diff options
Diffstat (limited to 'drivers/scsi/gvp11.c')
| -rw-r--r-- | drivers/scsi/gvp11.c | 141 |
1 files changed, 92 insertions, 49 deletions
diff --git a/drivers/scsi/gvp11.c b/drivers/scsi/gvp11.c index 2203ac281103..0420bfe9bd42 100644 --- a/drivers/scsi/gvp11.c +++ b/drivers/scsi/gvp11.c @@ -1,3 +1,4 @@ +// SPDX-License-Identifier: GPL-2.0-only #include <linux/types.h> #include <linux/init.h> #include <linux/interrupt.h> @@ -8,11 +9,14 @@ #include <linux/module.h> #include <asm/page.h> -#include <asm/pgtable.h> #include <asm/amigaints.h> #include <asm/amigahw.h> -#include "scsi.h" +#include <scsi/scsi.h> +#include <scsi/scsi_cmnd.h> +#include <scsi/scsi_device.h> +#include <scsi/scsi_eh.h> +#include <scsi/scsi_tcq.h> #include "wd33c93.h" #include "gvp11.h" @@ -22,8 +26,12 @@ struct gvp11_hostdata { struct WD33C93_hostdata wh; struct gvp11_scsiregs *regs; + struct device *dev; }; +#define DMA_DIR(d) ((d == DATA_OUT_DIR) ? DMA_TO_DEVICE : DMA_FROM_DEVICE) +#define TO_DMA_MASK(m) (~((unsigned long long)m & 0xffffffff)) + static irqreturn_t gvp11_intr(int irq, void *data) { struct Scsi_Host *instance = data; @@ -42,25 +50,37 @@ static irqreturn_t gvp11_intr(int irq, void *data) static int gvp11_xfer_mask = 0; -void gvp11_setup(char *str, int *ints) -{ - gvp11_xfer_mask = ints[1]; -} - static int dma_setup(struct scsi_cmnd *cmd, int dir_in) { + struct scsi_pointer *scsi_pointer = WD33C93_scsi_pointer(cmd); + unsigned long len = scsi_pointer->this_residual; struct Scsi_Host *instance = cmd->device->host; struct gvp11_hostdata *hdata = shost_priv(instance); struct WD33C93_hostdata *wh = &hdata->wh; struct gvp11_scsiregs *regs = hdata->regs; unsigned short cntr = GVP11_DMAC_INT_ENABLE; - unsigned long addr = virt_to_bus(cmd->SCp.ptr); + dma_addr_t addr; int bank_mask; static int scsi_alloc_out_of_range = 0; + addr = dma_map_single(hdata->dev, scsi_pointer->ptr, + len, DMA_DIR(dir_in)); + if (dma_mapping_error(hdata->dev, addr)) { + dev_warn(hdata->dev, "cannot map SCSI data block %p\n", + scsi_pointer->ptr); + return 1; + } + scsi_pointer->dma_handle = addr; + /* use bounce buffer if the physical address is bad */ if (addr & wh->dma_xfer_mask) { - wh->dma_bounce_len = (cmd->SCp.this_residual + 511) & ~0x1ff; + /* drop useless mapping */ + dma_unmap_single(hdata->dev, scsi_pointer->dma_handle, + scsi_pointer->this_residual, + DMA_DIR(dir_in)); + scsi_pointer->dma_handle = (dma_addr_t) NULL; + + wh->dma_bounce_len = (scsi_pointer->this_residual + 511) & ~0x1ff; if (!scsi_alloc_out_of_range) { wh->dma_bounce_buffer = @@ -82,10 +102,32 @@ static int dma_setup(struct scsi_cmnd *cmd, int dir_in) wh->dma_buffer_pool = BUF_CHIP_ALLOCED; } - /* check if the address of the bounce buffer is OK */ - addr = virt_to_bus(wh->dma_bounce_buffer); + if (!dir_in) { + /* copy to bounce buffer for a write */ + memcpy(wh->dma_bounce_buffer, scsi_pointer->ptr, + scsi_pointer->this_residual); + } + + if (wh->dma_buffer_pool == BUF_SCSI_ALLOCED) { + /* will flush/invalidate cache for us */ + addr = dma_map_single(hdata->dev, + wh->dma_bounce_buffer, + wh->dma_bounce_len, + DMA_DIR(dir_in)); + /* can't map buffer; use PIO */ + if (dma_mapping_error(hdata->dev, addr)) { + dev_warn(hdata->dev, + "cannot map bounce buffer %p\n", + wh->dma_bounce_buffer); + return 1; + } + } if (addr & wh->dma_xfer_mask) { + /* drop useless mapping */ + dma_unmap_single(hdata->dev, scsi_pointer->dma_handle, + scsi_pointer->this_residual, + DMA_DIR(dir_in)); /* fall back to Chip RAM if address out of range */ if (wh->dma_buffer_pool == BUF_SCSI_ALLOCED) { kfree(wh->dma_bounce_buffer); @@ -103,15 +145,19 @@ static int dma_setup(struct scsi_cmnd *cmd, int dir_in) return 1; } - addr = virt_to_bus(wh->dma_bounce_buffer); + if (!dir_in) { + /* copy to bounce buffer for a write */ + memcpy(wh->dma_bounce_buffer, scsi_pointer->ptr, + scsi_pointer->this_residual); + } + /* chip RAM can be mapped to phys. address directly */ + addr = virt_to_phys(wh->dma_bounce_buffer); + /* no need to flush/invalidate cache */ wh->dma_buffer_pool = BUF_CHIP_ALLOCED; } + /* finally, have OK mapping (punted for PIO else) */ + scsi_pointer->dma_handle = addr; - if (!dir_in) { - /* copy to bounce buffer for a write */ - memcpy(wh->dma_bounce_buffer, cmd->SCp.ptr, - cmd->SCp.this_residual); - } } /* setup dma direction */ @@ -124,13 +170,7 @@ static int dma_setup(struct scsi_cmnd *cmd, int dir_in) /* setup DMA *physical* address */ regs->ACR = addr; - if (dir_in) { - /* invalidate any cache */ - cache_clear(addr, cmd->SCp.this_residual); - } else { - /* push any dirty cache */ - cache_push(addr, cmd->SCp.this_residual); - } + /* no more cache flush here - dma_map_single() takes care */ bank_mask = (~wh->dma_xfer_mask >> 18) & 0x01c0; if (bank_mask) @@ -146,6 +186,7 @@ static int dma_setup(struct scsi_cmnd *cmd, int dir_in) static void dma_stop(struct Scsi_Host *instance, struct scsi_cmnd *SCpnt, int status) { + struct scsi_pointer *scsi_pointer = WD33C93_scsi_pointer(SCpnt); struct gvp11_hostdata *hdata = shost_priv(instance); struct WD33C93_hostdata *wh = &hdata->wh; struct gvp11_scsiregs *regs = hdata->regs; @@ -155,11 +196,16 @@ static void dma_stop(struct Scsi_Host *instance, struct scsi_cmnd *SCpnt, /* remove write bit from CONTROL bits */ regs->CNTR = GVP11_DMAC_INT_ENABLE; + if (wh->dma_buffer_pool == BUF_SCSI_ALLOCED) + dma_unmap_single(hdata->dev, scsi_pointer->dma_handle, + scsi_pointer->this_residual, + DMA_DIR(wh->dma_dir)); + /* copy from a bounce buffer, if necessary */ if (status && wh->dma_bounce_buffer) { if (wh->dma_dir && SCpnt) - memcpy(SCpnt->SCp.ptr, wh->dma_bounce_buffer, - SCpnt->SCp.this_residual); + memcpy(scsi_pointer->ptr, wh->dma_bounce_buffer, + scsi_pointer->this_residual); if (wh->dma_buffer_pool == BUF_SCSI_ALLOCED) kfree(wh->dma_bounce_buffer); @@ -171,24 +217,7 @@ static void dma_stop(struct Scsi_Host *instance, struct scsi_cmnd *SCpnt, } } -static int gvp11_bus_reset(struct scsi_cmnd *cmd) -{ - struct Scsi_Host *instance = cmd->device->host; - - /* FIXME perform bus-specific reset */ - - /* FIXME 2: shouldn't we no-op this function (return - FAILED), and fall back to host reset function, - wd33c93_host_reset ? */ - - spin_lock_irq(instance->host_lock); - wd33c93_host_reset(cmd); - spin_unlock_irq(instance->host_lock); - - return SUCCESS; -} - -static struct scsi_host_template gvp11_scsi_template = { +static const struct scsi_host_template gvp11_scsi_template = { .module = THIS_MODULE, .name = "GVP Series II SCSI", .show_info = wd33c93_show_info, @@ -196,13 +225,13 @@ static struct scsi_host_template gvp11_scsi_template = { .proc_name = "GVP11", .queuecommand = wd33c93_queuecommand, .eh_abort_handler = wd33c93_abort, - .eh_bus_reset_handler = gvp11_bus_reset, .eh_host_reset_handler = wd33c93_host_reset, .can_queue = CAN_QUEUE, .this_id = 7, .sg_tablesize = SG_ALL, .cmd_per_lun = CMD_PER_LUN, - .use_clustering = DISABLE_CLUSTERING + .dma_boundary = PAGE_SIZE - 1, + .cmd_size = sizeof(struct scsi_pointer), }; static int check_wd33c93(struct gvp11_scsiregs *regs) @@ -298,6 +327,13 @@ static int gvp11_probe(struct zorro_dev *z, const struct zorro_device_id *ent) default_dma_xfer_mask = ent->driver_data; + if (dma_set_mask_and_coherent(&z->dev, + TO_DMA_MASK(default_dma_xfer_mask))) { + dev_warn(&z->dev, "cannot use DMA mask %llx\n", + TO_DMA_MASK(default_dma_xfer_mask)); + return -ENODEV; + } + /* * Rumors state that some GVP ram boards use the same product * code as the SCSI controllers. Therefore if the board-size @@ -310,7 +346,7 @@ static int gvp11_probe(struct zorro_dev *z, const struct zorro_device_id *ent) if (!request_mem_region(address, 256, "wd33c93")) return -EBUSY; - regs = (struct gvp11_scsiregs *)(ZTWO_VADDR(address)); + regs = ZTWO_VADDR(address); error = check_wd33c93(regs); if (error) @@ -338,9 +374,16 @@ static int gvp11_probe(struct zorro_dev *z, const struct zorro_device_id *ent) wdregs.SCMD = ®s->SCMD; hdata = shost_priv(instance); - if (gvp11_xfer_mask) + if (gvp11_xfer_mask) { hdata->wh.dma_xfer_mask = gvp11_xfer_mask; - else + if (dma_set_mask_and_coherent(&z->dev, + TO_DMA_MASK(gvp11_xfer_mask))) { + dev_warn(&z->dev, "cannot use DMA mask %llx\n", + TO_DMA_MASK(gvp11_xfer_mask)); + error = -ENODEV; + goto fail_check_or_alloc; + } + } else hdata->wh.dma_xfer_mask = default_dma_xfer_mask; hdata->wh.no_sync = 0xff; |