diff options
Diffstat (limited to 'drivers/media/usb/em28xx/em28xx-reg.h')
| -rw-r--r-- | drivers/media/usb/em28xx/em28xx-reg.h | 100 |
1 files changed, 69 insertions, 31 deletions
diff --git a/drivers/media/usb/em28xx/em28xx-reg.h b/drivers/media/usb/em28xx/em28xx-reg.h index 0e0477847965..d7c60862874a 100644 --- a/drivers/media/usb/em28xx/em28xx-reg.h +++ b/drivers/media/usb/em28xx/em28xx-reg.h @@ -1,16 +1,22 @@ -#define EM_GPIO_0 (1 << 0) -#define EM_GPIO_1 (1 << 1) -#define EM_GPIO_2 (1 << 2) -#define EM_GPIO_3 (1 << 3) -#define EM_GPIO_4 (1 << 4) -#define EM_GPIO_5 (1 << 5) -#define EM_GPIO_6 (1 << 6) -#define EM_GPIO_7 (1 << 7) - -#define EM_GPO_0 (1 << 0) -#define EM_GPO_1 (1 << 1) -#define EM_GPO_2 (1 << 2) -#define EM_GPO_3 (1 << 3) +/* SPDX-License-Identifier: GPL-2.0 */ + +/* + * em28xx-reg.h - Register definitions for em28xx driver + */ + +#define EM_GPIO_0 ((unsigned char)BIT(0)) +#define EM_GPIO_1 ((unsigned char)BIT(1)) +#define EM_GPIO_2 ((unsigned char)BIT(2)) +#define EM_GPIO_3 ((unsigned char)BIT(3)) +#define EM_GPIO_4 ((unsigned char)BIT(4)) +#define EM_GPIO_5 ((unsigned char)BIT(5)) +#define EM_GPIO_6 ((unsigned char)BIT(6)) +#define EM_GPIO_7 ((unsigned char)BIT(7)) + +#define EM_GPO_0 ((unsigned char)BIT(0)) +#define EM_GPO_1 ((unsigned char)BIT(1)) +#define EM_GPO_2 ((unsigned char)BIT(2)) +#define EM_GPO_3 ((unsigned char)BIT(3)) /* em28xx endpoints */ /* 0x82: (always ?) analog */ @@ -25,10 +31,12 @@ #define EM28XX_R00_CHIPCFG 0x00 /* em28xx Chip Configuration 0x00 */ -#define EM28XX_CHIPCFG_VENDOR_AUDIO 0x80 -#define EM28XX_CHIPCFG_I2S_VOLUME_CAPABLE 0x40 -#define EM28XX_CHIPCFG_I2S_5_SAMPRATES 0x30 -#define EM28XX_CHIPCFG_I2S_3_SAMPRATES 0x20 +#define EM2860_CHIPCFG_VENDOR_AUDIO 0x80 +#define EM2860_CHIPCFG_I2S_VOLUME_CAPABLE 0x40 +#define EM2820_CHIPCFG_I2S_3_SAMPRATES 0x30 +#define EM2860_CHIPCFG_I2S_5_SAMPRATES 0x30 +#define EM2820_CHIPCFG_I2S_1_SAMPRATE 0x20 +#define EM2860_CHIPCFG_I2S_3_SAMPRATES 0x20 #define EM28XX_CHIPCFG_AC97 0x10 #define EM28XX_CHIPCFG_AUDIOMASK 0x30 @@ -47,7 +55,6 @@ #define EM28XX_CHIPCFG2_TS_PACKETSIZE_564 0x02 #define EM28XX_CHIPCFG2_TS_PACKETSIZE_752 0x03 - /* GPIO/GPO registers */ #define EM2880_R04_GPO 0x04 /* em2880-em2883 only */ #define EM2820_R08_GPIO_CTRL 0x08 /* em2820-em2873/83 only */ @@ -60,13 +67,12 @@ #define EM28XX_I2C_CLK_WAIT_ENABLE 0x40 #define EM28XX_I2C_EEPROM_ON_BOARD 0x08 #define EM28XX_I2C_EEPROM_KEY_VALID 0x04 -#define EM2874_I2C_SECONDARY_BUS_SELECT 0x04 /* em2874 has two i2c busses */ +#define EM2874_I2C_SECONDARY_BUS_SELECT 0x04 /* em2874 has two i2c buses */ #define EM28XX_I2C_FREQ_1_5_MHZ 0x03 /* bus frequency (bits [1-0]) */ #define EM28XX_I2C_FREQ_25_KHZ 0x02 #define EM28XX_I2C_FREQ_400_KHZ 0x01 #define