diff options
Diffstat (limited to 'drivers/net/ethernet/broadcom')
| -rw-r--r-- | drivers/net/ethernet/broadcom/genet/bcmgenet.c | 35 | ||||
| -rw-r--r-- | drivers/net/ethernet/broadcom/genet/bcmgenet.h | 2 | ||||
| -rw-r--r-- | drivers/net/ethernet/broadcom/genet/bcmmii.c | 145 |
3 files changed, 110 insertions, 72 deletions
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c index 0f138280315a..1de51811fcb4 100644 --- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c +++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c @@ -1996,8 +1996,6 @@ static void reset_umac(struct bcmgenet_priv *priv) /* issue soft reset with (rg)mii loopback to ensure a stable rxclk */ bcmgenet_umac_writel(priv, CMD_SW_RESET | CMD_LCL_LOOP_EN, UMAC_CMD); - udelay(2); - bcmgenet_umac_writel(priv, 0, UMAC_CMD); } static void bcmgenet_intr_disable(struct bcmgenet_priv *priv) @@ -2614,8 +2612,10 @@ static void bcmgenet_irq_task(struct work_struct *work) spin_unlock_irq(&priv->lock); if (status & UMAC_IRQ_PHY_DET_R && - priv->dev->phydev->autoneg != AUTONEG_ENABLE) + priv->dev->phydev->autoneg != AUTONEG_ENABLE) { phy_init_hw(priv->dev->phydev); + genphy_config_aneg(priv->dev->phydev); + } /* Link UP/DOWN event */ if (status & UMAC_IRQ_LINK_EVENT) @@ -2879,12 +2879,6 @@ static int bcmgenet_open(struct net_device *dev) if (priv->internal_phy) bcmgenet_power_up(priv, GENET_POWER_PASSIVE); - ret = bcmgenet_mii_connect(dev); - if (ret) { - netdev_err(dev, "failed to connect to PHY\n"); - goto err_clk_disable; - } - /* take MAC out of reset */ bcmgenet_umac_reset(priv); @@ -2894,12 +2888,6 @@ static int bcmgenet_open(struct net_device *dev) reg = bcmgenet_umac_readl(priv, UMAC_CMD); priv->crc_fwd_en = !!(reg & CMD_CRC_FWD); - ret = bcmgenet_mii_config(dev, true); - if (ret) { - netdev_err(dev, "unsupported PHY\n"); - goto err_disconnect_phy; - } - bcmgenet_set_hw_addr(priv, dev->dev_addr); if (priv->internal_phy) { @@ -2915,7 +2903,7 @@ static int bcmgenet_open(struct net_device *dev) ret = bcmgenet_init_dma(priv); if (ret) { netdev_err(dev, "failed to initialize DMA\n"); - goto err_disconnect_phy; + goto err_clk_disable; } /* Always enable ring 16 - descriptor ring */ @@ -2938,19 +2926,25 @@ static int bcmgenet_open(struct net_device *dev) goto err_irq0; } + ret = bcmgenet_mii_probe(dev); + if (ret) { + netdev_err(dev, "failed to connect to PHY\n"); + goto err_irq1; + } + bcmgenet_netif_start(dev); netif_tx_start_all_queues(dev); return 0; +err_irq1: + free_irq(priv->irq1, priv); err_irq0: free_irq(priv->irq0, priv); err_fini_dma: bcmgenet_dma_teardown(priv); bcmgenet_fini_dma(priv); -err_disconnect_phy: - phy_disconnect(dev->phydev); err_clk_disable: if (priv->internal_phy) bcmgenet_power_down(priv, GENET_POWER_PASSIVE); @@ -3631,8 +3625,6 @@ static int bcmgenet_resume(struct device *d) if (priv->internal_phy) bcmgenet_power_up(priv, GENET_POWER_PASSIVE); - phy_init_hw(dev->phydev); - bcmgenet_umac_reset(priv); init_umac(priv); @@ -3641,7 +3633,10 @@ static int bcmgenet_resume(struct device *d) if (priv->wolopts) clk_disable_unprepare(priv->clk_wol); + phy_init_hw(dev->phydev); + /* Speed settings must be restored */ + genphy_config_aneg(dev->phydev); bcmgenet_mii_config(priv->dev, false); bcmgenet_set_hw_addr(priv, dev->dev_addr); diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.h b/drivers/net/ethernet/broadcom/genet/bcmgenet.h index 7fbf573d8d52..dbc69d8fa05f 100644 --- a/drivers/net/ethernet/broadcom/genet/bcmgenet.h +++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.h @@ -720,8 +720,8 @@ GENET_IO_MACRO(rbuf, GENET_RBUF_OFF); /* MDIO routines */ int bcmgenet_mii_init(struct net_device *dev); -int bcmgenet_mii_connect(struct net_device *dev); int bcmgenet_mii_config(struct net_device *dev, bool init); +int bcmgenet_mii_probe(struct net_device *dev); void bcmgenet_mii_exit(struct net_device *dev); void bcmgenet_phy_power_set(struct net_device *dev, bool enable); void bcmgenet_mii_setup(struct net_device *dev); diff --git a/drivers/net/ethernet/broadcom/genet/bcmmii.c b/drivers/net/ethernet/broadcom/genet/bcmmii.c index 17bb8d60a157..dbe18cdf6c1b 100644 --- a/drivers/net/ethernet/broadcom/genet/bcmmii.c +++ b/drivers/net/ethernet/broadcom/genet/bcmmii.c @@ -173,46 +173,6 @@ static void bcmgenet_moca_phy_setup(struct bcmgenet_priv *priv) bcmgenet_fixed_phy_link_update); } -int bcmgenet_mii_connect(struct net_device *dev) -{ - struct bcmgenet_priv *priv = netdev_priv(dev); - struct device_node *dn = priv->pdev->dev.of_node; - struct phy_device *phydev; - u32 phy_flags = 0; - int ret; - - /* Communicate the integrated PHY revision */ - if (priv->internal_phy) - phy_flags = priv->gphy_rev; - - /* Initialize link state variables that bcmgenet_mii_setup() uses */ - priv->old_link = -1; - priv->old_speed = -1; - priv->old_duplex = -1; - priv->old_pause = -1; - - if (dn) { - phydev = of_phy_connect(dev, priv->phy_dn, bcmgenet_mii_setup, - phy_flags, priv->phy_interface); - if (!phydev) { - pr_err("could not attach to PHY\n"); - return -ENODEV; - } - } else { - phydev = dev->phydev; - phydev->dev_flags = phy_flags; - - ret = phy_connect_direct(dev, phydev, bcmgenet_mii_setup, - priv->phy_interface); - if (ret) { - pr_err("could not attach to PHY\n"); - return -ENODEV; - } - } - - return 0; -} - int bcmgenet_mii_config(struct net_device *dev, bool init) { struct bcmgenet_priv *priv = netdev_priv(dev); @@ -221,8 +181,38 @@ int bcmgenet_mii_config(struct net_device *dev, bool init) const char *phy_name = NULL; u32 id_mode_dis = 0; u32 port_ctrl; + int bmcr = -1; + int ret; u32 reg; + /* MAC clocking workaround during reset of umac state machines */ + reg = bcmgenet_umac_readl(priv, UMAC_CMD); + if (reg & CMD_SW_RESET) { + /* An MII PHY must be isolated to prevent TXC contention */ + if (priv->phy_interface == PHY_INTERFACE_MODE_MII) { + ret = phy_read(phydev, MII_BMCR); + if (ret >= 0) { + bmcr = ret; + ret = phy_write(phydev, MII_BMCR, + bmcr | BMCR_ISOLATE); + } + if (ret) { + netdev_err(dev, "failed to isolate PHY\n"); + return ret; + } + } + /* Switch MAC clocking to RGMII generated clock */ + bcmgenet_sys_writel(priv, PORT_MODE_EXT_GPHY, SYS_PORT_CTRL); + /* Ensure 