diff options
Diffstat (limited to 'Documentation/admin-guide/quickly-build-trimmed-linux.rst')
| -rw-r--r-- | Documentation/admin-guide/quickly-build-trimmed-linux.rst | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/Documentation/admin-guide/quickly-build-trimmed-linux.rst b/Documentation/admin-guide/quickly-build-trimmed-linux.rst index f08149bc53f8..cb4b78468a93 100644 --- a/Documentation/admin-guide/quickly-build-trimmed-linux.rst +++ b/Documentation/admin-guide/quickly-build-trimmed-linux.rst @@ -273,7 +273,7 @@ again. does nothing at all; in that case you have to manually install your kernel, as outlined in the reference section. - If you are running a immutable Linux distribution, check its documentation + If you are running an immutable Linux distribution, check its documentation and the web to find out how to install your own kernel there. [:ref:`details<install>`] @@ -347,7 +347,7 @@ again. [:ref:`details<uninstall>`] -.. _submit_improvements: +.. _submit_improvements_qbtl: Did you run into trouble following any of the above steps that is not cleared up by the reference section below? Or do you have ideas how to improve the text? @@ -733,7 +733,7 @@ can easily happen that your self-built kernel will lack modules for tasks you did not perform before utilizing this make target. That's because those tasks require kernel modules that are normally autoloaded when you perform that task for the first time; if you didn't perform that task at least once before using -localmodonfig, the latter will thus assume these modules are superfluous and +localmodconfig, the latter will thus assume these modules are superfluous and disable them. You can try to avoid this by performing typical tasks that often will autoload @@ -884,7 +884,7 @@ When a build error occurs, it might be caused by some aspect of your machine's setup that often can be fixed quickly; other times though the problem lies in the code and can only be fixed by a developer. A close examination of the failure messages coupled with some research on the internet will often tell you -which of the two it is. To perform such a investigation, restart the build +which of the two it is. To perform such an investigation, restart the build process like this:: make V=1 @@ -1070,7 +1070,7 @@ complicated, and harder to follow. That being said: this of course is a balancing act. Hence, if you think an additional use-case is worth describing, suggest it to the maintainers of this -document, as :ref:`described above <submit_improvements>`. +document, as :ref:`described above <submit_improvements_qbtl>`. .. |