EM28XX_I2C_FREQ_100_KHZ 0x00 - #define EM28XX_R0A_CHIPID 0x0a #define EM28XX_R0C_USBSUSP 0x0c #define EM28XX_R0C_USBSUSP_SNAPSHOT 0x20 /* 1=button pressed, needs reset */ @@ -93,6 +99,24 @@ #define EM28XX_XCLK_FREQUENCY_24MHZ 0x0b #define EM28XX_R10_VINMODE 0x10 + /* used by all non-camera devices: */ +#define EM28XX_VINMODE_YUV422_CbYCrY 0x10 + /* used by camera devices: */ +#define EM28XX_VINMODE_YUV422_YUYV 0x08 +#define EM28XX_VINMODE_YUV422_YVYU 0x09 +#define EM28XX_VINMODE_YUV422_UYVY 0x0a +#define EM28XX_VINMODE_YUV422_VYUY 0x0b +#define EM28XX_VINMODE_RGB8_BGGR 0x0c +#define EM28XX_VINMODE_RGB8_GRBG 0x0d +#define EM28XX_VINMODE_RGB8_GBRG 0x0e +#define EM28XX_VINMODE_RGB8_RGGB 0x0f + /* + * apparently: + * bit 0: swap component 1+2 with 3+4 + * => e.g.: YUYV => YVYU, BGGR => GRBG + * bit 1: swap component 1 with 2 and 3 with 4 + * => e.g.: YUYV => UYVY, BGGR => GBRG + */ #define EM28XX_R11_VINCTRL 0x11 @@ -155,7 +179,6 @@ #define EM28XX_OUTFMT_YUV422_Y1UY0V 0x15 #define EM28XX_OUTFMT_YUV411 0x18 - #define EM28XX_R28_XMIN 0x28 #define EM28XX_R29_XMAX 0x29 #define EM28XX_R2A_YMIN 0x2a @@ -185,15 +208,29 @@ #define EM28XX_R43_AC97BUSY 0x43 #define EM28XX_R45_IR 0x45 - /* 0x45 bit 7 - parity bit - bits 6-0 - count - 0x46 IR brand - 0x47 IR data + /* + * 0x45 bit 7 - parity bit + * bits 6-0 - count + * 0x46 IR brand + * 0x47 IR data */ /* em2874 registers */ #define EM2874_R50_IR_CONFIG 0x50 #define EM2874_R51_IR 0x51 +#define EM2874_R5D_TS1_PKT_SIZE 0x5d +#define EM2874_R5E_TS2_PKT_SIZE 0x5e + /* + * For both TS1 and TS2, In isochronous mode: + * 0x01 188 bytes + * 0x02 376 bytes + * 0x03 564 bytes + * 0x04 752 bytes + * 0x05 940 bytes + * In bulk mode: + * 0x01..0xff total packet count in 188-byte + */ + #define EM2874_R5F_TS_ENABLE 0x5f /* em2874/174/84, em25xx, em276x/7x/8x GPIO registers */ @@ -218,12 +255,12 @@ #define EM2874_IR_RC6_MODE_6A 0x0b /* em2874 Transport Stream Enable Register (0x5f) */ -#define EM2874_TS1_CAPTURE_ENABLE (1 << 0) -#define EM2874_TS1_FILTER_ENABLE (1 << 1) -#define EM2874_TS1_NULL_DISCARD (1 << 2) -#define EM2874_TS2_CAPTURE_ENABLE (1 << 4) -#define EM2874_TS2_FILTER_ENABLE (1 << 5) -#define EM2874_TS2_NULL_DISCARD (1 << 6) +#define EM2874_TS1_CAPTURE_ENABLE ((unsigned char)BIT(0)) +#define EM2874_TS1_FILTER_ENABLE ((unsigned char)BIT(1)) +#define EM2874_TS1_NULL_DISCARD ((unsigned char)BIT(2)) +#define EM2874_TS2_CAPTURE_ENABLE ((unsigned char)BIT(4)) +#define EM2874_TS2_FILTER_ENABLE ((unsigned char)BIT(5)) +#define EM2874_TS2_NULL_DISCARD ((unsigned char)BIT(6)) /* register settings */ #define EM2800_AUDIO_SRC_TUNER 0x0d @@ -245,6 +282,7 @@ enum em28xx_chip_id { CHIP_ID_EM2874 = 65, CHIP_ID_EM2884 = 68, CHIP_ID_EM28174 = 113, + CHIP_ID_EM28178 = 114, }; /* |