diff options
Diffstat (limited to 'drivers/phy/marvell')
| -rw-r--r-- | drivers/phy/marvell/Kconfig | 4 | ||||
| -rw-r--r-- | drivers/phy/marvell/phy-mvebu-a3700-comphy.c | 9 | ||||
| -rw-r--r-- | drivers/phy/marvell/phy-mvebu-cp110-comphy.c | 6 | ||||
| -rw-r--r-- | drivers/phy/marvell/phy-mvebu-cp110-utmi.c | 16 |
4 files changed, 26 insertions, 9 deletions
diff --git a/drivers/phy/marvell/Kconfig b/drivers/phy/marvell/Kconfig index bdb87c976243..bccd72dccb77 100644 --- a/drivers/phy/marvell/Kconfig +++ b/drivers/phy/marvell/Kconfig @@ -29,7 +29,7 @@ config PHY_MVEBU_A3700_COMPHY depends on ARCH_MVEBU || COMPILE_TEST depends on OF depends on HAVE_ARM_SMCCC - default y + default ARCH_MVEBU select GENERIC_PHY help This driver allows to control the comphy, a hardware block providing @@ -40,7 +40,7 @@ config PHY_MVEBU_A3700_UTMI tristate "Marvell A3700 UTMI driver" depends on ARCH_MVEBU || COMPILE_TEST depends on OF - default y + default ARCH_MVEBU select GENERIC_PHY help Enable this to support Marvell A3700 UTMI PHY driver. diff --git a/drivers/phy/marvell/phy-mvebu-a3700-comphy.c b/drivers/phy/marvell/phy-mvebu-a3700-comphy.c index 41162d7228c9..1d1db1737422 100644 --- a/drivers/phy/marvell/phy-mvebu-a3700-comphy.c +++ b/drivers/phy/marvell/phy-mvebu-a3700-comphy.c @@ -603,7 +603,7 @@ static void comphy_gbe_phy_init(struct mvebu_a3700_comphy_lane *lane, u16 val; fix_idx = 0; - for (addr = 0; addr < 512; addr++) { + for (addr = 0; addr < ARRAY_SIZE(gbe_phy_init); addr++) { /* * All PHY register values are defined in full for 3.125Gbps * SERDES speed. The values required for 1.25 Gbps are almost @@ -611,11 +611,12 @@ static void comphy_gbe_phy_init(struct mvebu_a3700_comphy_lane *lane, * comparison to 3.125 Gbps values. These register values are * stored in "gbe_phy_init_fix" array. */ - if (!is_1gbps && gbe_phy_init_fix[fix_idx].addr == addr) { + if (!is_1gbps && + fix_idx < ARRAY_SIZE(gbe_phy_init_fix) && + gbe_phy_init_fix[fix_idx].addr == addr) { /* Use new value */ val = gbe_phy_init_fix[fix_idx].value; - if (fix_idx < ARRAY_SIZE(gbe_phy_init_fix)) - fix_idx++; + fix_idx++; } else { val = gbe_phy_init[addr]; } diff --git a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c index da5e8f405749..71f9c14fb50d 100644 --- a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c +++ b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c @@ -244,8 +244,8 @@ static const struct mvebu_comphy_conf mvebu_comphy_cp110_modes[] = { GEN_CONF(4, 1, PHY_MODE_USB_HOST_SS, COMPHY_FW_MODE_USB3H), GEN_CONF(4, 1, PHY_MODE_PCIE, COMPHY_FW_MODE_PCIE), ETH_CONF(4, 1, PHY_INTERFACE_MODE_SGMII, 0x1, COMPHY_FW_MODE_SGMII), - ETH_CONF(4, 1, PHY_INTERFACE_MODE_2500BASEX, -1, COMPHY_FW_MODE_2500BASEX), - ETH_CONF(4, 