summaryrefslogtreecommitdiff
path: root/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
diff options
context:
space:
mode:
Diffstat (limited to 'arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts')
-rw-r--r--arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts287
1 files changed, 285 insertions, 2 deletions
diff --git a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
index 7a36c90ad4ec..5fbcd48f2e2d 100644
--- a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
+++ b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
@@ -1,6 +1,6 @@
// SPDX-License-Identifier: BSD-3-Clause
/*
- * Copyright (c) 2023 Qualcomm Innovation Center, Inc. All rights reserved.
+ * Copyright (c) 2023-2024 Qualcomm Innovation Center, Inc. All rights reserved.
*/
/dts-v1/;
@@ -9,6 +9,8 @@
#define PM7250B_SID 8
#define PM7250B_SID1 9
+#include <dt-bindings/iio/qcom,spmi-adc7-pmk8350.h>
+#include <dt-bindings/iio/qcom,spmi-adc7-pm7325.h>
#include <dt-bindings/leds/common.h>
#include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
#include <dt-bindings/regulator/qcom,rpmh-regulator.h>
@@ -34,6 +36,7 @@
aliases {
serial0 = &uart5;
+ serial1 = &uart7;
};
chosen {
@@ -174,6 +177,7 @@
#address-cells = <1>;
#size-cells = <0>;
+ orientation-gpios = <&tlmm 140 GPIO_ACTIVE_HIGH>;
connector@0 {
compatible = "usb-c-connector";
@@ -212,12 +216,107 @@
};
};
+ thermal-zones {
+ sdm-skin-thermal {
+ thermal-sensors = <&pmk8350_adc_tm 3>;
+
+ trips {
+ active-config0 {
+ temperature = <125000>;
+ hysteresis = <1000>;
+ type = "passive";
+ };
+ };
+ };
+
+ quiet-thermal {
+ thermal-sensors = <&pmk8350_adc_tm 1>;
+
+ trips {
+ active-config0 {
+ temperature = <125000>;
+ hysteresis = <1000>;
+ type = "passive";
+ };
+ };
+ };
+
+ xo-thermal {
+ thermal-sensors = <&pmk8350_adc_tm 0>;
+
+ trips {
+ active-config0 {
+ temperature = <125000>;
+ hysteresis = <1000>;
+ type = "passive";
+ };
+ };
+ };
+ };
+
vph_pwr: vph-pwr-regulator {
compatible = "regulator-fixed";
regulator-name = "vph_pwr";
regulator-min-microvolt = <3700000>;
regulator-max-microvolt = <3700000>;
};
+
+ wcn6750-pmu {
+ compatible = "qcom,wcn6750-pmu";
+ pinctrl-0 = <&bt_en>;
+ pinctrl-names = "default";
+ vddaon-supply = <&vreg_s7b_0p972>;
+ vddasd-supply = <&vreg_l11c_2p8>;
+ vddpmu-supply = <&vreg_s7b_0p972>;
+ vddrfa0p8-supply = <&vreg_s7b_0p972>;
+ vddrfa1p2-supply = <&vreg_s8b_1p272>;
+ vddrfa1p7-supply = <&vreg_s1b_1p872>;
+ vddrfa2p2-supply = <&vreg_s1c_2p19>;
+
+ bt-enable-gpios = <&tlmm 85 GPIO_ACTIVE_HIGH>;
+
+ regulators {
+ vreg_pmu_rfa_cmn: ldo0 {
+ regulator-name = "vreg_pmu_rfa_cmn";
+ };
+
+ vreg_pmu_aon_0p59: ldo1 {
+ regulator-name = "vreg_pmu_aon_0p59";
+ };
+
+ vreg_pmu_wlcx_0p8: ldo2 {
+ regulator-name = "vreg_pmu_wlcx_0p8";
+ };
+
