diff options
Diffstat (limited to 'Documentation/devicetree/bindings/net/ethernet-phy.yaml')
| -rw-r--r-- | Documentation/devicetree/bindings/net/ethernet-phy.yaml | 28 |
1 files changed, 24 insertions, 4 deletions
diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml index 2c71454ae8e3..bb4c49fc5fd8 100644 --- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml +++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml @@ -35,9 +35,13 @@ properties: description: PHYs that implement IEEE802.3 clause 45 - pattern: "^ethernet-phy-id[a-f0-9]{4}\\.[a-f0-9]{4}$" description: - If the PHY reports an incorrect ID (or none at all) then the - compatible list may contain an entry with the correct PHY ID - in the above form. + PHYs contain identification registers. These will be read to + identify the PHY. If the PHY reports an incorrect ID, or the + PHY requires a specific initialization sequence (like a + particular order of clocks, resets, power supplies), in + order to be able to read the ID registers, then the + compatible list must contain an entry with the correct PHY + ID in the above form. The first group of digits is the 16 bit Phy Identifier 1 register, this is the chip vendor OUI bits 3:18. The second group of digits is the Phy Identifier 2 register, @@ -232,6 +236,22 @@ properties: PHY's that have configurable TX internal delays. If this property is present then the PHY applies the TX delay. + tx-amplitude-100base-tx-percent: + description: + Transmit amplitude gain applied for 100BASE-TX. 100% matches 2V + peak-to-peak specified in ANSI X3.263. When omitted, the PHYs default + will be left as is. + + mac-termination-ohms: + maximum: 200 + description: + The xMII signals need series termination on the driver side to match both + the output driver impedance and the line characteristic impedance, to + prevent reflections and EMI problems. Select a resistance value which is + supported by the builtin resistors of the PHY, otherwise the resistors may + have to be placed on board. When omitted, the PHYs default will be left as + is. + leds: type: object @@ -250,7 +270,7 @@ properties: reg: maxItems: 1 description: - This define the LED index in the PHY or the MAC. It's really + This defines the LED index in the PHY or the MAC. It's really driver dependent and required for ports that define multiple LED for the same port. |