1 files changed, 0 insertions, 66 deletions
diff --git a/Documentation/devicetree/bindings/dma/ste-dma40.txt b/Documentation/devicetree/bindings/dma/ste-dma40.txt
deleted file mode 100644
index bea5b73a7390..000000000000
--- a/Documentation/devicetree/bindings/dma/ste-dma40.txt
+++ /dev/null
@@ -1,66 +0,0 @@
-* DMA40 DMA Controller
-
-Required properties:
-- compatible: "stericsson,dma40"
-- reg: Address range of the DMAC registers
-- reg-names: Names of the above areas to use during resource look-up
-- interrupt: Should contain the DMAC interrupt number
-- #dma-cells: must be <3>
-- memcpy-channels: Channels to be used for memcpy
-
-Optional properties:
-- dma-channels: Number of channels supported by hardware - if not present
-		the driver will attempt to obtain the information from H/W
-- disabled-channels: Channels which can not be used
-
-Example:
-
-	dma: dma-controller@801C0000 {
-		compatible = "stericsson,db8500-dma40", "stericsson,dma40";
-		reg = <0x801C0000 0x1000  0x40010000 0x800>;
-		reg-names = "base", "lcpa";
-		interrupt-parent = <&intc>;
-		interrupts = <0 25 0x4>;
-
-		#dma-cells = <2>;
-		memcpy-channels  = <56 57 58 59 60>;
-		disabled-channels  = <12>;
-		dma-channels = <8>;
-	};
-
-Clients
-Required properties:
-- dmas: Comma separated list of dma channel requests
-- dma-names: Names of the aforementioned requested channels
-
-Each dmas request consists of 4 cells:
-  1. A phandle pointing to the DMA controller
-  2. Device Type
-  3. The DMA request line number (only when 'use fixed channel' is set)
-  4. A 32bit mask specifying; mode, direction and endianess [NB: This list will grow]
-        0x00000001: Mode:
-                Logical channel when unset
-                Physical channel when set
-        0x00000002: Direction:
-                Memory to Device when unset
-                Device to Memory when set
-        0x00000004: Endianess:
-                Little endian when unset
-                Big endian when set
-        0x00000008: Use fixed channel:
-                Use automatic channel selection when unset
-                Use DMA request line number when set
-
-Example:
-
-	uart@80120000 {
-		compatible = "arm,pl011", "arm,primecell";
-		reg = <0x80120000 0x1000>;
-		interrupts = <0 11 0x4>;
-
-		dmas = <&dma 13 0 0x2>, /* Logical - DevToMem */
-		       <&dma 13 0 0x0>; /* Logical - MemToDev */
-		dma-names = "rx", "rx";
-
-		status = "disabled";
-	};