
-- compatible:
-  - "altr,pio-1.0"
-- reg: Physical base address and length of the controller's registers.
-- #gpio-cells : Should be 2
-  - The first cell is the gpio offset number.
-  - The second cell is reserved and is currently unused.
-- gpio-controller : Marks the device node as a GPIO controller.
-- interrupt-controller: Mark the device node as an interrupt controller
-- #interrupt-cells : Should be 2. The interrupt type is fixed in the hardware.
-  - The first cell is the GPIO offset number within the GPIO controller.
-  - The second cell is the interrupt trigger type and level flags.
-- interrupts: Specify the interrupt.
-- altr,interrupt-type: Specifies the interrupt trigger type the GPIO
-  hardware is synthesized. This field is required if the Altera GPIO controller
-  used has IRQ enabled as the interrupt type is not software controlled,
-  but hardware synthesized. Required if GPIO is used as an interrupt
-  controller. The value is defined in <dt-bindings/interrupt-controller/irq.h>
-  Only the following flags are supported:
-    IRQ_TYPE_EDGE_RISING
-    IRQ_TYPE_EDGE_FALLING
-    IRQ_TYPE_EDGE_BOTH
-    IRQ_TYPE_LEVEL_HIGH
-
-Optional properties:
-- altr,ngpio: Width of the GPIO bank. This defines how many pins the
-  GPIO device has. Ranges between 1-32. Optional and defaults to 32 if not
-  specified.
-
-Example:
-
-gpio_altr: gpio@ff200000 {
-	compatible = "altr,pio-1.0";
-	reg = <0xff200000 0x10>;
-	interrupts = <0 45 4>;
-	altr,ngpio = <32>;
-	altr,interrupt-type = <IRQ_TYPE_EDGE_RISING>;
-	#gpio-cells = <2>;
-	gpio-controller;
-	#interrupt-cells = <2>;
-	interrupt-controller;
-};