diff options
Diffstat (limited to 'Documentation/devicetree/bindings/serial/serial.yaml')
-rw-r--r-- | Documentation/devicetree/bindings/serial/serial.yaml | 26 |
1 files changed, 3 insertions, 23 deletions
diff --git a/Documentation/devicetree/bindings/serial/serial.yaml b/Documentation/devicetree/bindings/serial/serial.yaml index ffc9198ae214..6aa9cfae417b 100644 --- a/Documentation/devicetree/bindings/serial/serial.yaml +++ b/Documentation/devicetree/bindings/serial/serial.yaml @@ -88,10 +88,12 @@ properties: TX FIFO threshold configuration (in bytes). patternProperties: - "^(bluetooth|bluetooth-gnss|gnss|gps|mcu|onewire)$": + "^(bluetooth|bluetooth-gnss|embedded-controller|gnss|gps|mcu|onewire)$": if: type: object then: + additionalProperties: true + $ref: serial-peripheral-props.yaml# description: Serial attached devices shall be a child node of the host UART device the slave device is attached to. It is expected that the attached @@ -103,28 +105,6 @@ patternProperties: description: Compatible of the device connected to the serial port. - max-speed: - $ref: /schemas/types.yaml#/definitions/uint32 - description: - The maximum baud rate the device operates at. - This should only be present if the maximum is less than the slave - device can support. For example, a particular board has some - signal quality issue or the host processor can't support higher - baud rates. - - current-speed: - $ref: /schemas/types.yaml#/definitions/uint32 - description: | - The current baud rate the device operates at. - This should only be present in case a driver has no chance to know - the baud rate of the slave device. - Examples: - * device supports auto-baud - * the rate is setup by a bootloader and there is no way to reset - the device - * device baud rate is configured by its firmware but there is no - way to request the actual settings - required: - compatible |