diff options
Diffstat (limited to 'Documentation/admin-guide/gpio/gpio-sim.rst')
| -rw-r--r-- | Documentation/admin-guide/gpio/gpio-sim.rst | 11 |
1 files changed, 7 insertions, 4 deletions
diff --git a/Documentation/admin-guide/gpio/gpio-sim.rst b/Documentation/admin-guide/gpio/gpio-sim.rst index d8a90c81b9ee..f5135a14ef2e 100644 --- a/Documentation/admin-guide/gpio/gpio-sim.rst +++ b/Documentation/admin-guide/gpio/gpio-sim.rst @@ -50,8 +50,11 @@ the number of lines exposed by this bank. **Attribute:** ``/config/gpio-sim/gpio-device/gpio-bankX/lineY/name`` -This group represents a single line at the offset Y. The 'name' attribute -allows to set the line name as represented by the 'gpio-line-names' property. +**Attribute:** ``/config/gpio-sim/gpio-device/gpio-bankX/lineY/valid`` + +This group represents a single line at the offset Y. The ``valid`` attribute +indicates whether the line can be used as GPIO. The ``name`` attribute allows +to set the line name as represented by the 'gpio-line-names' property. **Item:** ``/config/gpio-sim/gpio-device/gpio-bankX/lineY/hog`` @@ -71,7 +74,7 @@ specific lines. The name of those subdirectories must take the form of: ``'line<offset>'`` (e.g. ``'line0'``, ``'line20'``, etc.) as the name will be used by the module to assign the config to the specific line at given offset. -Once the confiuration is complete, the ``'live'`` attribute must be set to 1 in +Once the configuration is complete, the ``'live'`` attribute must be set to 1 in order to instantiate the chip. It can be set back to 0 to destroy the simulated chip. The module will synchronously wait for the new simulated device to be successfully probed and if this doesn't happen, writing to ``'live'`` will @@ -123,7 +126,7 @@ Each simulated GPIO chip creates a separate sysfs group under its device directory for each exposed line (e.g. ``/sys/devices/platform/gpio-sim.X/gpiochipY/``). The name of each group is of the form: ``'sim_gpioX'`` where X is the offset of the line. Inside each -group there are two attibutes: +group there are two attributes: ``pull`` - allows to read and set the current simulated pull setting for every line, when writing the value must be one of: ``'pull-up'``, |