1, PHY_INTERFACE_MODE_5GBASER, -1, COMPHY_FW_MODE_XFI), + ETH_CONF(4, 1, PHY_INTERFACE_MODE_2500BASEX, 0x1, COMPHY_FW_MODE_2500BASEX), + ETH_CONF(4, 1, PHY_INTERFACE_MODE_5GBASER, 0x1, COMPHY_FW_MODE_XFI), ETH_CONF(4, 1, PHY_INTERFACE_MODE_10GBASER, -1, COMPHY_FW_MODE_XFI), /* lane 5 */ ETH_CONF(5, 1, PHY_INTERFACE_MODE_RXAUI, 0x2, COMPHY_FW_MODE_RXAUI), @@ -422,7 +422,7 @@ static int mvebu_comphy_ethernet_init_reset(struct mvebu_comphy_lane *lane) /* wait until clocks are ready */ mdelay(1); - /* exlicitly disable 40B, the bits isn't clear on reset */ + /* explicitly disable 40B, the bits isn't clear on reset */ regmap_read(priv->regmap, MVEBU_COMPHY_CONF6(lane->id), &val); val &= ~MVEBU_COMPHY_CONF6_40B; regmap_write(priv->regmap, MVEBU_COMPHY_CONF6(lane->id), val); diff --git a/drivers/phy/marvell/phy-mvebu-cp110-utmi.c b/drivers/phy/marvell/phy-mvebu-cp110-utmi.c index 4922a5f3327d..59903f86b13f 100644 --- a/drivers/phy/marvell/phy-mvebu-cp110-utmi.c +++ b/drivers/phy/marvell/phy-mvebu-cp110-utmi.c @@ -62,6 +62,8 @@ #define SQ_AMP_CAL_MASK GENMASK(2, 0) #define SQ_AMP_CAL_VAL 1 #define SQ_AMP_CAL_EN BIT(3) +#define UTMI_DIG_CTRL1_REG 0x20 +#define SWAP_DPDM BIT(15) #define UTMI_CTRL_STATUS0_REG 0x24 #define SUSPENDM BIT(22) #define TEST_SEL BIT(25) @@ -99,11 +101,13 @@ struct mvebu_cp110_utmi { * @priv: PHY driver data * @id: PHY port ID * @dr_mode: PHY connection: USB_DR_MODE_HOST or USB_DR_MODE_PERIPHERAL + * @swap_dx: whether to swap d+/d- signals */ struct mvebu_cp110_utmi_port { struct mvebu_cp110_utmi *priv; u32 id; enum usb_dr_mode dr_mode; + bool swap_dx; }; static void mvebu_cp110_utmi_port_setup(struct mvebu_cp110_utmi_port *port) @@ -159,6 +163,13 @@ static void mvebu_cp110_utmi_port_setup(struct mvebu_cp110_utmi_port *port) reg &= ~(VDAT_MASK | VSRC_MASK); reg |= (VDAT_VAL << VDAT_OFFSET) | (VSRC_VAL << VSRC_OFFSET); writel(reg, PORT_REGS(port) + UTMI_CHGDTC_CTRL_REG); + + /* Swap D+/D- */ + reg = readl(PORT_REGS(port) + UTMI_DIG_CTRL1_REG); + reg &= ~(SWAP_DPDM); + if (port->swap_dx) + reg |= SWAP_DPDM; + writel(reg, PORT_REGS(port) + UTMI_DIG_CTRL1_REG); } static int mvebu_cp110_utmi_phy_power_off(struct phy *phy) @@ -286,6 +297,7 @@ static int mvebu_cp110_utmi_phy_probe(struct platform_device *pdev) struct phy_provider *provider; struct device_node *child; u32 usb_devices = 0; + u32 swap_dx = 0; utmi = devm_kzalloc(dev, sizeof(*utmi), GFP_KERNEL); if (!utmi) @@ -345,6 +357,10 @@ static int mvebu_cp110_utmi_phy_probe(struct platform_device *pdev) } } + of_property_for_each_u32(dev->of_node, "swap-dx-lanes", swap_dx) + if (swap_dx == port_id) + port->swap_dx = 1; + /* Retrieve PHY capabilities */ utmi->ops = &mvebu_cp110_utmi_phy_ops; |