1 files changed, 192 insertions, 0 deletions
diff --git a/drivers/gpib/include/tnt4882_registers.h b/drivers/gpib/include/tnt4882_registers.h
new file mode 100644
index 000000000000..d54c4cc61168
--- /dev/null
+++ b/drivers/gpib/include/tnt4882_registers.h
@@ -0,0 +1,192 @@
+/* SPDX-License-Identifier: GPL-2.0 */
+
+/***************************************************************************
+ *    copyright		   : (C) 2002, 2004 by Frank Mori Hess
+ ***************************************************************************/
+
+#ifndef _TNT4882_REGISTERS_H
+#define _TNT4882_REGISTERS_H
+
+// tnt4882 register offsets
+enum {
+	ACCWR = 0x5,
+	// offset of auxiliary command register in 9914 mode
+	AUXCR = 0x6,
+	INTRT = 0x7,
+	// register number for auxiliary command register when swap bit is set (9914 mode)
+	SWAPPED_AUXCR = 0xa,
+	HSSEL = 0xd,	// handshake select register
+	CNT2 = 0x9,
+	CNT3 = 0xb,
+	CFG = 0x10,
+	SASR = 0x1b,
+	IMR0 = 0x1d,
+	IMR3 = 0x12,
+	CNT0 = 0x14,
+	CNT1 = 0x16,
+	KEYREG = 0x17,	// key control register (7210 mode only)
+	CSR = KEYREG,
+	FIFOB = 0x18,
+	FIFOA = 0x19,
+	CCR = 0x1a,	// carry cycle register
+	CMDR = 0x1c,	// command register
+	TIMER = 0x1e,	// timer register
+
+	STS1 = 0x10,	// T488 Status Register 1
+	STS2 = 0x1c,	// T488 Status Register 2
+	ISR0 = IMR0,
+	ISR3 = 0x1a,	// T488 Interrupt Status Register 3
+	BCR = 0x1f,	// bus control/status register
+	BSR = BCR,
+};
+
+enum {
+	tnt_pagein_offset = 0x11,
+};
+
+/*============================================================*/
+
+/* TURBO-488 registers bit definitions */
+
+enum bus_control_status_bits {
+	BCSR_REN_BIT = 0x1,
+	BCSR_IFC_BIT = 0x2,
+	BCSR_SRQ_BIT = 0x4,
+	BCSR_EOI_BIT = 0x8,
+	BCSR_NRFD_BIT = 0x10,
+	BCSR_NDAC_BIT = 0x20,
+	BCSR_DAV_BIT = 0x40,
+	BCSR_ATN_BIT = 0x80,
+};
+
+/* CFG -- Configuration Register (write only) */
+enum cfg_bits {
+	TNT_COMMAND = 0x80,	/* bytes are command bytes instead of data bytes
+				 * (tnt4882 one-chip and newer only?)
+				 */
+	TNT_TLCHE = (1 << 6),	/* halt transfer on imr0, imr1, or imr2 interrupt */
+	TNT_IN = (1 << 5),	/* transfer is GPIB read		 */
+	TNT_A_B = (1 << 4),	/* order to use fifos 1=fifo A first(big endian),
+				 * 0=fifo b first(little endian)
+				 */
+	TNT_CCEN = (1 << 3),	/* enable carry cycle		      */
+	TNT_TMOE = (1 << 2),	/* enable CPU bus time limit	      */
+	TNT_TIM_BYTN = (1 << 1),	/* tmot reg is: 1=125ns clocks, 0=num bytes */
+	TNT_B_16BIT = (1 << 0),	/* 1=FIFO is 16-bit register, 0=8-bit */
+};
+
+/* CMDR -- Command Register */
+enum cmdr_bits {
+	CLRSC = 0x2,	/* clear the system controller bit */
+	SETSC = 0x3,	/* set the system controller bit */
+	GO = 0x4,	/* start fifos */
+	STOP = 0x8,	/* stop fifos */
+	RESET_FIFO = 0x10,	/* reset the FIFOs		*/
+	SOFT_RESET = 0x22,	/* issue a software reset	*/
+	HARD_RESET = 0x40	/* 500x only? */
+};
+
+/* HSSEL -- handshake select register (write only) */
+enum hssel_bits {
+	TNT_ONE_CHIP_BIT = 0x1,
+	NODMA = 0x10,
+	TNT_GO2SIDS_BIT = 0x20,
+};
+
+/* IMR0 -- Interrupt Mode Register 0 */
+enum imr0_bits {
+	TNT_SYNCIE_BIT = 0x1, /* handshake sync */
+	TNT_TOIE_BIT = 0x2, /* timeout */
