diff options
Diffstat (limited to 'kernel/module/Kconfig')
| -rw-r--r-- | kernel/module/Kconfig | 163 |
1 files changed, 118 insertions, 45 deletions
diff --git a/kernel/module/Kconfig b/kernel/module/Kconfig index 33a2e991f608..2a1beebf1d37 100644 --- a/kernel/module/Kconfig +++ b/kernel/module/Kconfig @@ -2,6 +2,7 @@ menuconfig MODULES bool "Enable loadable module support" modules + select EXECMEM help Kernel modules are small pieces of compiled code which can be inserted in the running kernel, rather than being @@ -159,6 +160,7 @@ config MODULE_UNLOAD_TAINT_TRACKING config MODVERSIONS bool "Module versioning support" + depends on !COMPILE_TEST help Usually, you have to use modules compiled with your kernel. Saying Y here makes it sometimes possible to use modules @@ -167,6 +169,41 @@ config MODVERSIONS make them incompatible with the kernel you are running. If unsure, say N. +choice + prompt "Module versioning implementation" + depends on MODVERSIONS + help + Select the tool used to calculate symbol versions for modules. + + If unsure, select GENKSYMS. + +config GENKSYMS + bool "genksyms (from source code)" + help + Calculate symbol versions from pre-processed source code using + genksyms. + + If unsure, say Y. + +config GENDWARFKSYMS + bool "gendwarfksyms (from debugging information)" + depends on DEBUG_INFO + # Requires full debugging information, split DWARF not supported. + depends on !DEBUG_INFO_REDUCED && !DEBUG_INFO_SPLIT + # Requires ELF object files. + depends on !LTO + # To avoid conflicts with the discarded __gendwarfksyms_ptr symbols on + # X86, requires pahole before commit 47dcb534e253 ("btf_encoder: Stop + # indexing symbols for VARs") or after commit 9810758003ce ("btf_encoder: + # Verify 0 address DWARF variables are in ELF section"). + depends on !X86 || !DEBUG_INFO_BTF || PAHOLE_VERSION < 128 || PAHOLE_VERSION > 129 + help + Calculate symbol versions from DWARF debugging information using + gendwarfksyms. Requires DEBUG_INFO to be enabled. + + If unsure, say N. +endchoice + config ASM_MODVERSIONS bool default HAVE_ASM_MODVERSIONS && MODVERSIONS @@ -175,6 +212,31 @@ config ASM_MODVERSIONS assembly. This can be enabled only when the target architecture supports it. +config EXTENDED_MODVERSIONS + bool "Extended Module Versioning Support" + depends on MODVERSIONS + help + This enables extended MODVERSIONs support, allowing long symbol + names to be versioned. + + The most likely reason you would enable this is to enable Rust + support. If unsure, say N. + +config BASIC_MODVERSIONS + bool "Basic Module Versioning Support" + depends on MODVERSIONS + default y + help + This enables basic MODVERSIONS support, allowing older tools or + kernels to potentially load modules. + + Disabling this may cause older `modprobe` or `kmod` to be unable + to read MODVERSIONS information from built modules. With this + disabled, older kernels may treat this module as unversioned. + + This is enabled by default when MODVERSIONS are enabled. + If unsure, say Y. + config MODULE_SRCVERSION_ALL bool "Source checksum for all modules" help @@ -227,8 +289,9 @@ comment "Do not forget to sign required modules with scripts/sign-file" depends on MODULE_SIG_FORCE && !MODULE_SIG_ALL choice - prompt "Which hash algorithm should modules be signed with?" + prompt "Hash algorithm to sign modules" depends on MODULE_SIG || IMA_APPRAISE_MODSIG + default MODULE_SIG_SHA512 help This determines which sort of hashing algorithm will be used during signature generation. This algorithm _must_ be built into the kernel @@ -237,94 +300,105 @@ choice the signature on that module. config MODULE_SIG_SHA1 - bool "Sign modules with SHA-1" + bool "SHA-1" select CRYPTO_SHA1 -config MODULE_SIG_SHA224 - bool "Sign modules with SHA-224" - select CRYPTO_SHA256 - config MODULE_SIG_SHA256 - bool "Sign modules with SHA-256" + bool "SHA-256" select CRYPTO_SHA256 config MODULE_SIG_SHA384 - bool "Sign modules with SHA-384" + bool "SHA-384" select CRYPTO_SHA512 config MODULE_SIG_SHA512 - bool "Sign modules with SHA-512" + bool "SHA-512" select CRYPTO_SHA512 +config MODULE_SIG_SHA3_256 + bool "SHA3-256" + select CRYPTO_SHA3 + +config MODULE_SIG_SHA3_384 + bool "SHA3-384" + select CRYPTO_SHA3 + +config MODULE_SIG_SHA3_512 + bool "SHA3-512" + select CRYPTO_SHA3 + endchoice config MODULE_SIG_HASH string depends on MODULE_SIG || IMA_APPRAISE_MODSIG default "sha1" if MODULE_SIG_SHA1 - default "sha224" if MODULE_SIG_SHA224 default "sha256" if MODULE_SIG_SHA256 default "sha384" if MODULE_SIG_SHA384 