diff options
Diffstat (limited to 'drivers/net/dsa/microchip/ksz_common.h')
| -rw-r--r-- | drivers/net/dsa/microchip/ksz_common.h | 145 |
1 files changed, 132 insertions, 13 deletions
diff --git a/drivers/net/dsa/microchip/ksz_common.h b/drivers/net/dsa/microchip/ksz_common.h index 40c11b0d6b62..af17a9c030d4 100644 --- a/drivers/net/dsa/microchip/ksz_common.h +++ b/drivers/net/dsa/microchip/ksz_common.h @@ -1,7 +1,7 @@ /* SPDX-License-Identifier: GPL-2.0 */ /* Microchip switch driver common header * - * Copyright (C) 2017-2019 Microchip Technology Inc. + * Copyright (C) 2017-2024 Microchip Technology Inc. */ #ifndef __KSZ_COMMON_H @@ -19,9 +19,14 @@ #include "ksz_ptp.h" #define KSZ_MAX_NUM_PORTS 8 +/* all KSZ switches count ports from 1 */ +#define KSZ_PORT_1 0 +#define KSZ_PORT_2 1 +#define KSZ_PORT_4 3 struct ksz_device; struct ksz_port; +struct phylink_mac_ops; enum ksz_regmap_width { KSZ_REGMAP_8, @@ -58,9 +63,17 @@ struct ksz_chip_data { int port_cnt; u8 port_nirqs; u8 num_tx_queues; + u8 num_ipms; /* number of Internal Priority Maps */ bool tc_cbs_supported; - bool tc_ets_supported; + + /** + * @phy_side_mdio_supported: Indicates if the chip supports an additional + * side MDIO channel for accessing integrated PHYs. + */ + bool phy_side_mdio_supported; const struct ksz_dev_ops *ops; + const struct phylink_mac_ops *phylink_mac_ops; + bool phy_errata_9477; bool ksz87xx_eee_link_erratum; const struct ksz_mib_names *mib_names; int mib_cnt; @@ -79,6 +92,7 @@ struct ksz_chip_data { bool supports_rgmii[KSZ_MAX_NUM_PORTS]; bool internal_phy[KSZ_MAX_NUM_PORTS]; bool gbit_capable[KSZ_MAX_NUM_PORTS]; + bool ptp_capable; const struct regmap_access_table *wr_table; const struct regmap_access_table *rd_table; }; @@ -167,6 +181,7 @@ struct ksz_device { bool synclko_125; bool synclko_disable; bool wakeup_source; + bool pme_active_high; struct vlan_table *vlan_cache; @@ -183,6 +198,22 @@ struct ksz_device { struct ksz_switch_macaddr *switch_macaddr; struct net_device *hsr_dev; /* HSR */ u8 hsr_ports; + + /** + * @phy_addr_map: Array mapping switch ports to their corresponding PHY + * addresses. + */ + u8 phy_addr_map[KSZ_MAX_NUM_PORTS]; + + /** + * @parent_mdio_bus: Pointer to the external MDIO bus controller. + * + * This points to an external MDIO bus controller that is used to access + * the PHYs integrated within the switch. Unlike an integrated MDIO + * bus, this external controller provides a direct path for managing + * the switch’s internal PHYs, bypassing the main SPI interface. + */ + struct mii_bus *parent_mdio_bus; }; /* List of supported models */ @@ -192,7 +223,9 @@ enum ksz_model { KSZ8795, KSZ8794, KSZ8765, - KSZ8830, + KSZ88X3, + KSZ8864, + KSZ8895, KSZ9477, KSZ9896, KSZ9897, @@ -204,6 +237,7 @@ enum ksz_model { LAN9372, LAN9373, LAN9374, + LAN9646, }; enum ksz_regs { @@ -228,6 +262,9 @@ enum ksz_regs { S_MULTICAST_CTRL, P_XMII_CTRL_0, P_XMII_CTRL_1, + REG_SW_PME_CTRL, + REG_PORT_PME_STATUS, + REG_PORT_PME_CTRL, }; enum ksz_masks { @@ -313,6 +350,43 @@ struct ksz_dev_ops { void (*port_cleanup)(struct ksz_device *dev, int port); void (*port_setup)(struct ksz_device *dev, int port, bool cpu_port); int (*set_ageing_time)(struct ksz_device *dev, unsigned int msecs); + + /** + * @mdio_bus_preinit: Function pointer to pre-initialize the MDIO bus + * for accessing PHYs. + * @dev: Pointer to device structure. + * @side_mdio: Boolean indicating if the PHYs are accessed over a side + * MDIO bus. + * + * This function pointer is used to configure the MDIO bus for PHY + * access before initiating regular PHY operations. It enables either + * SPI/I2C or side MDIO access modes by unlocking necessary registers + * and setting up access permissions for the selected mode. + * + * Return: + * - 0 on success. + * - Negative error code on failure. + */ + int (*mdio_bus_preinit)(struct ksz_device *dev, bool side_mdio); + + /** + * @create_phy_addr_map: Function pointer to create a port-to-PHY + * address map. + * @dev: Pointer to device structure. + * @side_mdio: Boolean indicating if the PHYs are accessed over a side + * MDIO bus. + * + * This function pointer is responsible for mapping switch ports to PHY + * addresses according to the configured access mode (SPI or side MDIO) + * and the device’s strap configuration. The mapping setup may vary + * depending on the chip variant and configuration. Ensures the correct + * address mapping for PHY communication. + * + * Return: + * - 0 on success. + * - Negative error code on failure (e.g., invalid configuration). + */ + int (*create_phy_addr_map)(struct ksz_device *dev, bool side_mdio); int (*r_phy)(struct ksz_device *dev, u16 phy, u16 reg, u16 *val); int (*w_phy)(struct ksz_device *dev, u16 phy, u16 reg, u16 val); void (*r_mib_cnt)(struct ksz_device *dev, int port, u16 addr, @@ -347,11 +421,13 @@ struct ksz_dev_ops { void (*get_caps)(struct ksz_device *dev, int port, struct phylink_config *config); int (*change_mtu)(struct ksz_device *dev, int port, int mtu); + int (*pme_write8)(struct ksz_device *dev, u32 reg, u8 value); + int (*pme_pread8)(struct ksz_device *dev, int port, int offset, + u8 *data); + int (*pme_pwrite8)(struct ksz_device *dev, int port, int offset, + u8 data); void (*freeze_mib)(struct ksz_device *dev, int port, bool freeze); void (*port_init_cnt)(struct ksz_device *dev, int port); - void (*phylink_mac_config)(struct ksz_device *dev, int port, - unsigned int mode, - const struct phylink_link_state *state); void (*phylink_mac_link_up)(struct ksz_device *dev, int port, unsigned int mode, phy_interface_t interface, @@ -359,11 +435,6 @@ struct ksz_dev_ops { int duplex, bool tx_pause, bool rx_pause); void (*setup_rgmii_delay)(struct ksz_device *dev, int port); int (*tc_cbs_set_cinc)(struct ksz_device *dev, int port, u32 val); - void (*get_wol)(struct ksz_device *dev, int port, - struct ethtool_wolinfo *wol); - int (*set_wol)(struct ksz_device *dev, int port, - struct ethtool_wolinfo *wol); - void (*wol_pre_shutdown)(struct ksz_device *dev, bool *wol_enabled); void (*config_cpu_port)(struct dsa_switch *ds); int (*enable_stp_addr)(struct ksz_device *dev); int (*reset)(struct ksz_device *dev); @@ -374,6 +445,8 @@ struct ksz_dev_ops { struct ksz_device *ksz_switch_alloc(struct device *base, void *priv); int ksz_switch_register(struct ksz_device *dev); void