diff options
Diffstat (limited to 'Documentation/networking/bonding.rst')
| -rw-r--r-- | Documentation/networking/bonding.rst | 19 |
1 files changed, 15 insertions, 4 deletions
diff --git a/Documentation/networking/bonding.rst b/Documentation/networking/bonding.rst index e774b48de9f5..a4c1291d2561 100644 --- a/Documentation/networking/bonding.rst +++ b/Documentation/networking/bonding.rst @@ -1963,7 +1963,7 @@ obtain its hardware address from the first slave, which might not match the hardware address of the VLAN interfaces (which was ultimately copied from an earlier slave). -There are two methods to insure that the VLAN device operates +There are two methods to ensure that the VLAN device operates with the correct hardware address if all slaves are removed from a bond interface: @@ -2078,7 +2078,7 @@ as an unsolicited ARP reply (because ARP matches replies on an interface basis), and is discarded. The MII monitor is not affected by the state of the routing table. -The solution here is simply to insure that slaves do not have +The solution here is simply to ensure that slaves do not have routes of their own, and if for some reason they must, those routes do not supersede routes of their master. This should generally be the case, but unusual configurations or errant manual or automatic static @@ -2295,7 +2295,7 @@ active-backup: the switches have an ISL and play together well. If the network configuration is such that one switch is specifically a backup switch (e.g., has lower capacity, higher cost, etc), - then the primary option can be used to insure that the + then the primary option can be used to ensure that the preferred link is always used when it is available. broadcast: @@ -2322,7 +2322,7 @@ monitor can provide a higher level of reliability in detecting end to end connectivity failures (which may be caused by the failure of any individual component to pass traffic for any reason). Additionally, the ARP monitor should be configured with multiple targets (at least -one for each switch in the network). This will insure that, +one for each switch in the network). This will ensure that, regardless of which switch is active, the ARP monitor has a suitable target to query. @@ -2916,6 +2916,17 @@ from the bond (``ifenslave -d bond0 eth0``). The bonding driver will then restore the MAC addresses that the slaves had before they were enslaved. +9. What bonding modes support native XDP? +------------------------------------------ + + * balance-rr (0) + * active-backup (1) + * balance-xor (2) + * 802.3ad (4) + +Note that the vlan+srcmac hash policy does not support native XDP. +For other bonding modes, the XDP program must be loaded with generic mode. + 16. Resources and Links ======================= |