default "sha512" if MODULE_SIG_SHA512 + default "sha3-256" if MODULE_SIG_SHA3_256 + default "sha3-384" if MODULE_SIG_SHA3_384 + default "sha3-512" if MODULE_SIG_SHA3_512 -choice - prompt "Module compression mode" +config MODULE_COMPRESS + bool "Module compression" help - This option allows you to choose the algorithm which will be used to - compress modules when 'make modules_install' is run. (or, you can - choose to not compress modules at all.) - - External modules will also be compressed in the same way during the - installation. - - For modules inside an initrd or initramfs, it's more efficient to - compress the whole initrd or initramfs instead. - + Enable module compression to reduce on-disk size of module binaries. This is fully compatible with signed modules. - Please note that the tool used to load modules needs to support the - corresponding algorithm. module-init-tools MAY support gzip, and kmod - MAY support gzip, xz and zstd. + The tool used to work with modules needs to support the selected + compression type. kmod MAY support gzip, xz and zstd. Other tools + might have a limited selection of the supported types. - Your build system needs to provide the appropriate compression tool - to compress the modules. + Note that for modules inside an initrd or initramfs, it's more + efficient to compress the whole ramdisk instead. - If in doubt, select 'None'. + If unsure, say N. -config MODULE_COMPRESS_NONE - bool "None" +choice + prompt "Module compression type" + depends on MODULE_COMPRESS help - Do not compress modules. The installed modules are suffixed - with .ko. + Choose the supported algorithm for module compression. config MODULE_COMPRESS_GZIP bool "GZIP" help - Compress modules with GZIP. The installed modules are suffixed - with .ko.gz. + Support modules compressed with GZIP. The installed modules are + suffixed with .ko.gz. config MODULE_COMPRESS_XZ bool "XZ" help - Compress modules with XZ. The installed modules are suffixed - with .ko.xz. + Support modules compressed with XZ. The installed modules are + suffixed with .ko.xz. config MODULE_COMPRESS_ZSTD bool "ZSTD" help - Compress modules with ZSTD. The installed modules are suffixed - with .ko.zst. + Support modules compressed with ZSTD. The installed modules are + suffixed with .ko.zst. endchoice +config MODULE_COMPRESS_ALL + bool "Automatically compress all modules" + default y + depends on MODULE_COMPRESS + help + Compress all modules during 'make modules_install'. + + Your build system needs to provide the appropriate compression tool + for the selected compression type. External modules will also be + compressed in the same way during the installation. + config MODULE_DECOMPRESS bool "Support in-kernel module decompression" - depends on MODULE_COMPRESS_GZIP || MODULE_COMPRESS_XZ || MODULE_COMPRESS_ZSTD + depends on MODULE_COMPRESS select ZLIB_INFLATE if MODULE_COMPRESS_GZIP select XZ_DEC if MODULE_COMPRESS_XZ select ZSTD_DECOMPRESS if MODULE_COMPRESS_ZSTD help - Support for decompressing kernel modules by the kernel itself instead of relying on userspace to perform this task. Useful when load pinning security policy is enabled. @@ -336,7 +410,7 @@ config MODULE_ALLOW_MISSING_NAMESPACE_IMPORTS help Symbols exported with EXPORT_SYMBOL_NS*() are considered exported in a namespace. A module that makes use of a symbol exported with such a - namespace is required to import the namespace via MODULE_IMPORT_NS(). + namespace is required to import the namespace via MODULE_IMPORT_NS(""). There is no technical reason to enforce correct namespace imports, but it creates consistency between symbols defining namespaces and users importing namespaces they make use of. This option relaxes this @@ -357,8 +431,7 @@ config MODPROBE_PATH userspace can still load modules explicitly). config TRIM_UNUSED_KSYMS - bool "Trim unused exported kernel symbols" if EXPERT - depends on !COMPILE_TEST + bool "Trim unused exported kernel symbols" help The kernel and some modules make many symbols available for other modules to use via EXPORT_SYMBOL() and variants. Depending @@ -383,10 +456,10 @@ config UNUSED_KSYMS_WHITELIST exported at all times, even in absence of in-tree users. The value to set here is the path to a text file containing the list of symbols, one per line. The path can be absolute, or relative to the kernel - source tree. + source or obj tree. config MODULES_TREE_LOOKUP def_bool y - depends on PERF_EVENTS || TRACING || CFI_CLANG + depends on PERF_EVENTS || TRACING || CFI endif # MODULES |