1 files changed, 68 insertions, 0 deletions
diff --git a/arch/arm64/boot/dts/broadcom/bcm2712-rpi-5-b.dts b/arch/arm64/boot/dts/broadcom/bcm2712-rpi-5-b.dts
new file mode 100644
index 000000000000..3e0319fdb93f
--- /dev/null
+++ b/arch/arm64/boot/dts/broadcom/bcm2712-rpi-5-b.dts
@@ -0,0 +1,68 @@
+// SPDX-License-Identifier: (GPL-2.0 OR MIT)
+/*
+ * bcm2712-rpi-5-b-ovl-rp1.dts is the overlay-ready DT which will make
+ * the RP1 driver to load the RP1 dtb overlay at runtime, while
+ * bcm2712-rpi-5-b.dts (this file) is the fully defined one (i.e. it
+ * already contains RP1 node, so no overlay is loaded nor needed).
+ * This file is intended to host the override nodes for the RP1 peripherals,
+ * e.g. to declare the phy of the ethernet interface or the custom pin setup
+ * for several RP1 peripherals.
+ * This in turn is due to the fact that there's no current generic
+ * infrastructure to reference nodes (i.e. the nodes in rp1-common.dtsi) that
+ * are not yet defined in the DT since they are loaded at runtime via overlay.
+ * All other nodes that do not have anything to do with RP1 should be added
+ * to the included bcm2712-rpi-5-b-ovl-rp1.dts instead.
+ */
+
+/dts-v1/;
+
+#include "bcm2712-rpi-5-b-ovl-rp1.dts"
+
+/ {
+	aliases {
+		ethernet0 = &rp1_eth;
+	};
+};
+
+&pcie2 {
+	#include "rp1-nexus.dtsi"
+};
+
+&rp1_eth {
+	assigned-clocks = <&rp1_clocks RP1_CLK_ETH_TSU>,
+			  <&rp1_clocks RP1_CLK_ETH>;
+	assigned-clock-rates = <50000000>,
+			       <125000000>;
+	status = "okay";
+	phy-mode = "rgmii-id";
+	phy-handle = <&phy1>;
+
+	mdio {
+		reg = <0x1>;
+		reset-gpios = <&rp1_gpio 32 GPIO_ACTIVE_LOW>;
+		reset-delay-us = <5000>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		phy1: ethernet-phy@1 {
+			reg = <0x1>;
+		};
+	};
+};
+
+&rp1_gpio {
+	usb_vbus_default_state: usb-vbus-default-state {
+		function = "vbus1";
+		groups = "vbus1";
+	};
+};
+
+&rp1_usb0 {
+	pinctrl-0 = <&usb_vbus_default_state>;
+	pinctrl-names = "default";
+	status = "okay";
+};
+
+&rp1_usb1 {
+	status = "okay";
+};