diff options
Diffstat (limited to 'drivers/iio/accel/bmc150-accel.h')
| -rw-r--r-- | drivers/iio/accel/bmc150-accel.h | 26 |
1 files changed, 23 insertions, 3 deletions
diff --git a/drivers/iio/accel/bmc150-accel.h b/drivers/iio/accel/bmc150-accel.h index 47121f070fe9..e8f26198359f 100644 --- a/drivers/iio/accel/bmc150-accel.h +++ b/drivers/iio/accel/bmc150-accel.h @@ -6,6 +6,7 @@ #include <linux/iio/iio.h> #include <linux/mutex.h> #include <linux/regulator/consumer.h> +#include <linux/types.h> #include <linux/workqueue.h> struct regmap; @@ -13,6 +14,22 @@ struct i2c_client; struct bmc150_accel_chip_info; struct bmc150_accel_interrupt_info; +/* + * We can often guess better than "UNKNOWN" based on the device IDs + * but unfortunately this information is not always accurate. There are some + * devices where ACPI firmware specifies an ID like "BMA250E" when the device + * actually has a BMA222E. The driver attempts to detect those by reading the + * chip ID from the registers but this information is not always enough either. + * + * Therefore, this enum should be only used when the chip ID detection is not + * enough and we can be reasonably sure that the device IDs are reliable + * in practice (e.g. for device tree platforms). + */ +enum bmc150_type { + BOSCH_UNKNOWN, + BOSCH_BMC156, +}; + struct bmc150_accel_interrupt { const struct bmc150_accel_interrupt_info *info; atomic_t users; @@ -41,6 +58,7 @@ enum bmc150_accel_trigger_id { struct bmc150_accel_data { struct regmap *regmap; + int irq; struct regulator_bulk_data regulators[2]; struct bmc150_accel_interrupt interrupts[BMC150_ACCEL_INTERRUPTS]; struct bmc150_accel_trigger triggers[BMC150_ACCEL_TRIGGERS]; @@ -53,7 +71,7 @@ struct bmc150_accel_data { */ struct { __le16 channels[3]; - s64 ts __aligned(8); + aligned_s64 ts; } scan; u8 bw_bits; u32 slope_dur; @@ -62,6 +80,7 @@ struct bmc150_accel_data { int ev_enable_state; int64_t timestamp, old_timestamp; /* Only used in hw fifo mode. */ const struct bmc150_accel_chip_info *chip_info; + enum bmc150_type type; struct i2c_client *second_device; void (*resume_callback)(struct device *dev); struct delayed_work resume_work; @@ -69,8 +88,9 @@ struct bmc150_accel_data { }; int bmc150_accel_core_probe(struct device *dev, struct regmap *regmap, int irq, - const char *name, bool block_supported); -int bmc150_accel_core_remove(struct device *dev); + enum bmc150_type type, const char *name, + bool block_supported); +void bmc150_accel_core_remove(struct device *dev); extern const struct dev_pm_ops bmc150_accel_pm_ops; extern const struct regmap_config bmc150_regmap_conf; |