5 clks with Rx disabled + * followed by 5 clks with Reset asserted + */ + udelay(4); + reg &= ~(CMD_SW_RESET | CMD_LCL_LOOP_EN); + bcmgenet_umac_writel(priv, reg, UMAC_CMD); + /* Ensure 5 more clocks before Rx is enabled */ + udelay(2); + } + priv->ext_phy = !priv->internal_phy && (priv->phy_interface != PHY_INTERFACE_MODE_MOCA); @@ -254,6 +244,9 @@ int bcmgenet_mii_config(struct net_device *dev, bool init) phy_set_max_speed(phydev, SPEED_100); bcmgenet_sys_writel(priv, PORT_MODE_EXT_EPHY, SYS_PORT_CTRL); + /* Restore the MII PHY after isolation */ + if (bmcr >= 0) + phy_write(phydev, MII_BMCR, bmcr); break; case PHY_INTERFACE_MODE_REVMII: @@ -306,21 +299,71 @@ int bcmgenet_mii_config(struct net_device *dev, bool init) bcmgenet_ext_writel(priv, reg, EXT_RGMII_OOB_CTRL); } - if (init) { - linkmode_copy(phydev->advertising, phydev->supported); + if (init) + dev_info(kdev, "configuring instance for %s\n", phy_name); - /* The internal PHY has its link interrupts routed to the - * Ethernet MAC ISRs. On GENETv5 there is a hardware issue - * that prevents the signaling of link UP interrupts when - * the link operates at 10Mbps, so fallback to polling for - * those versions of GENET. - */ - if (priv->internal_phy && !GENET_IS_V5(priv)) - phydev->irq = PHY_IGNORE_INTERRUPT; + return 0; +} - dev_info(kdev, "configuring instance for %s\n", phy_name); +int bcmgenet_mii_probe(struct net_device *dev) +{ + struct bcmgenet_priv *priv = netdev_priv(dev); + struct device_node *dn = priv->pdev->dev.of_node; + struct phy_device *phydev; + u32 phy_flags = 0; + int ret; + + /* Communicate the integrated PHY revision */ + if (priv->internal_phy) + phy_flags = priv->gphy_rev; + + /* Initialize link state variables that bcmgenet_mii_setup() uses */ + priv->old_link = -1; + priv->old_speed = -1; + priv->old_duplex = -1; + priv->old_pause = -1; + + if (dn) { + phydev = of_phy_connect(dev, priv->phy_dn, bcmgenet_mii_setup, + phy_flags, priv->phy_interface); + if (!phydev) { + pr_err("could not attach to PHY\n"); + return -ENODEV; + } + } else { + phydev = dev->phydev; + phydev->dev_flags = phy_flags; + + ret = phy_connect_direct(dev, phydev, bcmgenet_mii_setup, + priv->phy_interface); + if (ret) { + pr_err("could not attach to PHY\n"); + return -ENODEV; + } } + /* Configure port multiplexer based on what the probed PHY device since + * reading the 'max-speed' property determines the maximum supported + * PHY speed which is needed for bcmgenet_mii_config() to configure + * things appropriately. + */ + ret = bcmgenet_mii_config(dev, true); + if (ret) { + phy_disconnect(dev->phydev); + return ret; + } + + linkmode_copy(phydev->advertising, phydev->supported); + + /* The internal PHY has its link interrupts routed to the + * Ethernet MAC ISRs. On GENETv5 there is a hardware issue + * that prevents the signaling of link UP interrupts when + * the link operates at 10Mbps, so fallback to polling for + * those versions of GENET. + */ + if (priv->internal_phy && !GENET_IS_V5(priv)) + dev->phydev->irq = PHY_IGNORE_INTERRUPT; + return 0; } |