diff options
Diffstat (limited to 'Documentation/devicetree/usage-model.rst')
| -rw-r--r-- | Documentation/devicetree/usage-model.rst | 6 |
1 files changed, 3 insertions, 3 deletions
diff --git a/Documentation/devicetree/usage-model.rst b/Documentation/devicetree/usage-model.rst index 0717426856b2..c6146c96ac56 100644 --- a/Documentation/devicetree/usage-model.rst +++ b/Documentation/devicetree/usage-model.rst @@ -46,7 +46,7 @@ The DT was originally created by Open Firmware as part of the communication method for passing data from Open Firmware to a client program (like to an operating system). An operating system used the Device Tree to discover the topology of the hardware at runtime, and -thereby support a majority of available hardware without hard coded +thereby supported a majority of available hardware without hard coded information (assuming drivers were available for all devices). Since Open Firmware is commonly used on PowerPC and SPARC platforms, @@ -128,7 +128,7 @@ successor, the BeagleBoard xM board might look like, respectively:: compatible = "ti,omap3-beagleboard-xm", "ti,omap3450", "ti,omap3"; Where "ti,omap3-beagleboard-xm" specifies the exact model, it also -claims that it compatible with the OMAP 3450 SoC, and the omap3 family +claims that it is compatible with the OMAP 3450 SoC, and the omap3 family of SoCs in general. You'll notice that the list is sorted from most specific (exact board) to least specific (SoC family). @@ -205,7 +205,7 @@ platform-specific configuration data. During early boot, the architecture setup code calls of_scan_flat_dt() several times with different helper callbacks to parse device tree -data before paging is setup. The of_scan_flat_dt() code scans through +data before paging is set up. The of_scan_flat_dt() code scans through the device tree and uses the helpers to extract information required during early boot. Typically the early_init_dt_scan_chosen() helper is used to parse the chosen node including kernel parameters, |