ksz_switch_remove(struct ksz_device *dev); +int ksz_switch_suspend(struct device *dev); +int ksz_switch_resume(struct device *dev); void ksz_init_mib_timer(struct ksz_device *dev); bool ksz_is_port_mac_global_usable(struct dsa_switch *ds, int port); @@ -387,6 +460,7 @@ int ksz_switch_macaddr_get(struct dsa_switch *ds, int port, struct netlink_ext_ack *extack); void ksz_switch_macaddr_put(struct dsa_switch *ds); void ksz_switch_shutdown(struct ksz_device *dev); +int ksz_handle_wake_reason(struct ksz_device *dev, int port); /* Common register access functions */ static inline struct regmap *ksz_regmap_8(struct ksz_device *dev) @@ -617,7 +691,29 @@ static inline bool ksz_is_ksz87xx(struct ksz_device *dev) static inline bool ksz_is_ksz88x3(struct ksz_device *dev) { - return dev->chip_id == KSZ8830_CHIP_ID; + return dev->chip_id == KSZ88X3_CHIP_ID; +} + +static inline bool ksz_is_8895_family(struct ksz_device *dev) +{ + return dev->chip_id == KSZ8895_CHIP_ID || + dev->chip_id == KSZ8864_CHIP_ID; +} + +static inline bool is_ksz8(struct ksz_device *dev) +{ + return ksz_is_ksz87xx(dev) || ksz_is_ksz88x3(dev) || + ksz_is_8895_family(dev); +} + +static inline bool is_ksz88xx(struct ksz_device *dev) +{ + return ksz_is_ksz88x3(dev) || ksz_is_8895_family(dev); +} + +static inline bool is_ksz9477(struct ksz_device *dev) +{ + return dev->chip_id == KSZ9477_CHIP_ID; } static inline int is_lan937x(struct ksz_device *dev) @@ -629,6 +725,12 @@ static inline int is_lan937x(struct ksz_device *dev) dev->chip_id == LAN9374_CHIP_ID; } +static inline bool is_lan937x_tx_phy(struct ksz_device *dev, int port) +{ + return (dev->chip_id == LAN9371_CHIP_ID || + dev->chip_id == LAN9372_CHIP_ID) && port == KSZ_PORT_4; +} + /* STP State Defines */ #define PORT_TX_ENABLE BIT(2) #define PORT_RX_ENABLE BIT(1) @@ -640,6 +742,7 @@ static inline int is_lan937x(struct ksz_device *dev) #define SW_FAMILY_ID_M GENMASK(15, 8) #define KSZ87_FAMILY_ID 0x87 #define KSZ88_FAMILY_ID 0x88 +#define KSZ8895_FAMILY_ID 0x95 #define KSZ8_PORT_STATUS_0 0x08 #define KSZ8_PORT_FIBER_MODE BIT(7) @@ -648,6 +751,12 @@ static inline int is_lan937x(struct ksz_device *dev) #define KSZ87_CHIP_ID_94 0x6 #define KSZ87_CHIP_ID_95 0x9 #define KSZ88_CHIP_ID_63 0x3 +#define KSZ8895_CHIP_ID_95 0x4 +#define KSZ8895_CHIP_ID_95R 0x6 + +/* KSZ8895 specific register */ +#define REG_KSZ8864_CHIP_ID 0xFE +#define SW_KSZ8864 BIT(7) #define SW_REV_ID_M GENMASK(7, 4) @@ -680,6 +789,17 @@ static inline int is_lan937x(struct ksz_device *dev) #define P_MII_MAC_MODE BIT(2) #define P_MII_SEL_M 0x3 +/* KSZ9477, KSZ87xx Wake-on-LAN (WoL) masks */ +#define PME_WOL_MAGICPKT BIT(2) +#define PME_WOL_LINKUP BIT(1) +#define PME_WOL_ENERGY BIT(0) + +#define PME_ENABLE BIT(1) +#define PME_POLARITY BIT(0) + +#define KSZ87XX_REG_INT_EN 0x7D +#define KSZ87XX_INT_PME_MASK BIT(4) + /* Interrupt */ #define REG_SW_PORT_INT_STATUS__1 0x001B #define REG_SW_PORT_INT_MASK__1 0x001F @@ -722,7 +842,6 @@ static inline int is_lan937x(struct ksz_device *dev) #define KSZ9477_PORT_MRI_TC_MAP__4 0x0808 #define KSZ9477_PORT_TC_MAP_S 4 -#define KSZ9477_MAX_TC_PRIO 7 /* CBS related registers */ #define REG_PORT_MTI_QUEUE_INDEX__4 0x0900 |