diff options
Diffstat (limited to 'drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c')
| -rw-r--r-- | drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c | 17 |
1 files changed, 2 insertions, 15 deletions
diff --git a/drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c b/drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c index b9f135297aa0..47dc3efcee92 100644 --- a/drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c +++ b/drivers/mtd/nand/raw/ingenic/ingenic_nand_drv.c @@ -13,7 +13,6 @@ #include <linux/module.h> #include <linux/of.h> #include <linux/of_address.h> -#include <linux/of_device.h> #include <linux/gpio/consumer.h> #include <linux/platform_device.h> #include <linux/slab.h> @@ -47,7 +46,7 @@ struct ingenic_nfc { struct nand_controller controller; unsigned int num_banks; struct list_head chips; - struct ingenic_nand_cs cs[]; + struct ingenic_nand_cs cs[] __counted_by(num_banks); }; struct ingenic_nand { @@ -381,18 +380,6 @@ static int ingenic_nand_init_chip(struct platform_device *pdev, return ret; } - /* - * The rb-gpios semantics was undocumented and qi,lb60 (along with - * the ingenic driver) got it wrong. The active state encodes the - * NAND ready state, which is high level. Since there's no signal - * inverter on this board, it should be active-high. Let's fix that - * here for older DTs so we can re-use the generic nand_gpio_waitrdy() - * helper, and be consistent with what other drivers do. - */ - if (of_machine_is_compatible("qi,lb60") && - gpiod_is_active_low(nand->busy_gpio)) - gpiod_toggle_active_low(nand->busy_gpio); - nand->wp_gpio = devm_gpiod_get_optional(dev, "wp", GPIOD_OUT_LOW); if (IS_ERR(nand->wp_gpio)) { @@ -562,7 +549,7 @@ MODULE_DEVICE_TABLE(of, ingenic_nand_dt_match); static struct platform_driver ingenic_nand_driver = { .probe = ingenic_nand_probe, - .remove_new = ingenic_nand_remove, + .remove = ingenic_nand_remove, .driver = { .name = DRV_NAME, .of_match_table = ingenic_nand_dt_match, |