+	TNT_ATNIE_BIT = 0x4, /* ATN interrupt */
+	TNT_IFCIE_BIT = 0x8,	/* interface clear interrupt */
+	TNT_BTO_BIT = 0x10, /* byte timeout */
+	TNT_NLEN_BIT = 0x20,	/* treat new line as EOS char */
+	TNT_STBOIE_BIT = 0x40,	/* status byte out  */
+	TNT_IMR0_ALWAYS_BITS = 0x80,	/* always set this bit on write */
+};
+
+/* ISR0 -- Interrupt Status Register 0 */
+enum isr0_bits {
+	TNT_SYNC_BIT = 0x1,	/* handshake sync */
+	TNT_TO_BIT = 0x2,	/* timeout */
+	TNT_ATNI_BIT = 0x4,	/* ATN interrupt */
+	TNT_IFCI_BIT = 0x8,	/* interface clear interrupt */
+	TNT_EOS_BIT = 0x10,	/* end of string */
+	TNT_NL_BIT = 0x20,	/* new line receive */
+	TNT_STBO_BIT = 0x40,	/* status byte out  */
+	TNT_NBA_BIT = 0x80,	/* new byte available */
+};
+
+/* ISR3 -- Interrupt Status Register 3 (read only) */
+enum isr3_bits {
+	HR_DONE = (1 << 0),	/* transfer done */
+	HR_TLCI = (1 << 1),	/* isr0, isr1, or isr2 interrupt asserted */
+	HR_NEF = (1 << 2),	/* NOT empty fifo */
+	HR_NFF = (1 << 3),	/* NOT full fifo */
+	HR_STOP = (1 << 4),	/* fifo empty or STOP command issued */
+	HR_SRQI_CIC = (1 << 5),	/* SRQ asserted and we are CIC (500x only?)*/
+	HR_INTR = (1 << 7),	/* isr3 interrupt active */
+};
+
+enum keyreg_bits {
+	MSTD = 0x20,	/* enable 350ns T1 delay */
+};
+
+/* STS1 -- Status Register 1 (read only) */
+enum sts1_bits {
+	S_DONE = 0x80,	/* DMA done			      */
+	S_SC = 0x40,	/* is system controller		      */
+	S_IN = 0x20,	/* DMA in (to memory)		      */
+	S_DRQ = 0x10,	/* DRQ line (for diagnostics)	      */
+	S_STOP = 0x08,	/* DMA stopped			      */
+	S_NDAV = 0x04,	/* inverse of DAV		      */
+	S_HALT = 0x02,	/* status of transfer machine	      */
+	S_GSYNC = 0x01,	/* indicates if GPIB is in sync w I/O */
+};
+
+/* STS2 -- Status Register 2 */
+enum sts2_bits {
+	AFFN = (1 << 3),	/* "A full FIFO NOT"  (0=FIFO full)  */
+	AEFN = (1 << 2),	/* "A empty FIFO NOT" (0=FIFO empty) */
+	BFFN = (1 << 1),	/* "B full FIFO NOT"  (0=FIFO full)  */
+	BEFN = (1 << 0),	/* "B empty FIFO NOT" (0=FIFO empty) */
+};
+
+// Auxiliary commands
+enum tnt4882_aux_cmds {
+	AUX_9914 = 0x15,	// switch to 9914 mode
+	AUX_REQT = 0x18,
+	AUX_REQF = 0x19,
+	AUX_PAGEIN = 0x50,	// page in alternate registers
+	AUX_HLDI = 0x51,	// rfd holdoff immediately
+	AUX_CLEAR_END = 0x55,
+	AUX_7210 = 0x99,	// switch to 7210 mode
+};
+
+enum tnt4882_aux_regs {
+	AUXRG = 0x40,
+	AUXRI = 0xe0,
+};
+
+enum auxg_bits {
+ /* no talking when no listeners bit (prevents bus errors when data written at wrong time) */
+	NTNL_BIT = 0x8,
+	RPP2_BIT = 0x4,	/* set/clear local rpp message */
+	CHES_BIT = 0x1, /*clear holdoff on end select bit*/
+};
+
+enum auxi_bits {
+	SISB = 0x1,	// static interrupt bits (don't clear isr1, isr2 on read)
+	PP2 = 0x4,	// ignore remote parallel poll configuration
+	USTD = 0x8,	// ultra short (1100 nanosec) T1 delay
+};
+
+enum sasr_bits {
+	ACRDY_BIT = 0x4,	/* acceptor ready state */
+	ADHS_BIT = 0x8,		/* acceptor data holdoff state */
+	ANHS2_BIT = 0x10,	/* acceptor not ready holdoff immediately state */
+	ANHS1_BIT = 0x20,	/* acceptor not ready holdoff state */
+	AEHS_BIT = 0x40,	/* acceptor end holdoff state */
+};
+
+#endif	// _TNT4882_REGISTERS_H