+ vreg_pmu_wlmx_0p85: ldo3 {
+ regulator-name = "vreg_pmu_wlmx_0p85";
+ };
+
+ vreg_pmu_btcmx_0p85: ldo4 {
+ regulator-name = "vreg_pmu_btcmx_0p85";
+ };
+
+ vreg_pmu_rfa_0p8: ldo5 {
+ regulator-name = "vreg_pmu_rfa_0p8";
+ };
+
+ vreg_pmu_rfa_1p2: ldo6 {
+ regulator-name = "vreg_pmu_rfa_1p2";
+ };
+
+ vreg_pmu_rfa_1p7: ldo7 {
+ regulator-name = "vreg_pmu_rfa_1p7";
+ };
+
+ vreg_pmu_pcie_0p9: ldo8 {
+ regulator-name = "vreg_pmu_pcie_0p9";
+ };
+
+ vreg_pmu_pcie_1p8: ldo9 {
+ regulator-name = "vreg_pmu_pcie_1p8";
+ };
+ };
+ };
};
&apps_rsc {
@@ -745,6 +844,36 @@
};
};
+&pm7325_temp_alarm {
+ io-channels = <&pmk8350_vadc PM7325_ADC7_DIE_TEMP>;
+ io-channel-names = "thermal";
+};
+
+&pmk8350_adc_tm {
+ status = "okay";
+
+ xo-therm@0 {
+ reg = <0>;
+ io-channels = <&pmk8350_vadc PMK8350_ADC7_AMUX_THM1_100K_PU>;
+ qcom,ratiometric;
+ qcom,hw-settle-time-us = <200>;
+ };
+
+ quiet-therm@1 {
+ reg = <1>;
+ io-channels = <&pmk8350_vadc PM7325_ADC7_AMUX_THM1_100K_PU>;
+ qcom,ratiometric;
+ qcom,hw-settle-time-us = <200>;
+ };
+
+ sdm-skin-therm@3 {
+ reg = <3>;
+ io-channels = <&pmk8350_vadc PM7325_ADC7_AMUX_THM3_100K_PU>;
+ qcom,ratiometric;
+ qcom,hw-settle-time-us = <200>;
+ };
+};
+
&pm8350c_pwm {
nvmem = <&pmk8350_sdam_21>,
<&pmk8350_sdam_22>;
@@ -789,6 +918,44 @@
status = "okay";
};
+&pmk8350_vadc {
+ channel@3 {
+ reg = <PMK8350_ADC7_DIE_TEMP>;
+ label = "pmk8350_die_temp";
+ qcom,pre-scaling = <1 1>;
+ };
+
+ channel@44 {
+ reg = <PMK8350_ADC7_AMUX_THM1_100K_PU>;
+ label = "xo_therm";
+ qcom,hw-settle-time = <200>;
+ qcom,pre-scaling = <1 1>;
+ qcom,ratiometric;
+ };
+
+ channel@103 {
+ reg = <PM7325_ADC7_DIE_TEMP>;
+ label = "pm7325_die_temp";
+ qcom,pre-scaling = <1 1>;
+ };
+
+ channel@144 {
+ reg = <PM7325_ADC7_AMUX_THM1_100K_PU>;
+ qcom,ratiometric;
+ qcom,hw-settle-time = <200>;
+ qcom,pre-scaling = <1 1>;
+ label = "pm7325_quiet_therm";
+ };
+
+ channel@146 {
+ reg = <PM7325_ADC7_AMUX_THM3_100K_PU>;
+ qcom,ratiometric;
+ qcom,hw-settle-time = <200>;
+ qcom,pre-scaling = <1 1>;
+ label = "pm7325_sdm_skin_therm";
+ };
+};
+
&pon_pwrkey {
status = "okay";
};
@@ -799,6 +966,39 @@
status = "okay";
};
+&qup_uart7_cts {
+ /*
+ * Configure a bias-bus-hold on CTS to lower power
+ * usage when Bluetooth is turned off. Bus hold will
+ * maintain a low power state regardless of whether
+ * the Bluetooth module drives the pin in either
+ * direction or leaves the pin fully unpowered.
+ */
+ bias-bus-hold;
+};
+
+&qup_uart7_rts {
+ /* We'll drive RTS, so no pull */
+ drive-strength = <2>;
+ bias-disable;
+};
+
+&qup_uart7_rx {
+ /*
+ * Configure a pull-up on RX. This is needed to avoid
+ * garbage data when the TX pin of the Bluetooth module is
+ * in tri-state (module powered off or not driving the
+ * signal yet).
