1 files changed, 1 insertions, 62 deletions
diff --git a/Documentation/devicetree/bindings/net/phy.txt b/Documentation/devicetree/bindings/net/phy.txt
index b55857696fc3..2399ee60caed 100644
--- a/Documentation/devicetree/bindings/net/phy.txt
+++ b/Documentation/devicetree/bindings/net/phy.txt
@@ -1,62 +1 @@
-PHY nodes
-
-Required properties:
-
- - interrupts : <a b> where a is the interrupt number and b is a
-   field that represents an encoding of the sense and level
-   information for the interrupt.  This should be encoded based on
-   the information in section 2) depending on the type of interrupt
-   controller you have.
- - interrupt-parent : the phandle for the interrupt controller that
-   services interrupts for this device.
- - reg : The ID number for the phy, usually a small integer
-
-Optional Properties:
-
-- compatible: Compatible list, may contain
-  "ethernet-phy-ieee802.3-c22" or "ethernet-phy-ieee802.3-c45" for
-  PHYs that implement IEEE802.3 clause 22 or IEEE802.3 clause 45
-  specifications. If neither of these are specified, the default is to
-  assume clause 22.
-
-  If the PHY reports an incorrect ID (or none at all) then the
-  "compatible" list may contain an entry with the correct PHY ID in the
-  form: "ethernet-phy-idAAAA.BBBB" where
-     AAAA - The value of the 16 bit Phy Identifier 1 register as
-            4 hex digits. This is the chip vendor OUI bits 3:18
-     BBBB - The value of the 16 bit Phy Identifier 2 register as
-            4 hex digits. This is the chip vendor OUI bits 19:24,
-            followed by 10 bits of a vendor specific ID.
-
-  The compatible list should not contain other values than those
-  listed here.
-
-- max-speed: Maximum PHY supported speed (10, 100, 1000...)
-
-- broken-turn-around: If set, indicates the PHY device does not correctly
-  release the turn around line low at the end of a MDIO transaction.
-
-- enet-phy-lane-swap: If set, indicates the PHY will swap the TX/RX lanes to
-  compensate for the board being designed with the lanes swapped.
-
-- enet-phy-lane-no-swap: If set, indicates that PHY will disable swap of the
-  TX/RX lanes. This property allows the PHY to work correcly after e.g. wrong
-  bootstrap configuration caused by issues in PCB layout design.
-
-- eee-broken-100tx:
-- eee-broken-1000t:
-- eee-broken-10gt:
-- eee-broken-1000kx:
-- eee-broken-10gkx4:
-- eee-broken-10gkr:
-  Mark the corresponding energy efficient ethernet mode as broken and
-  request the ethernet to stop advertising it.
-
-Example:
-
-ethernet-phy@0 {
-	compatible = "ethernet-phy-id0141.0e90", "ethernet-phy-ieee802.3-c22";
-	interrupt-parent = <40000>;
-	interrupts = <35 1>;
-	reg = <0>;
-};
+This file has moved to ethernet-phy.yaml.