+ */
+ bias-pull-up;
+};
+
+&qup_uart7_tx {
+ /* We'll drive TX, so no pull */
+ drive-strength = <2>;
+ bias-disable;
+};
+
&qupv3_id_0 {
status = "okay";
};
@@ -842,12 +1042,90 @@
&tlmm {
gpio-reserved-ranges = <32 2>, /* ADSP */
<48 4>; /* NFC */
+
+ bt_en: bt-en-state {
+ pins = "gpio85";
+ function = "gpio";
+ output-low;
+ bias-disable;
+ };
+
+ qup_uart7_sleep_cts: qup-uart7-sleep-cts-state {
+ pins = "gpio28";
+ function = "gpio";
+ /*
+ * Configure a bias-bus-hold on CTS to lower power
+ * usage when Bluetooth is turned off. Bus hold will
+ * maintain a low power state regardless of whether
+ * the Bluetooth module drives the pin in either
+ * direction or leaves the pin fully unpowered.
+ */
+ bias-bus-hold;
+ };
+
+ qup_uart7_sleep_rts: qup-uart7-sleep-rts-state {
+ pins = "gpio29";
+ function = "gpio";
+ /*
+ * Configure pull-down on RTS. As RTS is active low
+ * signal, pull it low to indicate the BT SoC that it
+ * can wakeup the system anytime from suspend state by
+ * pulling RX low (by sending wakeup bytes).
+ */
+ bias-pull-down;
+ };
+
+ qup_uart7_sleep_rx: qup-uart7-sleep-rx-state {
+ pins = "gpio31";
+ function = "gpio";
+ /*
+ * Configure a pull-up on RX. This is needed to avoid
+ * garbage data when the TX pin of the Bluetooth module
+ * is floating which may cause spurious wakeups.
+ */
+ bias-pull-up;
+ };
+
+ qup_uart7_sleep_tx: qup-uart7-sleep-tx-state {
+ pins = "gpio30";
+ function = "gpio";
+ /*
+ * Configure pull-up on TX when it isn't actively driven
+ * to prevent BT SoC from receiving garbage during sleep.
+ */
+ bias-pull-up;
+ };
};
&uart5 {
status = "okay";
};
+&uart7 {
+ /delete-property/ interrupts;
+ interrupts-extended = <&intc GIC_SPI 608 IRQ_TYPE_LEVEL_HIGH>,
+ <&tlmm 31 IRQ_TYPE_EDGE_FALLING>;
+ pinctrl-1 = <&qup_uart7_sleep_cts>,
+ <&qup_uart7_sleep_rts>,
+ <&qup_uart7_sleep_tx>,
+ <&qup_uart7_sleep_rx>;
+ pinctrl-names = "default",
+ "sleep";
+
+ status = "okay";
+
+ bluetooth: bluetooth {
+ compatible = "qcom,wcn6750-bt";
+ vddrfacmn-supply = <&vreg_pmu_rfa_cmn>;
+ vddaon-supply = <&vreg_pmu_aon_0p59>;
+ vddbtcmx-supply = <&vreg_pmu_btcmx_0p85>;
+ vddrfa0p8-supply = <&vreg_pmu_rfa_0p8>;
+ vddrfa1p7-supply = <&vreg_pmu_rfa_1p7>;
+ vddrfa1p2-supply = <&vreg_pmu_rfa_1p2>;
+ max-speed = <3200000>;
+ };
+};
+
&usb_1 {
status = "okay";
};
@@ -919,7 +1197,7 @@
&wifi {
memory-region = <&wlan_fw_mem>;
- qcom,ath11k-calibration-variant = "Qualcomm_rb3gen2";
+ qcom,calibration-variant = "Qualcomm_rb3gen2";
status = "okay";
};
@@ -986,3 +1264,8 @@
bias-pull-up;
};
};
+
+&lpass_audiocc {
+ compatible = "qcom,qcm6490-lpassaudiocc";
+ /delete-property/ power-domains;
+};
generated by cgit (git 2.34.1) at 2025-07-24 09:11:09 +0000